Question about 1995 Ford Aspire

1 Answer

1995 aspire wont start

Wont start unless u push it off then u have to pat gas pedal until u get to steady speed

Posted by on

  • 1 more comment 
  • kelleylarry Jul 01, 2008

    1995 ford aspire is getting gas when u are cranking it u can smell it can take fuel line off and gas squirts out when cranking how do u check fuel pump and where is fuel regulator located

  • kelleylarry Jul 04, 2008

    disconnected battery for 5 mins. and cleaned spark plugs still wont start

  • petrasman_1 Aug 09, 2008

    car is turning over getting fuel but not firing

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 126 Answers

With little infomation i would say that you need to replace the fuel pump or you shoul start with the fuel filter then if that doesnt help try the fuel pump replacement . see when you push it motor is turning faster than starter motor meaning need less fuel to start it so when you push it motor is winding faster than with starter motor good luck with this project

Posted on Jul 01, 2008

  • james cox
    james cox Jul 02, 2008

    well the motor is getting fuel so that isnt the problem so try disconnecting the battery for 5 min then start motor ill have to look into may manuals to see standard fuel pressure regulator test and location ok i'll do the best i can to find out the issue with this thing ok take out spark plugs and clean then to start with because the excess fuel is flooding it out for shure now ill be looking into problem

  • james cox
    james cox Jul 04, 2008

    ive been reading up on tour issue and there is a test that you can do to see what sensor is not working you need to have a real good knowledge of how to use a jumper wire and you have to ground out the sti circuit and watch your check engine light count the flashes it will be a 2 digit code that i need to determine problem so say 2 pulses of flashes represents code 02 which means camshaft sensor failure 4 flashes means crankshaft position sensor . so at that ill leave that up to you if ur willing to use jumper could cause damage if you ground the wrong pin so ill want to know if you know the fuel pressure that your pump is making it should be atleast 40 psi thats alot of pressure if you dont have the correct pressure it wont run for ya lets find out what the pressure is before grounding out any wires for codes do a fuel pressure test the gauge kit is 30.00 if you dont have one or if yoe have a neighbour that does ill wait to hear from you re actual fuel pressure in psi this will let me in on weather its a crank sensor or the fuel pump ok try

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 Buick LeSabre 3.8 Liter Wont start unless I push down on gas pedal like it wants more gas, Why? Runs OK when running


Possibly a bad or dirty Idle Air Control motor. The engine computer controls the operation of this motor to control idle speed. A pintle on the motor extends and retracts, according to signal from the computer. The pintle controls an air passage below it to give or take away air during idle -when the throttle shaft is closed, no air will get into the engine through the throttle body except through the idle air passage . The IAC motor or valve is on the throttle body, with a 4 wire connector. Take it off and look for carbon or coking deposits around the valve's pintle, and in the air passage beneath it. With the idle valve off, plug the connector back on it, then watch the pintle as the key is turned to on. If there is no movement whatsoever, the motor is probably bad.

I have also heard that a bad coolant temperature sensor can cause such a hard start. If the computer does not know the engine is cold, it won't put enough gas into the cylinders for easy starts. The engine needs more gas to start and run when cold.

Sep 13, 2014 | 1995 Buick LeSabre

1 Answer

Car wont keep running unless foot is on gas pedal


Here's a video Andres Nazario suggested as a solution to your problem from YouTube:


Fixing A Car That Cranks But Doesn't Start Up

Apr 30, 2013 | Honda Accord Cars & Trucks

1 Answer

Engine wont start, unless I push the gas pedal and keep my foot on it.?


Could be a dirty throttle body, or a stuck idle air control valve.
Is the check engine light staying on now ?

Apr 23, 2013 | Toyota Highlander Cars & Trucks

1 Answer

1995 pontiac grand am starts doesnt stay running wen pedal pushed


sounds like it is not getting much fuel. when you step on gas pedal to call for more fuel, its not there so it will quit. check fuel filter to be sure it is ok! have a good day!!

Jul 18, 2010 | 1995 Pontiac Grand Am

1 Answer

Idle problem


check the airflow meter it may be stuck and make sure the electrical connection to it is not loose and also check the hose leading to it are not loose or cracked they tend to crack at the bottom where you cannot see it unless you remove it and check

May 21, 2009 | 1999 BMW 318 ti

1 Answer

Need to know how to bleed clutch of 1995 honda passport. Do- it - yourself instructions. The clutch pedal is pushed down with no resistance at all. Once pushed down i can start the car but the clutch will...


Fill the clutch reservoir with new brake fluid and kneel down beside the car, reach in with your hand and pump the clutch pedal up and down until it starts to return on it's own. Check the reservoir level, hop in the car and pump the pedal about twenty times with you foot, the clutch will self bleed and you'll be able to shift. If there is a leak somewhere, this problem will reoccur until the cause of the leak is fixed.

Mar 30, 2009 | 1995 Honda Passport

1 Answer

Taurus wont start


keep your foot on the gas until the car warms up

Jan 29, 2009 | 1993 Ford Taurus

1 Answer

1995 Toyota Camary Erratic idle/accelaration from engine


The timing belt is one tooth off. Pull the covers back off, set the engine to TDC and recheck your marks, and make sure that the tension is correct.

Jan 12, 2009 | 1995 Toyota Camry

Not finding what you are looking for?
1995 Ford Aspire Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...