Question about 1992 Chevrolet S-10

1 Answer

Fuel pump 1992 chevy S-10

I need to repair / replace a fuel pump on my chevy S-10 Need help and or instructions

Posted by on

  • Hoger Sep 29, 2008

    I need to repair / replace a fuel pump on my chevy S-10 year 99. Need help and or instructions

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

You have to drop the fuel tank to get to the fuel pump. not a difficult job but it is time consuming and an extra pair of hands will be very helpful. First thing to do is get all the gas out you can, asses how you are going to remove the tank and then start. Don't forget to be very careful with the fuel lines, disconnect them and reconnect them carefully.

Posted on Oct 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 chevy suburban 7.4 4WD replaced fuel pump, fuel filter, and fuel pressure regulator not getting gas to one side of fuel injectors


hold on with replacin parts-----did u do a scan--------also the rail cud be pluged or you probly need a pressure chec on fuel line

Apr 09, 2012 | 1992 Chevrolet C/K 2500

1 Answer

I have a fuel problem with my 1992 chevy s-10 I have fuel at the throttle body but its not getting into the bowl, can spray fuel into the bowl and the truck will run


i am having to do the same thing ! i replaced the filter and regulater on throttle body and pump ! and still not fixed !! did you find out what was wroung with yours ? coopermike71@yahoo.com

thanks mike.

Jan 01, 2011 | 1992 Chevrolet S-10

1 Answer

Where is the fuel pump fuse on a chevy s10 blazer?


Its in side the gas tank On the top of it You have to drop the tank to replace it Make sure it;s the pump first because its not easy to do And you probley will need other parts in addition to the pump to repair this TANK STRAPS FUEL LINES AND THE TANK IT SELF MAY NEED REPAIRS DO TO HOLES RUSTED IN THE TOP OF IT

Oct 29, 2010 | 1992 Chevrolet S-10 Blazer

1 Answer

Have a 1992 chevy S10 with a 4.3L it cranks over but it don't start. i checked pick up coil it's good. i checked ing. coil . it checks good. and icontrol modgual with a ne have a 1992 chevy S1with a 4.3L...


Try this. Remove the breather, Carefully tip 1/2 a cup of gas in the intake. Replace the breather quickly. Fire it up. My quess is that it will run fine. The fuel pump is the prob! You will need to lower the fuel tank to change the fuel pump.

Mar 26, 2010 | 1992 Chevrolet S-10

1 Answer

Chevy s 10 pickup will not crack , possible


first off - there can be other factors - long before the fuel pump - - how about the filter? if u spray fuel into the intake does it run for a few seconds or at least 'fire off' showing it wants to run but needs fuel? Also check ur spark before u go that far - as to the tank -much easier to remove the tank - EMPTY -- get a friend -as it is gas and once it goes - it will kill u quick - - and put a jack under the tank - remove the bolts - lower it just a little bit - then remove the lines - there are special lines so check with the dealer - free advice they are good for too - - also take down the VIN number and check for a recall - might be a free repair -

Dec 26, 2009 | 1992 Chevrolet S-10

1 Answer

My husband said his 2000 Chevy S10 would sputter and stall continuously. Just happened yesterday. Took it to Pep Boys. They diagnosed it as a bad fuel injector. He has a 4 cyclinder manual transmission....


I had the same problem with my 1992 S10 Pick Up. Found the problem to be with the fuel pump. Replaced the fuel pump and it ran like a charm.
The fuel pump is located in the gas tank.

Sep 15, 2009 | 1992 Chevrolet S-10

1 Answer

Chevy s-10 repair problems


You must be careful if you are going to cut and use a union with flaring tool to repair that you make sure the repair when tightened is straight or it will leak and if it leaks well you know the rest, you must aquire a heavy tubing cutter a union after measuring the tube and a flaring tool this may be more expensive than just replacing the kinked hose these systems are under high pressure between 30-40 psi so a simple rubber hose with a hose clamp will not hold the pressure don't waste your time with that. Jack up the vehicle support with jack stands and follow the steel hose to see where it conects to the steel fuel hose that goes along the floor of the vehicle hopefully there is a place to unscrew stock unoin and replace the line or remove to repaire with said flaring tool and coupler.

PS follow the instructions of flaring to the letter or leak may result, as always wear safety glasses gasoline in the eyes really sucks.

Jul 20, 2009 | 1992 Chevrolet S-10

1 Answer

Fuel Pump Bad.


remove fuel tank from vehicle and remove lock ring from tank swap fuel pump out..make sure sealing ring is installed properly

May 09, 2009 | 1992 Chevrolet Lumina

1 Answer

''fuel pump runs when truck is off could it be anything else other than fuel pump 92 chevy s 10


this is caused by the fuel pump relay being burned in the closed position, replace the fuel pump relay.

Mar 27, 2009 | 1992 Chevrolet S-10

Not finding what you are looking for?
1992 Chevrolet S-10 Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...