Question about 1999 Nissan Sentra

1 Answer

Transmission car has a hard time changing gears uphills or accelerating

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,605 Answers

What knid of transmssion?? auto or manual???
check the fluide.

Posted on Oct 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Losing speed when going up hills


catalytic converter. get it tested. Might be the fuel filter clogging up.

Apr 06, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

Loses power in high gears


run fault codes and look for accelerator position sensor fault . Check for MAP/MAF sensors as well

Feb 18, 2014 | Cars & Trucks

1 Answer

2001 Toyota Camry. Loud rumble on start/warm-up, slightly decreasing after some drive time. Engine seems strained (with louder rumble and vibration) mostly in lower gears, accelerating and/or uphill. No...


Have you checked your oil and fluid levels in the engine and transmisson.
if it's a manual could the clutch be worn out causing the high rpm and thrust bearing noise in the clutch.

Jun 13, 2012 | Cars & Trucks

1 Answer

1999 v6 firebird misfires on #6 cyl when under load, plug was fuel fouled last time I had it replaced, but keeps missing only when under load. no other problems.


if you've changed the spark plug and no difference, then it's time to swap the coil with another cyl. coil and see if the miss goes to the other cylinder, if it does'nt follow to other cylinder, then I would replace that injector !

Mar 18, 2012 | 1999 Pontiac Firebird

1 Answer

The ranger has a common problem with lunging or jerking when in 4th or 5th gear going uphill or accelerating. I have replaced all firing components, fuel components, timing belt, rear end is fine. Does...


I am assuming your transmission is a 5speed manual. What is the tachometer reading when you experience this jerking in 5th gear? It sounds like the engine is being lugged. If you are trying to pull a hill or accelerate in 5th gear at less than 40 or 45mph, you need to downshift to a lower gear.

Feb 03, 2011 | Ford Ranger Cars & Trucks

1 Answer

2002 Montero Sport 4X2 jerks during and after shifting into 3rd or fourth gear. Particularly bad going uphill. Not so bad during hard acceleration. Have changed fuel filter, plugs, etc. Even changed center...


Check the 'U' joints in the drive line. Check the engine/transmission mounts for damage or looseness. The real enigma is trying to determine if this is an engine or a chassis problem. If the check engine light is on, doing a scan of the computer should show engine problems. If no light, concentrate on anything in the chassis for periodic binding. Good luck!

Mar 15, 2010 | 2002 Mitsubishi Montero Sport

1 Answer

Bucking upon acceleration uphill, not any other time. Hard buck not just sputtering


Depending on miles, this could be a timing problem. Also you may want to change plugs, wires, fuel filter and clean fuel injectors.

Jul 17, 2009 | 2001 Chevrolet Astro

2 Answers

Poor acceleration


when was the fuel filter changed last how many miles on truck i found plugged filters will hold the vehical back on hard acceleratoin may be worth checking

Apr 29, 2009 | 1995 GMC Suburban

1 Answer

Hesitation during acceleration


could be the type of plug you are using.I was told only to use ngk plugs.I recently put bosch plugs in my mazda 3 and the check engine light came on and it started missfiring.

Apr 26, 2009 | 2004 Mazda 3

Not finding what you are looking for?
1999 Nissan Sentra Logo

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...