Question about 2001 Ford Mustang

1 Answer

2001 mustang gt brake lights not working

All of my brake lights have gone out at the same time

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Most likely a fuse

Posted on Jun 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 ford mustang shifter stuck in park


Try taking off the boot off the shifter and see with a light to see if something is stopping it from moving,if not that I would suggest putting car on ramps and see if the linkage is stuck underneath where the tranny is always start with simple as it might be a cheap repair best of luck

Aug 26, 2014 | 2001 Ford Mustang GT

1 Answer

97 ford e super duty v10 rv turn signal & stop lights quit


It could be one of the two brake switches. The turn signals will be routed through them and the cruise module uses them, so if it detects something amiss, it's likely that it wont operate.

Nov 11, 2013 | 2001 Ford Mustang GT

1 Answer

95 mustange gt brake light dont work check #9 fuses change all bulbs replaced switch on brake pedal hazards lights works ,parking or running lights works,turning signal lights works,what other places i...


I assume the fuse has power if the hazards work.
The third brake light skips the turn signal switch, the regular brake light circuit goes thru the turn signal switch.
Do you have power going into the turn signal switch on the red lite green wire from the brake switch ?

Feb 17, 2013 | 1995 Ford Mustang

1 Answer

1995 ford mustange gt brakes lightsts don't work


All the grounds are good?How do you know the switch is good?Did you test it with a ohm meter?

Feb 17, 2013 | 1995 Ford Mustang

1 Answer

2004 GT Mustang, Inner Pad Gone (to metal rivet ) Outer Pad like new


This most of the time happens when the brake caliper is sticking,but find out if it is the brake hose to the caliper that is causing the problem,or if the caliper itself is the cause.

May 06, 2010 | 2004 Ford Mustang

1 Answer

Hello i have a 1995 ford mustang gt and i need a diagram for the electricle cluster that sits in the dash board that controlls the hd lights, tail lights, break lights etc thank you


im not sure what your talking about, it sounds like you want the wiring for the cluster, but this doesnt control brake,tail or headlights, the brake lights operate through the brake light switch and go through the signal light switch to power those up. the headlights and tail lights work through the head light switch, what system do you need, or what doesnt work.

Apr 06, 2010 | 1995 Ford Mustang

2 Answers

Brake lights don't work


Check the switch on the brake pedal. They go bad from time to time and are usually cheap to replace.

May 28, 2009 | 2004 Ford Mustang

1 Answer

1994 mustang brake lights do not work


9 times out of 10 its the brake switch located under the drivers side dash behind the brake peddle arm. However check the brake light fuses first.

Mar 18, 2009 | 1994 Ford Mustang

1 Answer

2001 Mustang GT rear brake job


yep this is a two man job, onece you get air in the lines is better to do all four, my has abs and i was able to do it, but next time don't take anylines lose just turn the piston clockwise and you should be able to push it in.

Sep 11, 2008 | 2001 Ford Mustang

Not finding what you are looking for?
2001 Ford Mustang Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...