1997 toyota camry passenger side front power window problem
I have 1997 toyota camry. front passenger side goes up but its not going down. if i give the power direct from battery then it goes up and down in both directions. what is the problem in it?????? how i can fix it--------
An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: 1997 toyota camry passenger side front power window...
I would lean towards it being a bad switch on that side. To test this theory go grab any DPDT(double pole-double throw) switch and hook it up to that side, if it works than it's just a bad switch, go grab a new one from a junkyard or dealer.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The master switch is the one located on the drivers side. If this switch has a malfunction it can rob power from the passenger side causing the problem you have. If the regulator/motor are in working order and you know the passenger switch is ok then that could be the problem. Another couple of possible problems could be a broken wire in the harness traveling from the car to the door (inside the rubber protective boot or a weak window motor (1990 is pretty old for a motor of that type.
more than likely one of the switches are bad (down side of switch works but up side of switch dont) being as the switches are wired together if one goes bad other one won't work either take the switch out one of back doors should be same as front passenger door put rear switch in front passenger door if works then u know front door switch is bad if it doesn't then drivers door switch is bad u replaced window regulator Did that come with motor too??? if not check to see if motor is good there is two wires going to motor cut isolation back on wires and using some jumper wires attach one wire to positive terminal of a 12 volt battery attach other wire to negative terminal of battery window should move up or down reverse connections and window should move other way
Reverse your test light connector, connect it to power so you can check for ground at window motor, flip switch up or down should have ground at both wire's while flipping switch to up or down, more then likely your not going to have ground at the up position, do same test at harness before passenger door switch if no ground master switch bad.
I would suspect the switched first. One window might show as a wiring fault but two, no usually..
remove the switch assembly from the door armrest and use a test probe to check the centre terminals of the front and rear window switches.
The centre terminals transpose the power and earth supplies when the switch is pushed up and down. If you lose either the power or earth connections during the switching tests, replace the switch assembly.
No.The drivers master power switch is probably bad.YOu will have to perform a test on the three other switches on the master. Check for power and ground when you push each putton.If the master switch fails the test you need a new master switch.
the power windows of most toyotas only works if the master switch located on the drivers side is good. remove the master switch check for burned traces on the printed circuit board. solder a jumper wire across the burned part and it should work
No won't be fuse. My guess is there is something faulty with the main controller. You could probably verify this by trying the switch on right rear passenger door. If it works there then the problem is at the main controller in the driver door. Could be a loose wire or the switch itself is broken.
Can you hear the moter or do interior lights dim when pressing button? If so remove door panel and lubricate tracks and rolers using lithium grease lube only the tracks that do not come in contact with glass.
Check the connections at the switch and at the moter with a volt meter if there is power than time for a new moter. no power than check at drivers side switch. If no power there and fuse is ok you have a open in wires and will have to trace entire circut