The side rear view mirror is broken - 1992 Chevrolet S-10 Blazer

Hi Tom,here's a video on your mirror replacement. How To Install Replace Broken Side Rear View Mirror Cadillac CTS 03 07...

BMW 540i Side View Mirror Removal 525i 530i - YouTube

? 8:16
https://www.youtube.com/watch?v=Bmm9M28dqv4
Mar 10, 2014 - Uploaded by bimmermerchant
BMW 540i Side View Mirror Removal 525i 530i. bimmermerchant ..... A truck recently side swiped my ...

How to Repair and Replace a Broken Side Mirror Glass ...

? 2:31
https://www.youtube.com/watch?v=uUcpzHx2ZR0
Jan 6, 2013 - Uploaded by AutoandTruckMirrors
This How To video offers you easy step by step instructions on how to remove and replace a broken side ...

How To: Replace The Side Mirror on a Dodge Caravan ...

? 13:58
https://www.youtube.com/watch?v=ldjeQsnAJ9M
Jan 26, 2014 - Uploaded by Daniel Scheer
This video is a step by step instruction for the removal andreplacement of the side mirror on a 1996-2007 ...

VW Golf MK4 - how to remove/replace door wing mirror video

? 3:00
https://www.youtube.com/watch?v=saIEH-CxRkY
Aug 10, 2014 - Uploaded by DIY Mechanics
VW Golf MK4 - how to remove/replace door wing mirror video ... How To install Replace Side rear View ...

This is what you do take the door skin off of the inside of the door and at the top corner there will be i think three nuts and than your going to need door clips after your done in order to put the door panal back on

is it just the glass that broke?

Exterior Mirror Glass Removal

1. Position the inner edge or the exterior rear view mirror glass to its maximum travel.

1. WARNING: Place a shop towel between the exterior rear view mirror glass and the hand to avoid personal injury in the instance of glass breakage.
   Grasp the outboard edge of the exterior rear view mirror glass and pull outward.

1. Remove the exterior rear view mirror glass.
   • If equipped, disconnect the heated rear view mirror glass electrical connectors.

Installation

1. If equipped, connect the heated rear view mirror glass electrical connectors.

1. NOTE: An audible click will be heard during installation.
   Press firmly in the center of the exterior rear view mirror glass until it snaps onto the exterior rear view mirror motor.

SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal

1. Remove the front door trim panel. For additional information, refer to Section 501-05 .

1. Remove the upper speaker.
   1. Disconnect the electrical connector.
   1. Remove the bolts.
   1. Remove the speaker.

1. Position the watershield aside.

1. Remove the exterior rear view mirror access panel.

1. Disconnect the exterior rear view mirror electrical connectors.
   • Release the wiring harness locator.

1. Remove the exterior rear view mirror.
   • Remove the bolts.
   • Feed the wiring harness through the door opening.

the only way to fix if the mirror is damaged is to replace mirror assembly. remove the trim piece on the backside of the mirror and remove the 3 10mm nuts holding the mirror on.

There are two tiny motors in each mirror. one for up/down. One for side to side. They have jack screws (plastic) that fit into the motors.

You can manually put your hands on either side of the mirror and force adjust it. If you hear a ratcheting sound, the jack screws are OK. Then repeat with hands on top and bottom.

If you hear ratcheting and mirror stays where you stop it, that means one of the motors is bad. The motor assembly is available as a separate part.

-------------------------------------------------------------------------------------
Mirror Motor—Crown Victoria, Grand Marquis
Removal and Installation

1. Disconnect battery ground cable. Refer to Section 14-01 .
   

1. Remove outside Rear View Mirror Glass as outlined.
   

1. Remove Outside Rear View Mirror as outlined.
   

1. Remove two screws from outside rear view mirror motor.
   

1. Remove outside rear view mirror housing from outside rear view mirror base.
   

1. Disconnect connector and remove outside rear view mirror motor from mirror housing.
   

1. To install, reverse Removal procedure.
   

Might be cheaper to buy used irror at car-part.com. Look for * to find page with cheapest part. Or, EBay. Good luck

You will need to remove the triangular panel on the inside of the door on the opposite side of the broken mirror. Once you remove the panel, you will see the retaining bolts holding the mirror in place. Once you remove the bolts, the mirror can then be pulled out from the outside. Reverse the procedure to reinstall the new mirror.

there should be a plastic cover on the inside of the car where the mirror is take this off and there will be a connector block unplug this and there should be screws undo them and the whole thing should come off themn and you should be able to seperate them then.