Question about 2000 Chevrolet S-10

1 Answer

2000 s-10 wont turn over to start but batt charge is good.

Recently had a tranny sensor replaced from a shop. Picked the vehicle up from the shop drove about 2 miles to my house. Today I went to drive the vehicle and went 1.3 miles stopped to get gas filled up hopped back in truck and nothing the vehicle will not turn over. Had a friend say it may be a short somewhere? any ideas

Posted by on

  • bulova68 Jul 08, 2008

    cant find were to hook up neg. battery cable

  • slb5956 Aug 02, 2008

    the alternator on my 97 s10 not charging, had the alternator checked its good batt charge is good but anternator wont charge can anyone help me out?

×

Ad

1 Answer

What exactly happens when you hit the key

Posted on Jul 03, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It cranks but wont start. replaced starter, coil, spark wires and plugs. crankshaft position sensor, distributor and cap. still wont turn over. fuel pump turns on fine, and there is pressure at the...


the ignition module probly bad-replaces points and located in distributer area--batt must also read 12.6v and alternator must be healthy--fuses may not all be good--take a light tester to um--make sure inline safety fuse on the batt line is workn

Oct 10, 2013 | 1991 Jeep Wrangler

2 Answers

Car died. Cranks, but wont start. Codes P0328, P0340


Yes, if the camshaft position sensor has failed, your vehicle won't start.

Jun 11, 2013 | 2004 Nissan XTerra

1 Answer

Ford econoline wont start


https://s4.postimg.org/898usmifh/starter.jpg

Click on the link. I tried to get all on the same page, hope you can read it? It's for the starter motor circuit. You need to test when problem is ongoing.
Make sure battery has a full charge and connections all good. I don't know liter size of engine, whether it is diesel or gasoline? The diagram is for 5.8L gas engine.
Any testing at starter motor make sure tranny is in park or neutral and the parking brake is set. Two voltage circuits at starter motor, one comes from the battery, hot all the time. The other circuit goes hot when starter relay is energized. Check the fuses for voltage in the diagram. The starter motor usually grounds through engine block.
Unless you can do some testing, I don't know how to help?

Jun 28, 2017 | Cars & Trucks

1 Answer

Battery was weak so i put a charge on it. car slow to crank over but started but will not keep running.


+charge batt to full, start the car, then turn on your headlights and heater blower. if the car dies and wont start back/dead batt, check/replace alternator

Dec 16, 2010 | 2004 Toyota Avalon

1 Answer

2000 caravan not charging. R&R alt, and batt.


Have the computer checked. On your vehicle the computer is what tells the alternator to turn on to start charging. If the alterantaor is not getting that signal from the computer you will have to replace the computer.

Dec 17, 2009 | 2000 Dodge Caravan

1 Answer

Speedometer wont work


Most cars have one main vehicle speed sensor (vss). The VSS in front wheel drive cars is mounted in the transmission. A gear in the tranny turns a small gear on the VSS. If a tooth of the gear on the VSS is damaged, you can get that erratic speedometer jumping like you're experiencing. A malfunctioning VSS can cause problems with shifting and with the activation of the anti-lock braking system and cruise control. Have a Transmission shop inspect your VSS and replace if necessary, if your handy with tools. you can buy the VSS and replace you self. The speed sensors on the Galant are called pulse generators and need to be replace as a set. Located outside of the transmission right on top.
Good luck!

Dec 09, 2009 | 2000 Mitsubishi Galant

4 Answers

My 2003 kia turns over but will not start, it ran good earlery


We replaced the crank sensor and another sensor still nothing.

Aug 18, 2009 | 2005 Kia Sedona

1 Answer

New starter good batt. only clicks wont turn over 1995 montero


The Batt does not have a full charge or it is the wrong cranking AMP's for the car... find out if it is the right Batt and also that it is put on a "slow charge" over night or at least 6 hr's

Jan 20, 2009 | 1995 Mitsubishi Montero

1 Answer

Transmission pops out of gear


Sounds like your tranny guy just did a bad job, the tranny needs to come out and be inspected internally. I bet the guy has a lock pin in wrong, or not at all.

Nov 28, 2008 | 1998 Chevrolet Cavalier

1 Answer

94 toyota camry le


Hi,when you say rebuilt,are you speaking of the tranny.If so,then you should call the tranny repair shop to have it towed back at there expense.No doubt,you have a warranty on the repairs?As far as the "water sensor".The vehicle has an engine coolant temperature sensor but this should not give you your symptoms...Please rate this answer..Thank You and Good Luck!!!

Aug 04, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...