I have had the XG350L into the dealer about 5 times for an air bag warning light that stays on. When they have reset it without finding a problem it is a very tempory solution. The problem has been a loose connector twice and once they replaced a faulty side air bag. Is there any way that I can check the connectors without going to the dealer.
Not sure of the year of your car, but there was a recall to resecure the harness connector. If it is 2005 the entire airbag harness should be replaced, Sorry only the dealer can access the air bag info.
Tighten battery terminals tightly or get a lead terminal post cap and tighten the battery cable very tight. the air bag light triggers when you hit a bump or just have a lose connection to the battery. Same thing happened to me
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Not normal at all. Could be a connection problem at the air bag pre tensioners, the part where your seat belt clips in to when you wearing the seat belt, or could be the hooter ring contact that is not good or the airbag/s has been activated then airbag computer and seatbelt stalks that activated has to be replaced.
You have a problem or fault with your airbag system and the system would not work if you had a accident. Working on that system incorrectly could cause the airbag to inflate. Take your truck to the dealer or professional garage.
Hello, This can be something that really needs attention. The warning can tell you that there is a bad Impact sensor on the front bumper or that the Chemicals or contacts in one of your Airbags is not correct.
You really don't want the thing triggering your bags by accident or having a bag that will not inflate. There should be a Diagnostic plug a scanner can read. It may be something any Bump shop can attend to if you want to avoid a Dealer.
If the airbag light stays on after it completes it's "check light" process then there is a fault in the air bag system. It could be anything from a bad sensor (there are 3 of them) to a wire that has become unplugged. This problem should be repaired as soon as possible because the air bags will not deploy in a collision while the warning light is continually on.
In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to follow factory Airbag disarming protocol can result in an unexpected Airbag deployment and possible serious personnel injury or death.
is this van new for you ? is it a status light letting you know that the airbag is loaded and ready for anypassenger that you have in your van ? do you have a key that you can turn it off in most vans there is an option to turn air bag on or off depending on size or opinion of passenger . im thinking that if its a status light its okay to be on letting you know its ready for opperation . take a look at your owners manual airbag section . and if it does turn out to be a warning malfunction indicator please dont waste time take it to your local dealer and have it checked out .hope this information helps good luck