2004 Infiniti I35 Logo

Related Topics:

Posted on Dec 10, 2010

2002 Infiniti I35 The driver's power seat forward/back motor has quit working. Is it possible, in the short run, to move the motor from the passenger side to the driver's side? Is it necessary to undo the battery cable also???

5 Related Answers

Anonymous

  • 58 Answers
  • Posted on May 05, 2009

SOURCE: How to program 2002 i35 infiniti keyless remote?

The procedure goes like this. First get in the car and lock all the doors. Secondly insert and remove the key repeatedly until the turn signal indicators on the dash flash twice simultaneously, it should be like seven or eight times. Then turn the key on and press the lock button on the remote and the lights should flash again. After that turn the key off and manually unlock and open the drivers door, then shut it. Wait a few seconds then try the remote. 

Ad

Anonymous

  • 1 Answer
  • Posted on Jun 28, 2009

SOURCE: Driver's seat unable to move forward or backward

I have the same problem. I removed the motor assembly that powers the seat fore/aft and found a stripped plastic gear on the right-hand side of the driver-side seat track. It looks kinda like a speedometer gear. I was able to remove it, and hopefully Infiniti sells just the little gear.

Anonymous

  • 601 Answers
  • Posted on Jul 26, 2009

SOURCE: how do you get at the radiator drain plug on a

Hi...

This picture should help you.

f474e50.jpg
Thanks
Smith

Anonymous

  • 1326 Answers
  • Posted on Sep 10, 2009

SOURCE: kia sedona front passenger seat stuck in forward position

Electric or manual??? If electric one of the motors has gone out. If the kids were playing with it they may have held the button down causing the motor to spin while the seat was all the way foward and it will just burn the motor up after so long. Also the switch could be bad. Unfortunatley being that its power there is no way to manually move the seat back without the motor turning or removing the seat and spinning the motor sprocket by hand...

Anonymous

  • 1 Answer
  • Posted on Oct 02, 2009

SOURCE: Driver's seat unable to move forward or backward

There are plastic gears connecting the track to the seat assembly. Whne one of these strip the seat will only work or move to one side. Infiniti does not sell a simple fix. You are looking at buying an entire seat assembly complete with the module for all the electronics. It will be at a cost of around $950 - $1000. Once that is in, Infiniti must program the seat to the brain of the car, only then can you reset your memory settings.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Infiniti 03 i35 the driver seat won't move forward or backwards...help

Infiniti/Nissan Seat fix - YouTube

? 3:31
www.youtube.com/watch?v=L1pTDadNdLw
May 25, 2012 - Uploaded by Nathan Melendez Fix the seat motor on a Infiniti Qx4 or a Nissan Pathfinder, and most other cars. ... Make seat make a clicking ...
0helpful
1answer

Power seat Ford Escape 2003 drivers seat will not move forward or back

If it isn't making noise, check the electrical connection. If its getting power it could be that the motor needs to be replaced.If it just hums when you try to operate it, the motor is either jammed or needs to be replaced.
0helpful
1answer

Infiniti I35 2004 with all options and 80,000 miles. The driver's electric seat is jammed at the back position and tries to go forward whenever the car starts and all it can do is make a grinding...

sounds like the motor is bad easiest and cheapest way to fix would be to get a complete seat from the Junk yard the seat should come with all the motors and tracks all you have to do is unbolt old seat and bolt down new one only draw back to this is seat might not be same color but there two ways to fix that first u could just get a set of seat covers Or you can take the track and motor off new seat and install them on the old seat
21helpful
3answers

Driver's seat unable to move forward or backward

There are plastic gears connecting the track to the seat assembly. Whne one of these strip the seat will only work or move to one side. Infiniti does not sell a simple fix. You are looking at buying an entire seat assembly complete with the module for all the electronics. It will be at a cost of around $950 - $1000. Once that is in, Infiniti must program the seat to the brain of the car, only then can you reset your memory settings.
5helpful
2answers

The drivers seat is stuck. It won't move forward or backward but all other seat functions work fine. hi and please help..I have the same problem with the driver seat..it will go up and down and the back...

I'm assuming this is a power seat. If so, there are separate motors that control the various functions of the seat such as forward/backard, recline, lumbar support, etc. It could be that the motor or an electrical connection to the motor for the forward/backward motion is faulty. Normally all of the motors would be on the same power circuit, so if some of the functions are working then it is probably not a blown fuse.

Just one other personal observation, I have actually seen an instance where some loose pocket change had spilled under the seat and a quarter had become wedged in the track that the seat slides in and had jammed the tracks so tightly that the seat would not move.

One thing to note is whether or not you hear anything when you try to move the seat forward/backward. If you hear a click or a buzz when you press the button then that could mean that something is physically jamming the seat tracks. If you don't hear anything when you press the button, then that more than likely means a problem with the motor or the electrical connection to the motor.
10helpful
4answers

Power seat switch

It is most definitely the seat slide motor. Most infiniti drivers seats have three different motors. I30, I35's and QX4's all had problems with the seat slide motors. You can tap on the slide motor which is under the front of the seat and it will probably work for a little while, but it WILL stop working completely. There was actually a Technical Service Bulletin regarding this issue because there were so many vehicles that had this problem. I hate to see that guy waste money trying to get a circuit board rebuilt that absolutely will not solve the problem. 
12helpful
4answers

The drivers seat is stuck. It won't move forward or backward but all other seat functions work fine.

This is a seat slide motor assembly problem. I worked for an Infiniti dealer for many years as a service advisor, and this was a common issue on these vehicles. Most of the time you can take the **** end of a screwdriver and tap on the motor from the front of the seat and it should start working. It may work for a while but it will most certainly stop, how soon depends on how far gone it is. Eventually it will quit working altogether and tapping it won't work either. As a service advisor we probably replaced a hundred of those things. Last I knew the part was about 280.00 and about an hour labor. I would not take it to someone who doesn't really know Infiniti though as you may get the car back with an air bag light flashing or something. Dealers really don't try to rip people off, they generally want to do the right thing as they want you to come back for all your problems, keep that in mind. 
Not finding what you are looking for?

974 views

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...