- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you have rear disc brakes, one of the rotors could be warped and causing the pads to move in the caliper. You should be able to remove one wheel at a time, lock down the rotor with the lug nuts, and put the trans in low gear or reverse to listen for the noise.
your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.
Go to the autozone.com website and register your vehicle. It's free and you will access to an online repair manual. Info on changing the oil pump should be available there. Hope this helped and best wishes.
Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don
When I crank my truck it runs wide open for a minute of so and then it starts to idle down. What causes this? It is a 1992 Chevy S10 v6 pickup. How can I fix this problem? I have no manuel on this vehicle for a diagram of the engine at all.