Question about 1997 Toyota Corolla

1 Answer

New carburator installation problems

I installed a new carburator in my car, now the cars refs is extremely high

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 117 Answers

You need to wind the idle adjusting screw to set the idle its the lowest screw on the side of the accelerator cable holder

Posted on Jun 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change powerstering pump chevy uplander


I just finished replacing mine.

It is much easier if you do these steps:

1. Remove the serpentine belt.
2. Remove the nuts holding the main fuse box over the battery.
3. Remove the reinforcing bar over the battery.
4. Remove the battery.
5. Remove the windsheild washer tank.
6. Now you have access to remove the pump pulley. Without removing the stuff, it may be possible, but it will be extremely difficult.
7. Remove the pump pulley.
8. Loosen the high pressure hose fitting.
9. Remove the return line clamp.
10. Remove the power steering pump mounting bolts.
11. Remove the high pressure hose fitting.
12. Remove the power steering pump while sliding off the low pressure hose.
13. Remove the clips holding the reservoir on the pump.
14. Remove the reservoir.
15. Install new o-ring on the reservoir.
16. Install reservoir on new pump.
17. Install clips to hold reservoir on pump.
18. Install new o-ring on high pressure fitting.
19. Place new pump in position while sliding on low pressure hose.
20. Loosely attache high pressure fitting.
21. Tighten pump to mounts.
22. Tighten high pressure fitting.
23. Install clamp on low pressure hose.
24. Install power steering pulley.
25. Install washer reservoir.
26. Install battery.
27. Install reinforcing cross member.
28. Install fuse panel.
29. Install serpentine belt.
30. Bleed the power steering system.

Dec 13, 2012 | 2008 Chevrolet Uplander

2 Answers

Replace power steering pump on 06 chevy uplander


I just finished replacing mine.

It is much easier if you do these steps:

1. Remove the serpentine belt.
2. Remove the nuts holding the main fuse box over the battery.
3. Remove the reinforcing bar over the battery.
4. Remove the battery.
5. Remove the windsheild washer tank.
6. Now you have access to remove the pump pulley. Without removing the stuff, it may be possible, but it will be extremely difficult.
7. Remove the pump pulley.
8. Loosen the high pressure hose fitting.
9. Remove the return line clamp.
10. Remove the power steering pump mounting bolts.
11. Remove the high pressure hose fitting.
12. Remove the power steering pump while sliding off the low pressure hose.
13. Remove the clips holding the reservoir on the pump.
14. Remove the reservoir.
15. Install new o-ring on the reservoir.
16. Install reservoir on new pump.
17. Install clips to hold reservoir on pump.
18. Install new o-ring on high pressure fitting.
19. Place new pump in position while sliding on low pressure hose.
20. Loosely attache high pressure fitting.
21. Tighten pump to mounts.
22. Tighten high pressure fitting.
23. Install clamp on low pressure hose.
24. Install power steering pulley.
25. Install washer reservoir.
26. Install battery.
27. Install reinforcing cross member.
28. Install fuse panel.
29. Install serpentine belt.
30. Bleed the power steering system.

Jul 08, 2012 | 2006 Chevrolet Uplander

1 Answer

1991 F 150 will only idle,dies when gas pedal is pressed


Sound like a carburator problem. Possibly a bad accelerator pump. A carburator kit comes with a new one if you know how to install the kit. If not either have a shop rebuild it. This is much cheaper than buying a new one.

Dec 04, 2011 | 1991 Ford F150

2 Answers

Car is stalling at stops and running at high idle in park


Take it back to who ever rebuilt the carb. What you are describing are all carburation problems. Float set too high. Fast idle set too high. Accelerater pump not working. (inside carb). To get it started, pump it 2 times, and then hold it to the floor, and crank it over. Then if it runs, take it back to him. Check you oil. If it's really flooded bad, you will be way over full.

Mar 23, 2010 | 1989 Dodge Diplomat

1 Answer

Steering extremely hard, after installation of a new battery


replace the steering pump and it might work better

Aug 21, 2009 | Chevrolet HHR Cars & Trucks

1 Answer

My 99 accord goes into high idol when starting and if you touch the gas it revs high then low till i turn the car off . if i leave it on high idol after starting and dont touch the gas it eventually will...


check for air leaks on the emission system, if fine, check for the throthle posittioner disconect it, if idles good, replaceit, next go to the idle motor, is next to the throthle body, remove it and clean it with a good carburator cleaner, install it and start the car.
good luck.

Jul 08, 2009 | 1999 Honda Accord

2 Answers

New carburator and it runs worse


Check your fuel pump,it sounds as if you have excessive fuel pressure.

May 05, 2009 | 1984 Ford F 250

1 Answer

Carburator problems


Sounds like the choke circuit is faulty. Find a shop that works on older cars with older mechanics. The new mechanics don't know how to work on older cars. Good luck. Please rate me so I know if I helped you. Thanks.

Dec 31, 2008 | 1986 Buick Regal

1 Answer

Carburator seems to stall at high rpm's


mcdevito75 here, It could be a bad gas filter or fuel pump, if you can, change them both.

Nov 30, 2008 | 1987 Mitsubishi Mighty Max

1 Answer

Carburattor instalation


i have a nissan sentra 1994 4 doors, in Colombia, Bogota South America, but i have some problems with the sincronisation becouse somne times the car increases the aceleration along. its an automatic car.

Jun 29, 2008 | 1997 Toyota Corolla

Not finding what you are looking for?
1997 Toyota Corolla Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...