Could be the slave cylinder or clutch plate. Check ur bell housing and see if your fluid level is low. You can put clutch fluid in the housing 3/4 of the way full. Pump your clutch a couple of times to get fluid in the lines. You can do this a couple of times, but after a week or so you NEED to replace your clutch. You can get'em at your local parts store for about $150. You need to have a mechanic replace your clutch because it involves removing your transmission. total cost about $400 Same thing happened to me twice in 2 yrs. Make sure you get a lifetime warranty. Hope this was helpful
SOURCE: 1998 Chevy S10 front axle will not engage when put into 4 wheel
Normal thing that happens as long as onone (worked) on it, is the vacume hose going to the engage sevevo under the battery box has fell of on either end or is brocken on the way there. Then the once or now leaky battery acid ate up this same servo. then the cable going to the front axel breaks sticks falls off or even someone needing one climbed under your truck while parked somewhere to get one to replace their brokeen one now you don't have one then theaxel engage arm or gearset is damaged
SOURCE: I have a 1998 Hyundai Tiburon Clutch will not engage
it sounds like the pressure plate or the clutch need replacing umay have a broken spring on the pressure plate .or the fork that goes in side the bell housing is off the ball socket that holds it in place either way the transmition has to be removed to determin the problem
611 views
Usually answered in minutes!
×