Question about 1998 Plymouth Grand Voyager

2 Answers

98 plymoth grand voyager cruise control

We have a 98 grand voyager that the cruise control won't engage, is there a fuse or relay that may have gone bad, or is it worse?

Posted by on

  • 1 more comment 
  • Anonymous Feb 16, 2009

    my cruise control will not engage and then sometimes it is kinda hard to start I am not sure that the two are connected but they both started happening at the same time hum

  • madsont Apr 17, 2009

    my cruise is out but the light comes on to show cruise is on but you can not set it and also when it was on cruise the rpms would surge and you could feel it **** a little... I have a 2000 dodge grand caravan sport

  • Anonymous Mar 21, 2014

    trying to locate the horn on the van it doesn't work

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Possible solution, the cruise control circuit goes through the clock spring. You might need to check it out. If the problem is intermitten, it may be had to comfirm that the clock spring is the problem. Does your horn work? If it does not work, there is a high probability that you need to change the clock spring.

Posted on Mar 11, 2009

There was a recall for an air bag problem which also fixes the cruise control and horn (clockspindle in steering wheel)

Posted on Jul 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1997 Plymouth Voyager 6Cyl. Had clockspring repaired at dealer. Cruise control light goes on in dashboard but no cruise?


cruise controls are operated by
brake switch
VSS auto or clutch pedal -manual
tacho
control switch,
ECM
cruise control will not engage if the engine rpms are too low , vehicle speed is to slow
VSS unit is faulty (wiring)
switch is not making full contact
any one dropping out will cancel the control engagement

Sep 28, 2016 | Plymouth Cars & Trucks

1 Answer

1997 Plymoth Grand Voyager windshield wipers and door locks turn on and off while driving with no warning. Now the cruise control no longer works. Where is the Body Control Module located, and how much...


the turn signal switches go bad on 99% of those cars. the other one percent its the bcm[behind fuse box drivers side. or a wire to it. either one of the door ajar switches[usullay the slider ]is out of ajjustment or one of the door lock cylinder switces is bad.

Jul 02, 2010 | 1996 Plymouth Voyager

2 Answers

The cruise control and horn do not work


It sounds like the "clock spring" in the steering wheel is bad. It makes the connections for those items on the steering wheel.

47a7ac5.jpg

Jun 09, 2010 | 2000 Plymouth Grand Voyager

1 Answer

I changed the relay fuse to my windshield wipers and the knob and my wipers still wont work on my 98 plymoth grand voyager what should i check


Turn wipers on (veh in "on" or "acc" position)
Disconnect the electrical connection at the windshield wiper motor (located in the engine compartment on the fire wall) and check for voltage. If you have voltage, there is a good possibility your windshield wiper motor is bad.
You may also: Disconnect the electrical connection at the windshield motor and run a heavy gauge wire directly from the positive side of the battery to the motor. If you get the windshield motor to come on. There may be only a wiring (short) problem between the relay and the motor.
Let me

Jan 21, 2010 | 1989 Plymouth Reliant

1 Answer

98 plymoth grand voyager cruise control


disconnect battery and wait 20 minutes for safety

you need to remove the air bag (3 bolts behind the steering wheel) then remove the steering wheel 1 nut but you need a puller. then the column shrouds 3 screws under the column the unplug and replace the clock spring and put it back together.

Apr 21, 2009 | 2000 Chrysler Grand Voyager

1 Answer

1998 plymouth grand voyager cruise control relay/fuse location?


Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.

Apr 10, 2009 | 1998 Plymouth Grand Voyager

1 Answer

Cruise control 1998 plymouth grand voyager not working


Check fuses under dash on drivers side, & fuse & relay box under hood on drivers side. I.D. for fuses & relays under hood on underside of cover.

Apr 09, 2009 | 1998 Plymouth Grand Voyager

1 Answer

Cruise control 1998 plymouth grand voyager fuse block diagram


Hello chekon,

Thank you for choosing fixya.com. The fuse box cover should have a diagram on the back of it, which will indicate which fuse represents it's component(s). If you are unsure what any abbreviations stand for or represent, look in your owners manual, or look in a service manual for the 1998 Plymouth Grand Voyager. I also own a 98 Plymouth Grand Voyager (SE) and have a service manual for it, as well as for the 97 Dodge Caravan. My 98 has the 3.0 L engine, and I have done several maintenance requirements to it recently, so if you have any other questions, please let me know and I'll help you out.

Let me know if you need me to locate any fuses or relays for you. In the meantime, I'll do some searching online for some diagrams. Most sites charge for such items, however, if I find something I'll leave a comment with such findings.

Thank you again for choosing fixya.com.


carsandcomps
Guru, fixya.com
Oregon

Apr 09, 2009 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
1998 Plymouth Grand Voyager Logo

760 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...