Question about 1999 Jeep Cherokee

2 Answers

Jeep error code p1698. Starts with high rpms and in higher gear (3rd gear?). O/D botton dosen't light when button on shifter pressed.

Posted by on

  • Anonymous Aug 17, 2008

    p1698 comes up for code. The car starts in 3rd and doessnt shift up, no od light goes on. Im getting 7mpg

  • mrfalt Oct 05, 2008

    airbag light on P1698 error code. no tach and no speedo I can only shift outta gear if I physically put it into 1-2, then 3, and then D.  

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Isn't a bad TCM my problem ended up being a bag engine ground.  Cheap fix check that before you send it to the dealership and spend $120!!!!

Posted on Oct 22, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

Have the dealer check it out.
You could have a bad tranny control module.

Posted on Oct 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'm getting no guages & no bus code on odometer. Its a 99 Cherokee sport. I put a scanner on it & it had 2 codes. I can't find them in my book or jeep forum. The codes are #1- P1698 & #2- P1694.


P1698 Jeep P1698 Jeep - ECM Fault No CCD Message From TCM Repair Importance Level: 3/3 Repair Difficulty Level: 3/3 alt="What does this mean?"> Share alt="Share on Facebook"> alt="Share on Twitter"> alt="Share on Linkedin"> alt="Share on Google Plus"> alt="AutoCodes.com"> alt="Print Version"> alt="PDF Print"> alt="Share Code"> alt="P1698 Jeep Comments"> ' Add Comment alt="Close Selection"> http://www.autocodes.com/p1698_jeep.html Forum Code Possible causes - Faulty Engine control Module (ECM)
- Engine control Module(ECM) harness is open or shorted
- Engine control Module (ECM) cicuit poor electricl connection
- Low battery voltage
alt="What does this mean?"> What does this mean? Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) P1698 Jeep Description Engine control Module (ECM) unable to communicate with Transmission Control Module (TCM)


Read more: http://www.autocodes.com/p1698_jeep.html#ixzz3trtqLzjM

Here is P1694


Code P1694

Dec 09, 2015 | Jeep Cars & Trucks

1 Answer

My 95 yukon wont shift in to 3rd gear ?


I think you have two separate issues

First get all the codes & fix the ABS issues first

I think you'll find the trans is due for a rebuild,sorry, if that doesn't turn out to be the case.
It is slipping for some reason & that isn't fixable without a tear down

May 24, 2012 | 1995 GMC Yukon

1 Answer

I have a arrow light on the instrument panel down where all the other lights are like the battery light an oil light ect. Anyway sometimes that arrow light flashes and wondering what it means an what need...


4th gear disengagement:

The 4th gear is engaged automatically after the transmission has shifted through 1st, 2nd and 3rd gears

at certain speeds and loads. By pressing in the button at the rear of the selector level, the 4th gear can be

disengaged, thus providing a three-speed transmission. As a reminder the


? light on the dashboard

glows. By pressing in the button again, the transmission reverts to four-speed operation and the


?
light shuts off.
This is straight out of the owner's handbook. What this indicates is that there may be a problem with the shift solenoid. On the highway, does is seem to rev high? Can you press the button on the shifter and have the light go out? let me know.

Aug 13, 2011 | Volvo 850 Cars & Trucks

1 Answer

What does it mean when the "Hold" indicator light comes up?


Hi, the hold light refers to the hold button on the shifter module. It means the transmission holds the lower gear revving up the rpms and won't shift to the higher gear. Seeing the light means the button has been engaged. Push it to turn it off.........

May 11, 2011 | Mitsubishi Montero Sport Cars & Trucks

1 Answer

Rpms rev. high before it will go into gear. and it wont go into overdrive unless you play with the gas and the gear shifter.


when was the transmission last serviced? it seems like the transmission filter is plugged and it takes the pump higher rpms to push fluid through try changing the tranny filter.,

Jan 19, 2010 | 1992 Buick Roadmaster

1 Answer

2004 jeep grand cherokee idling problem. Revs motor 200 to 500 rpms higher while driving.


I had the exact same problem on my 04 GC. I put some Techron Concentrate Plus Fuel System Cleaner in from Wal-Mart and it seemed to fix the problems right away. Let me know.

May 31, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Transmission wont shift until about 4000rpms from 1st to 2nd gea


Have a code check done and see if speed sensor or controller is working properly. if bought from a dealer, get it back there asap...they can't sell it in that condition!!...No test drive before you ploped down your money?

Apr 16, 2009 | 2004 Jeep Grand Cherokee

1 Answer

The D3 code on my 2007 honda odyssey is on what is the problem


Hi!
This is not a code. Instead it is an indication that you are running the van in "overdrive off" mode.

Your van is equiped with a 5 speed automatic transmission. By running in overdrive off you are essentially running in 3rd gear, out of 5 gears. This will cause your van to run at a much higher engine speed, while not going very fast at all and consuming a lot more gas than normal.

You can deactivate this mode by:
1) start the van
2) Press the break pedal
3) Shift to 'D' (drive mode)
4) press the little button that is located on the left side of the shifter, under the shifter button.

If the light does not go out after pressing this button, you may need to take the van to your Honda dealership. Your van should still be under warranty as it is a 2007 model.

Good luck!

Jul 02, 2008 | 2007 Honda Odyssey

Not finding what you are looking for?
1999 Jeep Cherokee Logo

Related Topics:

663 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...