Question about 2007 Pontiac G6 GT Convertible

Open Question

Pontiac g6 shuts off while driving and time delay when you press gas pedal to increase speed

Posted by on

  • Anonymous Feb 17, 2009

    Car hesistates when accelarating and sometimes it almost shuts down. MIL will flash but will never stay on. No codes are ever set on ecm.

×

6 Suggested Answers

SOURCE: transmission

do a computer diagnostics, may be your oxygen sensors in anti
pollution system malfunctioned. some of these computer assisted models do this to attract attention to E.P.A. standards

Posted on Jul 30, 2008

tneubauer
  • 437 Answers

SOURCE: Pontiac G6 gas pedal rattle

Is this almost like a metallic buzzing sound?

Find the catalytic converter under the car it should have a shield on it. Use a broomstick with the car running and hold the shield still and have someone give it a little gas. Just move from shield to shield until you find the offending shield.

Don't touch these with your hand as they can get hot fast.

Most parts houses sell a very large hose clamp to go around these shield for about $10, they will know exactly what you are looking for.

Posted on May 30, 2009

  • 1857 Answers

SOURCE: 95 grand am bucks, but sometimes doesn't. It will

Alot of things can cause this, even a spark plug. but I would be looking at maybe a coil or ignition module issue or a weak fuel pump that is on its way out. Or maybe even a throttle position sensor. Noone can say forsure without driving it themselves and testing based on what they felt.

If its time for a tuneup I would do the plugs and wires., If you dont suspect the tuneup as being the problem I would replace the ignition module that is located in the cover that is on top of the engine covering the sparkplugs. Its a easy job. Its attached to the under side of the cover. I have seen this type of symptom several times with this car and the module is usually the culprit when everything else checks out ok.

Posted on Jan 14, 2010

emissionwiz
  • 61037 Answers

SOURCE: Free Press announced recall on 2009 Pontiac Vibe.

call any GM dealer they can tell u if your specific car is involved, it goes by vehicle ID number or VIN, u will also revieve a letter in the mail at some point.

Posted on Jan 28, 2010

  • 121 Answers

SOURCE: pontiac g6 2006 2.4l codep0300,idles is good but

that code is an engine misfire. try changing the plugs and wires. if that doesnt work you may have to change the coil packs.

Posted on Feb 23, 2010

  • 2 Answers

SOURCE: I have a 2005 pontiac

Open up the access panel on the passenger side - see pic below.
f234998.jpg
You;re looking for a reddish color 10 fuse located on the bottom right in the fuse box. This should be the fuse for the instrument panel. Hope that helps.

Posted on Oct 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turns off when going on reverse and when turning the wheel without pressing on the gas pedal


I know this might sound dumb, but it has happened to a lot of people - make sure your floor mat (not even a corner of it) isn't on top of the accelerator pedal. Even the slightest weight can cause the pedal to accelerate enough to be noticeable.
Not dumb, it's a good answer. The floor mat can slip forward (and has) in two of our new vehicles when we were driving on the highway. It had worked its way off the anchors and slipped forward, causing the vehicles to accelerate. I put the gearshift in Neutral, pulled off the highway and that was the problem, both times. I don't think it was on top of the gas pedal, underneath, but still pressing or I guess, pulling the pedal down.

All of these are good answers, but if it's an automatic transmission, it might be normal provided the engine performance is ok. Auto trannies have a torque converter stall speed. I have a 96 Cadillac Fleetwood and it will move on its own.

Parts For Porsche Boxster

Jun 11, 2012 | 2000 Pontiac Sunfire

1 Answer

My 2006 g6 sometimes will crank but not start. does it when cold and warm. sometimes you can try again and it will start other times it takes a few tries


tons of reasons.... depends on your troubleshooting feedback fouled plugs (change em) crappy gas (put a pint of gas cleaner in the tank at next fillup before you fill it) low fuel pressure (breach in fuel delivery?)
I assume you are not pumping the gas pedal at all, but if you are, do not do that. Leave your foot off ! If you do pump it, it will most easily flood it with gas and prevent ignition until the gas is cleared (you can clear a flooded system by pressing and keeping the gas pedal to the floor (once) and try to crank. Release the pedal immediately upon successful ignition revolutions.

Feb 08, 2011 | 2006 Pontiac G6

1 Answer

How do I change the time on the radio in my '08 pontiac g6


To set the hour, press the CLOCK button. The clock symbol displays and the hour flashes. Turn the ADJ (adjust) knob to increase or to decrease the hours. To set the minutes, press the CLOCK button again. The minutes flash. Turn the ADJ knob to increase or to decrease the minutes. The time can be set with the ignition on or off.
To synchronize the time with an FM station broadcasting Radio Data System (RDS) information, press and hold the clock button to enter the clock set mode, then press and hold the clock button for three seconds until UPDATED displays. If the time is not available from the station, NO UPDATE displays.
RDS time is broadcast once a minute. After tuning to an RDS broadcast station, it can take a few minutes for the time to update.

Nov 07, 2010 | 2008 Pontiac G6 Sedan

2 Answers

I cannot get the Change Oil Soon message to reset on a Pontiac G6


Chevrolet Malibu, Malibu Maxx 2004-06; 2006 HHR, Cobalt, Pontiac G6, Solstice
Turn ignition to run engine off. Display OIL LIFE RESET in the Driver Information Center (DIC). Press and hold the ENTER button for at least one second. An ACKNOWLEDGED’ display message will appear for three second or until the next button is pressed. This will tell you the system has been reset. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Jul 17, 2009 | 2007 Pontiac G6 GT Convertible

1 Answer

Brake lights stick while driving but turn off when pressing brake


CHECK YOUR BRAKE LIGHT SWITCH THAT IS ON YOUR BRAKE PEDAL UNDER THE DASH

Jul 05, 2009 | 2007 Pontiac G6 GT Convertible

1 Answer

Pontiac G6 oil reset will not work has in past


try turning the key on with engine off, pump the gas pedal 3 times within 3 seconds

Jun 17, 2009 | Pontiac G6 Cars & Trucks

1 Answer

Pontiac G6 gas pedal rattle


Is this almost like a metallic buzzing sound?

Find the catalytic converter under the car it should have a shield on it. Use a broomstick with the car running and hold the shield still and have someone give it a little gas. Just move from shield to shield until you find the offending shield.

Don't touch these with your hand as they can get hot fast.

Most parts houses sell a very large hose clamp to go around these shield for about $10, they will know exactly what you are looking for.

May 30, 2009 | 2006 Pontiac G6

Not finding what you are looking for?
2007 Pontiac G6 GT Convertible Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...