Question about 2006 Hummer H3

2 Answers

Turn signal repair hummer h3 - 2006 Hummer H3

Posted by on

  • 1 more comment 
  • h34me Jun 28, 2008

    took off front grill, still can't figure out how to replace turn signal???

  • Anonymous May 04, 2009

    I don't know how to get to my driver's side front turn signal!!!

  • Anonymous Mar 23, 2014

    engine does not turn over, like it is not getting gas

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Remove a half dozen or so plastic rivets holding plastic wheel well in...the center of the rivets pull out then yank on them. the rest is obvious.

Posted on Jul 10, 2008

My computer screen is the wrong way round?

Posted on Jun 28, 2008

6 Suggested Answers

mastatech
  • 478 Answers

SOURCE: can a 2007 h3 hummer be towed behind an rv

yes,it can be done exactly like the jeep!

Posted on Mar 14, 2009

goofduck
  • 490 Answers

SOURCE: Hummer H3 rear lights staying on

if it is the brake lights that are on check the brake light switch on the brake pedal

Posted on Apr 21, 2009

  • 30 Answers

SOURCE: DOORS displays on DIC in 2007 Hummer H3. All

i beleive those have their own door switches in latch i would try to clean latches with spray brake kleen then blow out, lube with a spray lube like wd40 that may solve your issue. while your doing this remove negative battery cable so the ecm has to recheck doors system.

Posted on Mar 18, 2010

  • 1 Answer

SOURCE: 2006 H3 Hummer fan problem

Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner

Posted on Jun 11, 2010

  • 594 Answers

SOURCE: my h3 hummer reduced power signal came on last

SCAN FORE ENGINE CODE

Posted on May 08, 2011

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 h3 hummer with no brake lights or turn signals. I have replaced the turn signal switch. Can anyone help me with this


Check switch on the brake pedal,check globes in the rear of car have power going to them,you will need a test light to test them.

Mar 29, 2017 | 2006 Hummer H3

2 Answers

Why do I lose radio signal on my 2006 h3 hummer when I turn on my ignition? My radio works fine until I turn on my ignition.


If it works at the accessory position and not on the run position. I would go after the run wire to the radio. If other things don't work in the run position, look to the ignition switch.

Oct 08, 2016 | 2006 Hummer H3

1 Answer

Driving and Rpms go up


Dealer Checked my Hummer. They said all H3's have the same problem ...

www.elcovaforums.com > ... > General H3 Discussion

Sep 15, 2005 - 24 posts - ‎17 authors
rattling sound inespected in my hummer because ... go uphill or press on the gas pedal to ... same time up to 2500 rpm on my H3. .... Buzz or Rattle Noise While DrivingUnder Load from the Exhaust ... 2006 Hummer H3

Slow Gear Shift, Low RPM - Normal for H3? - Hummer Forums ...

www.hummerforums.com > ... > Hummer Lineup > Hummer H3
Mar 6, 2012 - Hey All! I recently bought a used 2007 H3 (automatic). ... for h3"!!.if it dont feel normal,,it aint!! im driving my 2nd h3 and they both felt ... 2006 Hummer H3... you can tell when locked up. go ez on gas and rpms dont jump,they ... Hummer H3 Won't get above 2.5 RPM - Hummer Forums ...
Jun 26, 2014
My h3 loses power and sometimes turns off when i turn
Mar 16, 2010
More results from www.hummerforums.com

RPM bouncing from idle. Caused short bursts of "unintended ...


Jan 01, 2016 | 2006 Hummer H3

1 Answer

2008 Hummer H3 passenger side tail lamp out.


There could be loose wire at the bulb socket ,A break in a wire, Or a bad ground, Or a short, Best way to have it solve is to take it into a auto eletric shop to be check out,

Nov 28, 2012 | 2008 Hummer H3

1 Answer

Install front turn signal on h3


You need to remove the front wheel hose panel to gain access to the turn signal bulbs.Hope this helps.Good luck.

Feb 25, 2012 | 2006 Hummer H3

1 Answer

Where is the inside fusebox located on a h3 hummer


check the owner's manual. the fuse that controls brake and turn signals are in the underhood fuse panel.

Nov 05, 2011 | 2007 Hummer H3X

1 Answer

My 06 hummer h3 shuts off when you turn the steering wheel


Try unplugging the power steering pressure sensor, It's either in the pressure line or on the back of the pump. It sends a signal to the PCM to increase the RPMs at low speed when more power from the pump is required when parking and such.

Jun 24, 2011 | 2006 Hummer H3

2 Answers

2006 H3 Hummer rear passenger turn signal non-op. Replaced bulb -same also checked fuse - same. need another avenue to check.


Did you check hazard operation, what is the turn signal on dash blink rate(faster than other side)? Make sure socket is clean of corrosion and terminal pins not burnt.

May 11, 2011 | 2006 Hummer H3

3 Answers

My h3 hummer has some kind of problem with the signal rear lights and the break rear light i check the fuse and that not the problem whatg to do now???


my h3 hummer runing light on trailer do not work i have no power at the plug the turn & stop lights work

Apr 23, 2010 | 2006 Hummer H3

Not finding what you are looking for?
2006 Hummer H3 Logo

Related Topics:

1,201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...