Question about 2000 Hyundai Elantra

1 Answer

Hyundai/elantra/2000 car runs when you shut off .it will not start up until cools off.

Posted by on

  • papabear3711 Jul 05, 2008

    crankshaft sensor . mine works fine now

  • Sundarj Aug 01, 2008

    Car is good while shutoff but not starting after keeping for some time (4-5 hrs)

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had my 1998 hooked up to a code reader it says its the ignition position sensor ,and can cause a coil pack problem.. But my car is doing same thing,sometimes it won't start til' the next day.

Posted on Jul 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 Hyundai Elantra won't start once the


Have you figured out if you are lacking spark to the plugs or fuel pressure when it fails to start ?

May 15, 2013 | Cars & Trucks

1 Answer

How do I flush the cooling system in a 2000 hyundai elantra?


There are several methods for flushing the cooling system on ALL engine cooling systems. Time honored is drain the radiator (drain ****). Fill with fresh water and run engine to operating temperature until cooling fans turn on. Drain cooling system again. Refill with 50-50 coolant. Another method is purchasing a "T" vlave (coolant flush/service kit) from Autozone, PepBoys, NAPA, O'Reilys, CarQuest, etc.). This "T" valve is installed in one of the heater hoses & attached to a garden hose. Remove the radiator cap & turn on the water supply to the garden hose. Let water run until flush water is 'clear'. Remove garden hose from T valve & refill radiator with pure coolant until the T valve drainage turns green/orange. Install T valve cap... DONE!

Sep 08, 2011 | 2000 Hyundai Elantra

1 Answer

My 1998 Hyundai Elantra will not start after running out of gas.When I put gas in it ,it would crank but it took a long time to start. I drove it 3 miles and it shut off. I cranked it and cranked it,but it...


Don't let the car run out of gas. Fill the tank and run until the tank is half empty. Again fill the tank.
By driving until you run out of gas, you are letting sediments/dirt collected in the bottom of the tank to enter the engine. Rather they will block the fuel filter. Then gas will not reach the engine.
Clean the gas filter and your car will run fine.
The same advice again. Don't drive until the tank becomes empty.

Aug 30, 2011 | 1998 Hyundai Elantra

1 Answer

I have a 2000 hyundai elantra that does not want to start. When starting the engine the car acts like it wants to start then dies. I have fire at the spark plugs, I do hear the fuel pump running, all my...


engine might be flooded remove spark plugs to see if they are wet with fuel pull fuel pump fuse crank eng over with plugs removssed to push fuel from cylinders dry plugs reinstall hold gas pedal to the floor while cranking untill engine starts

Dec 27, 2010 | 2000 Hyundai Elantra

1 Answer

Replaced fuel pump in 2000 hyundai elantra and


well if she ran it to long with no oil it might be locked up and might be able to turn it over if its not to bad. but you should still get power going to your fuel pump i would check all connection going to fuel pump and no broken wires. try even un plugging battery to see if there's a bypass

May 05, 2010 | 2000 Hyundai Elantra

1 Answer

How do i remove air from a 2000 hyundai elantra cooling system?


loosen up the radiator cap and add fluid (while car is running ) till there is no more bubbles also check to see if there is a bleeder it will be located by the thermostat housing do this first.

Oct 19, 2009 | 2000 Hyundai Elantra

2 Answers

2000 hyundai elantra alarm goes off where is the


There is NO kill switch on the 2000 Elantra... HOWEVER, there is a thing called the Key Fob (keyless remote entry system). There is, however, a system in place called the 'starter kill' circuit and it is activated when the burglar alarm goes off.... it's called the burglar alarm relay and it is activated to prevent the engine starter system from being used. There are three ways to get the engine started in such a circumstance... 1. use the key fob to 'disarm' the system... 2. put the key in the ignition and turn it to the 'RUN" position and wait until the alarm stops (horn stops beeping and the parking lights stop flashing), then the engine will start.... 3. pull the starter relay from the UnderHood junction box and bypass the starter circuit (key in ignition and in the 'RUN' position), jumper the starter solenoid circuit to energize the solenoid to start cranking the engine -- it should start then.

Oct 03, 2009 | 2000 Hyundai Elantra

1 Answer

My Hyundai Elantra 1999 crankshaft position sensor A circuit


could be ??the windings in the sensor have the insulation on the way out

Jun 28, 2009 | 2000 Hyundai Elantra

1 Answer

2000 hyundai just shuts off....


often that problem can be cause by the crank sensor, check engine light will come on,if it is scan code to make sure ,it will point to problem area

Feb 27, 2009 | 2000 Hyundai Elantra

1 Answer

2000 H-tiberon dies and does not start until cools or hours later.


hi no engine codes showing as this is normally the ecu,s engine temperature switch if no codes get the ignition coil checked out while it won,t start yates210456

Oct 09, 2008 | 2000 Hyundai Elantra

Not finding what you are looking for?
2000 Hyundai Elantra Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...