Keyless entry my keyless entry stopped working today and i changed the batteries but it still doesnt work. Is there a fuse that might cause this?

may have to re-program your keyless entry. depending on what make and model car you have you should be able to find out how by going to the internet.

is the chech engin light on

check the fuses in the truck. there is one that works the keyless entry sensor

you must reprogram your transmitters due to the fact that the memory in the module has been erased by the removal of power

check all the fuses inside the car. the new battery could have surged and blew a fuse which would cause the key less entry sensor in the car to stop.

my keyless entry does not work and i change my battery for both the remote is there another battery or fuse

sometimes you have to hold the lock and unlock at the same time and stand close to your jeep until the locks unlock and lock agian if that works then they are reset if not than try to change the batterys in one remote and retry

You might try Opening the Door and Opening the Hood and Disconnecting the Battery. This should reset the System. If this is the Factory Keyless Entry, There is a Relay and a Fuse for this. Check them and see if they are Bad or Blown.

if it was factory installed theres usually a fuse in the fuse panel whereever that may be...replace the fuse with the same voltage as the other one says. but if the fuse isn't in the fuse panel its most likely under the hood, to the right...hope this helps. =)

Your keyless/security system may have been damaged by the spikes. But, assuming you've already checked all the fuses, I would start by having the alternator tested. I would also check the alternator wire connection to the power distribution center (pdc). It can loosen and cause different problems.

Good Luck!