Question about 1994 Isuzu Rodeo

1 Answer

TRANSMISSIONS TRANSMISSION LOST ALL FORWARD GEARS. I RECENTLY REPLACED THE ENGINE. THE TRUCK WAS RUNNING GREAT AND THEN SLOWLY THE FORWARD GEARS STARTED TO SLIP.I HAVE TALKED TO A FEW DIFFERENT PLACES AND TWO OUT OF 7 ARE DIRECTING ME LOOK AT THE ELECTRICIAL SOLENOIDS BEFORE REPLACING THE COMPLETE TRANNY.I DON'T KNOW WERE THE SOLENOIDS ARE LOCATED. PLEASE HELP.I AM BEING QUOTED 1500.00 TO 2000.00 FOR REPAIR. mcanelly62@yahoo.com Margie

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 625 Answers

Most of the times you should be hable to see the solenoides by removing the bottom oil pan on the trans, some are harder to find but remove the oil pan and see if you have acces to the solenoids, the are hook up with electric wires

Posted on Jul 20, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

V70 poured new Dex3 auto trans in. Reverse gear stops working after a few days equal 500km, but all forward are still ok.


Sounds like your transmission is going bad. If your transmission is slipping only in drive or forward gears, then it could be just that it is low on fluid, but when reverse starts to slip it usually means rebuild/replace transmission.

Good luck

Dec 02, 2013 | Cars & Trucks

1 Answer

Ford e-250 transmission problems


My Econoline 250 with 4.2 lost fluid from hose leak, fixed leak everything was normal for 3 days till I drove it on highway. When it went into overdrive lost forward power. Turned off OD and did ok for a while. Lost forward gears slowly, put in fluid, hard to tell when full. Reverse is fine but have to rev up engine to get forward to engage, then everything is fine at lights and such till take out of drive, then have to rev engine to about 2500rpm to engage drive. Help?

Nov 05, 2013 | 1990 Ford F250

2 Answers

In gear but wont move


what engine/ there are many.
since you dont know, i must guess.
here goes, in generic form
1: is it the engine power lost or transmission failure
if you dont know, ask any mech to tell you, in 1second flat.
2:lost engine power (guess2)
a: lost electical power 12vdc to critical EFI parts.
b: lost compresson.
c: lost or weak spark no bad timing spark.
d: bad fueling.

that list works for all modern cars. if tranny is a M/T say so. now.

Oct 15, 2013 | Toyota Corolla Cars & Trucks

1 Answer

Transmision wont go into gear no drive indicator


Did you replace the lost transmission fluid and rechecked the oil level after starting. Secondly if the torque converter moved forward without you knowing it, the converter may not be properly connected to the front pump and it won't be working Lastly ensure that all electrical wiring connectors are properly connected and not loose.

Apr 01, 2013 | 1997 Toyota Camry

1 Answer

Replaced 2 3 sol in trans goes forward in all gears


Transmission gear assembly and transmission needs inspection. Also check the transmission fluid level. Also is the fluid getting leaked or its low.


There are few very helpful links with solutions to troubleshoot this problem.


========

I suggest you to refer these links.


Click the link below:-----


2000 Toyota Camry: Transmission slipping and Stuck up?

http://whatisbyme.blogspot.in/2012/05/2000-toyota-camry-transmission-slipping.html

-----------

Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

----------

Car engine Overheats and transmission starts slipping?

http://schematicsdiagram.blogspot.com/2011/12/car-engine-overheats-and-transmission.html

-------------

2006 Ford Explorer: Engine Vibrates and gears slipping?

http://whatisbyme.blogspot.in/2012/06/2006ford-explorer-engine-vibrates-and.html

---------------

Clutch slipping problem?

http://howtobyme.blogspot.in/2012/03/clutch-slipping-problem.html

----------

Dodge Anti slip System is not operating?

http://whatisbyme.blogspot.in/2012/07/dodge-anti-slip-system-is-not-operating.html

----------

OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

------------

Transmission fluid leaks near radiator on ford windstar?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

-------------

Ford Windstar transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-----------

TRANSMISSION REPLACING AND TROUBLESHOOTING


http://alltypesofpartsreplacing.blogspot.com/2012/12/transmission-replacing-and.html

---------



These details will help.

Thanks.

Dec 07, 2012 | 2005 Pontiac Grand Am

2 Answers

1991 nissan maxima i press the gas when in gear and keeps revving up but will go forward slowly


Check the transmission for leaks and fluid level. And fix as needed. However, seems like your transmission is slipping.

Jun 27, 2012 | 1991 Nissan Maxima

1 Answer

1994 gmc sierra pickup 4.3L V6 automatic transmission experiencing difficulties with ODrive = 4th gear, and Drive = 3rd gear, engine revs up to the max properties with little to no forward motion. Rev


You have internal transmission damage I expect the clutches on third and fourth gear are wiped out. Its either that or a solenoid gone bad that holds those clutches pressure get it in a transmission shop soon to avoid whole transmission replacement costs.

Mar 19, 2012 | Cars & Trucks

1 Answer

Was pushing snow and heard aloud ping while in reverse and it quit pulling.all forward gears still work. sounded like a u-joint. believe me i no that sound.i drive it like i stoled it. lol.but thats what...


not sure if this is an automatic or manual transmission 1st (automatic)if all forward gears are still working what it sounds like is that the reverse drum in the transmission has come apart. which will eventually cause the forward gears to start to go if thats the case, the rapir for the reverse drum is internal the transmission will need to be rebuilt. you can just put a reverse drum, but my opinion is there will be more damage and while its out might as well rebuild the entire transmission. you didnt mention if it was 4 wd or not and only rarely have i seen a transfer case cause the same issue, once most recently in a f150 with a manual transmission i was working on the chain stretched so bad it lost reverse but had all forward gears. 2nd (manual) could have lost the reverse synchronizer whic again the trans will need to be repaired either with just a syncro or complete rebuild. hope this helps

Feb 04, 2011 | 1999 Chevrolet 3500

1 Answer

Hi i have a 2000 ford super duty i was plowing snow today and it started slipping in forward gears but revers worked fine then i shut it off and let it set for 4 hours and then we started it and it drove...


Not likely. Chances are that while plowing snow, you overheated the transmission, causing the forward clutches to slip. Regardless, you should prepare to replace or rebuild it, keeping in mind that if it is going to be severe duty, such as snowplowing, you will want to add a transmission cooler as well as beefing up your internals. If it slipped once, it will surely do it again, until you lose all forward gears. It will still work great in reverse, in most cases.

Jan 19, 2011 | Ford F-250 Cars & Trucks

Not finding what you are looking for?
1994 Isuzu Rodeo Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...