Question about 2002 Chevrolet Avalanche

1 Answer

Windows won't go down!!!

Front right side window will not go down..... When tying all i hear is a clicking sound. Would like to replace the motor but don't know how to get the door cover off. HELP IT'S HOT IN ATLANTA GA

Posted by on

  • donaven Jan 02, 2009

    My driver side window sounded like it had sand in there, then it decided to go up and down at a really slow speed and now the window wont do anything. Its partially open still. One rear window is out too. The other two are starting to go up and down very slowly now too. This is a problem I've read about alot and they need to fix this problem. No drive-up tellers, drive thrus for the kids etc... If I get pulled over I cant even roll my window down! Its hot here too!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 334 Answers

The door panel is held on with snap in plastic plugs. just use a screw driver and pop the plugs out by prying on the door panel. Then just unplug all wires going to it.Its a pretty good job so be prepared. But your right it is the window motor. That clicking is the relay.
God Bless Greg

Posted on Dec 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Left rear window went down and won't go up


Posted this earlier...similar problem..


First do you hear it trying to work, is it like a "clack, clack, clack" sound? or you hear the motor running smoothly? You will need to remove the door panel and take a look behind the plastic water seal to see whats going on, it is either going to be the regulator ( part the motor is attached to...cable broke)/damaged or more likely the nylon bushings inside the motor itself, they run like 10 bucks on Amazon. If you take the motor out of the regulator assembly be careful not to let the cable system come apart/unwind( use nylon ties while motor is out to hold in place). The motor itself is straight forward open/replace worn/falling apart nylon bushings/relube/reassemble. The tricky part is not screwing up the regulator assembly...depends on your skills.

Mar 18, 2013 | 1999 Mercury Mountaineer

1 Answer

1996 nissan pathfinder driver side window won't go up and down


does it click or grind when pushing window button if so the window lift track may need replaced, if there are no sounds then disconnect the wires from the lift motor and with the ignition on so power is sent to switch, push button and check wires to 12 volts dc. If no power I would replace the driver side switch after checking the wires for defects. If there is power then I would re-install wires to motor after turning off key and try button again with power on. replace motor if it doesn't work.

Dec 31, 2011 | 1996 Nissan Pathfinder

1 Answer

Front passenger side window won't go up or down .... I can hear the window motor though


The cable is broken. And unfortunately the motor track and cable is probably one whole assembly. So you need to replace it all as it is one unit.

Jul 03, 2011 | 2003 Cadillac Deville

1 Answer

Two weeks ago the drivers side rear wind stoped operating and is in the up position. All other windows were working ok. Yesterday the passanger side rear window stoped operating. Fuses are ok and I hear...


Not really i think your right, it sounds like both motors went bad a quick little test i always do is hold switch down and bang on the inside of the door at lower front of door and sometimes it shakes motor and it starts working then i know for sure its a motor, this save cuatomers money , they dont pay to remove panel and testing,try it . hope this helps.

Aug 29, 2010 | 2006 Lexus Es 330

1 Answer

Just installed new rotors,brake pads, bearings and tie rods to front of 2000 montana. have a whopping sound when driving , this goes away when wheels turned slightly right. when turning right corner hear a...


One of your CV joints are bad, inspect which CV joint needs to be replaced. Roll your windows down and make tight right and left corners in an empty parking lot slowly and listen for the clicking noise. If it's coming from the passenger side window or the drivers side window, which ever side the noise is coming from is the side that the CV joint has failed and will need to be replaced.
Thank you for using FIxya and replacing the front wheel bearing improperly buy hammering the CV joint out instead of using a wheel bearing puller will cause damage to the CV joint as to what you have described. Good luck and keep us posted.

Jul 20, 2010 | 2000 Pontiac Montana

2 Answers

Window help


Sounds like the gear drive in the small electric motor that moves the window up and down has broken. You will need to replace the electric motor. You can't just buy the gear for it unfortunately.

Aug 30, 2009 | 1995 Ford Explorer

2 Answers

2000 Ford expedition window problem


Sounds like you need a window motor. Try hitting in center of door trim panel to see if you can get it to work if so replace motor.

Jul 05, 2009 | Ford Expedition Cars & Trucks

3 Answers

2000 GMC Jimmy SLE driver's power window


The same thing happened to my 1999 JMC Jimmy recently. I believe the problem is that your power window motor has most likely gone out or is starting to go out. The motor will need replaced. They are pretty expensive new. I went to a junkyard and got one for around 15 dollars. When mine went bad, I had rolled my window down about three or four inches and it stuck there. I took my door panel off and tapped on the motor while holding up on the window switch and got it to go up after a few minutes. I am replacing my motor today, I'll leave an update here about the outcome when I finish the job. I hope this information helps you.

Sep 27, 2008 | 2000 GMC Jimmy

Not finding what you are looking for?
2002 Chevrolet Avalanche Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...