Question about 1997 Chevrolet Lumina

1 Answer

We are having trouble locating the low-pressure gauge.

We are trying to check the refridgerant in our 97 Chevy Lumina. We cannot locate the low-pressure gauge. Where is it?

Posted by on

1 Answer

Located at bottom rear of battery.

Posted on Jul 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 Chevy blazer how do I get out of safe mode ran low on oil now runs an drives but won't let car go fast past 2000rpms


The computing system on your vehicle has no safe mode for running low on oil . The only thing that will happen is the check gauges light will come on.
The oil pressure gauge is an analog device that is located in the IPC. The oil pressure gauge is operated directly by the oil pressure sensor circuit. As the engine oil pressure changes, the resistance of the sensor and the current flow in the oil pressure gauge changes. The current flow in the oil pressure gauge causes the needle to move in order to appropriately display the engine oil pressure. A sensor resistance of 1ohms will display as 0 kPa (0 PSI) and a resistance of 88 ohms will display as 80 kPa (80 PSI ). The IPC also monitors the oil pressure sensor circuit and interprets the current flow in this circuit in order to determine when the engine oil pressure is too low. If the oil pressure is too low, the check gauges tell tale will turn on. The oil pressure sender is located on the left side of the 2.2L. The 4.3L engine, oil pressure sender is located at the top left side, near the distributor/high voltage switch.
Try disconnecting the battery cables an hold them together for ten minutes , reset ECM !

Nov 08, 2015 | Cars & Trucks

1 Answer

I have a 97 Chevy lumina that backfires and stalls when I accelerate.what is causing it.its 3.1 v6


I'd want to check proper fuel pressure? How long since a tune-up? Can you check applicable trouble codes?

Sep 14, 2014 | 1997 Chevrolet Lumina

1 Answer

97 Lumina cutting back


Have you checked base fuel pressure with a gauge ?

Jul 01, 2013 | 1997 Chevrolet Lumina

1 Answer

Where is the flasher located on a 97 chevy lumina sedan


Try looking up under the dash just above the brake pedal. If you still can't find it turn on the 4 ways because turn signal and 4 ways use the same flasher on that model. You should be able to hear it clicking. Good luck.

Feb 03, 2013 | Chevrolet Cars & Trucks

1 Answer

1992 chevy lumina euro 3.1 while driving the engine acts like it is going to die then it regains power and then repeats the sluggish, lack of fuel .


check fuel pressure most likely bad fuel pump. also check your oil sending unit or gauge. chevys run the fuel relay to the oil pressure switch in case the oil is so low the car wont start. sometimes the relay in between this circuit goes bad as well. if all is well check or replace the ignition module (located directly under coils) or distributor integrated if it has a distributor

Mar 14, 2011 | 1992 Chevrolet Lumina

2 Answers

Where is the starter located in the 1991 Chevy Lumina APV ??


97de1d4.gif


REMOVAL AND INSTALLATION
3.1L Engine
Besides regular hand tools, a special oil pressure sensor socket will be necessary to complete this operation.

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
  3. Remove the A/C compressor brace (if equipped).
  4. Extract the wiring harness from the retainer and position it out of the way.
  5. Remove the cover from the starter wiring.
  6. Remove the outer nut and disengage the wiring from the starter solenoid.
  7. Disconnect the electrical connector from the oil pressure gauge sensor.
  8. Using the special socket, remove the oil pressure gauge sensor.
  9. Unbolt the starter from the engine. Retain any shims.

To install:
  1. Install the starter to the engine, reuse any shims that were removed. Tighten to 32 ft. lbs. (43 Nm).
  2. Connect the wiring to the solenoid and install the outer nut.
  3. Place the cover over the starter wiring.
  4. Replace the oil pressure gauge sensor using the special socket.
  5. Plug the electrical connector onto the sensor.
  6. Mount the harness to the retainer.
  7. Install the A/C compressor brace (if equipped).
  8. Lower the vehicle.
  9. Connect the negative battery cable.

Oct 08, 2010 | 1991 Chevrolet Lumina Apv

1 Answer

Where do i put r134 in my 1999 chevy luminia


You have to locate the Low Pressure line for your AC and connect the refill hose and gauge to that. It will have, in most cases, a black or blue dust cover cap made of plastic on it. The refill kit will only fit the low pressure side as these connectors are different in size.

Jul 20, 2010 | 1999 Chevrolet Lumina

1 Answer

1990 chevy lumina 3.1 ltr runs for 5 mins, then guits, codes 32 & 43 says 02 sensor, check circuit fuse a relay could be defective, and check circuit wiring, Where is the fuse for the 02 sensor located...


I would check back pressure to Catalytic converter. Sounds like it could be plugged off. You have to plumb a gauge ahead of the converter and check the back pressure.

Sep 14, 2009 | 1990 Chevrolet Lumina

1 Answer

I need to locate the low pressure port for charging the a/c unit on my 1998 chevy lumina sedan


find your inlet/outlet evaporator lines and follow the one going to the compressor. that is your low side

Jun 25, 2009 | 1999 Chevrolet Lumina

3 Answers

97 Chevy Lumina Completly Stops while driving


When it stops, does it have spark? (crank sensor)

Apr 10, 2009 | 1997 Chevrolet Lumina

Not finding what you are looking for?
1997 Chevrolet Lumina Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...