Question about 1999 Chevrolet Lumina

1 Answer

Intake casket how do i know it has leaked too much

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 58 Answers

Hello again , could you tell me the amount of leaking.

Posted on Jun 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a water leak. the hoses all seem good as does the "weep hole" on the water pump. The oil and trans fluid look normal and the car runs fine. The only thing I see is below the alternator...


Not all water pumps leak from the weep hole, if the water pump casket becomes worn then it will leak from behind the water pump. You can also have a leak coming from the thermastat housing. To find out exactly have a pressure test performed on your car.

Feb 28, 2011 | 2002 Chevrolet Impala

1 Answer

I have 2007 MALIBU SS I'm losing antifreeze somewhere could it be an intake casket


yes it could be if its a 3.1 or bigger. check to see if oil is getting in coolant tank, check very close at the intake gasket also the head gasket for leaks. and check bottom of water pump when running. if they fail it will drip from bottom at relief hole. my 3.1 had the sam problem and i replaced the intake gasket. and it has been fine now for about 2 years. just check it out.

Jan 12, 2011 | 2007 Chevrolet Malibu SS Sedan New Cars

2 Answers

Trying to put thermostate in casket wont fit


You need to put the edge of the thermostat into the slot in the gasket. There will be a "cut" on the inside edge of the gasket and you have to thread it on before you put it in the car.

Jan 03, 2011 | 2005 Chrysler Town & Country

2 Answers

My Chevy Malibu 1997 has a major problem with leaking in the coolant system. The coolant light comes on and stays on. We put prestone in the recovery system until its filled. The coolant light continue...


I'm guessing that the mechanic fixed a coolant leak around the gasket on the upper air plenum. The gasket leak was probably caused by Dexcool antifreeze deteriorating the gasket material. If that is the case, then the lower intake gasket is probably leaking too. If the mechanic refilled the cooling sysytem with DExcool antifreeze, then it probably destroyed the sealant he used to make the initial repair. I would have the car towed back to the mechanic to avoid any further damage from overheating. Have the mechanic remove the lower intake and check the gasket for leaks. DO NOT refill the cooling system with Dexcool. Use a compatible antifreeze that will work with aluminum engine parts.

Dec 18, 2010 | 1997 Chevrolet Malibu

1 Answer

Water leak, trying to figure out if it is head or intake manifold casket. There is a flat ridge under the intake manifold and it has antifreeze on it and it is above the head casket, I was thinking this...


Without checking the head with a pressure test anything is possible. do a compression check on the cylinders and see if you have high compression on a cylinder. If the head is cracked it will let water into the cylinder and cause high pressure. This is still true with a broken intake manifold gasket as well though depending where it is broken. It is possible that what you are seeing is blow back from the radiator over flow. You don't see any leaks when your stationary but if you drive it and then stop and check it you see the fluid. This could be a result of blow back from a loose radiator cap or bad over flow hose.

Jul 22, 2010 | 2000 Pontiac Firebird

1 Answer

Put new front head casket & spark plugs & wires runs like ****


Are you sure you have plug wires on correctly? Better double check them.

Sep 11, 2009 | 1993 Dodge Caravan

1 Answer

Question


This is just a patch to get you home. Fix the car and the problem that made it run hot to cause this gasket to leak. See a funeral home about any casket problems.

May 03, 2009 | 1993 Cadillac DeVille

1 Answer

Leaking intake casket 1999 lumina 3


hello again could you tell me the amount of leaking.

Jun 26, 2008 | 1999 Chevrolet Lumina

1 Answer

Manifold intake casket leaking 31


thanks for asking , sure they are right , but be sure that it didn't leak to much , and if you have any problem there is one thing to do .... just ask fixya , and i hope a wonderful day for you , thanks for using fixya

Jun 26, 2008 | 1999 Chevrolet Lumina

Not finding what you are looking for?
1999 Chevrolet Lumina Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...