Question about 2007 Dodge Ram Truck

1 Answer

Diagostic I had a diagostic test and no codes, but my idle is very low 700s when it's just sitting in park and it is low in each gear. I took it in and the car place said it is an intermitten problem, but never really investigated. The car place where I bought the car said that it's a small engine and a very under powered car which COULD be the problem, and that you can only change the idle speed now days by computer and that is very pricy. Any suggestions? Anyone with the same probs? if so what did you do?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 375 Answers

Take it and check in some small shops. It cost me $20 to get one.

Posted on Jun 26, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No heat coming from the vents.

If it is a manual system--sounds like coolant low ie: air bubble in system. If it is ATC system, Check Codes, if no failure codes, coolant may be low--air bubble in system--most Durango's have air bleeders in system.

Jan 18, 2015 | 1998 Dodge Durango

1 Answer

Idle drops way down in drive gear in park it's fine or running the A/C

what car is this, could be normal or not depending, like my 73 nova dogs down when put in gear but its suppose to with a 3 speed turbo. if its a newer car its not. and would sudject checking transmission fluid/filter or even replace both. if your fuild is low or old the transmission wont slip as easy and will make you car work harder to idel while sitting still.

Jun 08, 2012 | 2004 Dodge Neon

1 Answer

1990 Range Rover will not go into gear

Check the fluid level while idling in park. Low fluid pressure due to low fluid can cause this.

Nov 20, 2017 | 1990 Land Rover Range Rover

1 Answer

I just got done replacing the power steering motor on my 2003 GMC Seirra 1500, After I got done bleeding the lines i took it out for a test drive but everytime i put it in gear it idles down extremely low...

If you disconnected the battery,the computer needs to relearn the idle profile. This may take a bit of driving.Also,make sure the air intake piping is properly secured to the throttle body and Mass airflow sensor at the filter housing and not allowing the engine to **** in any false air past the MAF

Sep 06, 2011 | 2003 GMC Sierra 1500

1 Answer

I want to adjust the idle on a 2003 ford f150

The engine Idle is adjusted by the PCM (power control module) If your having idle problem, cleaned the throttle body real good (just to make sure there wasn't a problem there) then do a "IAC relearn" by unhooking the battery, letting it sit for about 5 minutes, then hooked battery back up, let it idle for 3 mins, put in gear and held it there for 3 mins, and then neutral for 3 mins, then back into park. Go for a test drive and this should fix the problem.

When its warmed up, in park or in gear, RPMs are about 600-650 at warm idle. At cold its about 850 or so, Good luck and thank you for using Fixya

Mar 19, 2010 | 2003 Ford F150 Regular Cab

2 Answers

Idled high, replace IAC and PCV, now idles low and stalls

May be a defective IAC, or bad connection, or improperly installed, as in lost little "O" ring when putting it on. I would also be looking at TP sensor, which I would have tested in the first place. Have you tried cycling your key to retrieve problem codes yourself? ( turn key to on,(not start) then off, then on, then off, then on again, and leave on, and count flashes of check engine light. It will flash quick, then pause, then flash again. For example: 3 flashes, pause, then 3 more is code 33. 2 flashes, pause, 5 more, is code 25. When you get 5, pause 5 more, that code 55, which means end of message. Write them down, and get back to us with what you have if any.

Nov 18, 2009 | 1989 Dodge Shadow

1 Answer

Idled high, replace IAC and PCV, now idles low and stalls

On modern day cars the parts that get fitted need to be adapted to the ECM using a decent diagnostic machine. I bet that this was not done and the car is now suffering as a result.
Something to try is resetting the ECU, simply disconnect battery for 10 minutes, reconnect, then start car from cold *without touching gas pedal* and leave idling until the rad fan comes on (this resets all the base idle settings) then take it for a drive - hopefully will solve the problem

Nov 18, 2009 | 1990 Dodge Caravan

1 Answer

Rough idle then stalls

Vacume leak or bad idle motor. With the car in park and running with the hood open listen for leaks moving your hand around the different hoses looking for a change in the sounds that you hear. The idel motor also makes the car idel up to 1500 RPM or so right at start-up then idel down, If it doesn;t the idel motor is likly. Check engine light is on when running? Test for codes, Follow code test charts don't skip any steps!.

Nov 02, 2009 | 1998 Chevrolet Malibu

1 Answer

Rough low idle in gear when stopped at a light.

probable vacuum leak query brake booster

Jul 26, 2009 | 2001 Dodge Neon

Not finding what you are looking for?
2007 Dodge Ram Truck Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides