Question about 1990 Mazda MX-5

1 Answer

Enous roadster feels like it is running flat and will not pull away at low rev,s

Posted by on

1 Answer

Is your air filter blocked????

Posted on Aug 25, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My car wont start when cold outside could this be the problem of a failing fuel pump

More likely the battery, try starting the car with no electrics running (interior light, fans, wipers etc.) when it fires rev it up a few times and let it idle for a bit before pulling away if it runs fine after this you can use you electrics as normal . if its an auto pull away slowly if its a manual pull away with more revs than normal but very slowly engage the clutch.

Dec 29, 2015 | Cars & Trucks

1 Answer

Van has no power at low revs only

Most ignition modules have two parts -- a low speed section and a high speed section. Your low rev section could be bad. Most parts stores will test it free.

Apr 08, 2015 | Cars & Trucks

1 Answer

The oil pressure is low at idle and rises with higher engine revs. Oil levels are ok, new oil approx 2000kms ago. Was a slight noise at one stage in the engine but went away after engine's revs in

It sounds as if the clearance that the bearings normally run in have been surpassed and need to be replaced. Higher engine revs will supply extra oil which will overcome any small discrepencies but constant running at this stage will result in faster degradation of all engine components concerned resulting in a more expensive repair. Shes basically worn out.

Feb 27, 2012 | 1993 Toyota Land Cruiser

1 Answer

No power on hills or flat.revs up high rpm before shifting.errattic shifting

First check the level of fluid in your transmission, if its an automatic , there will be a dipstick on top of transmission and there is a line on dipstick when its warm running usually in neutral.( will say on dipstick if you run vehicle in neutral or in park), if car is a standard, theres a plug on side of trans. usually have to do this under vehicle. pull plug with car level and put finger in hole and if you cant feel fluid on finger its low. also in automatics if fluid is dark and not clear or bright red and stinks (with a burnt smell ) its usually means you have transmission problems. if fluid is low you have a leak and if went to long low on fluid chances are transmission is bad.

Feb 11, 2011 | 1993 Toyota Camry V6

1 Answer

Remault laguna 1.8 16valve runs but when pulling away and driving in low revs feels like its running on 3 cylinders?? but over 2.500 revs runs ok?? ive changed,plugs,coils,choke?? any ideas

get it running m8 pull plug leads of one at a time with a pair of (rubber grip) plyers to stop u from getting a shock, might be worth loosening first this will tell you what cylinder your missfire is in check plug gap and resistence in ht lead if this isnt the problem u need the valve clearence checking for more info email me at i will be happy to help u check the valve clearence!

Jan 05, 2010 | 2000 Renault 181

1 Answer

Just started to pull away from a stop in 1st and

sounds as though your input shaft broke, this would cause a loud clunk, cause it to feel as though in gear, and cause no pull.

Oct 26, 2009 | 1988 Nissan Maxima

1 Answer

Ford focus slow at take off

clutch slipping change the clutch

Jun 10, 2009 | 2002 Ford SVT Focus

Not finding what you are looking for?
1990 Mazda MX-5 Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

71694 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7031 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides