Question about 1992 Nissan Stanza

1 Answer

Engine?? Recently the timing chain broke damaging the head gasket and motor. Im having major problems trying to locate a GOOD and reliable motor for the car. Do anyone have suggestions on where i could go to find one??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Need torque schematics for heads on 92 Nissan Stanza

Posted on Jul 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I accidently drove my 20003 dodge Durango in 2nd gear,it over heated and wont start,timing chain?


overheated motors damage the rings and bore of the engine
it will blow head gaskets and warp/ crack heads
very rarely will it damage the timing chain
run a compression test first and it is possible that there is valve damage ( burnt valves )

Aug 08, 2015 | Dodge Durango Cars & Trucks

1 Answer

I've had the left rear head rebuilt on a 03 Nissan maxima 3.5 liter, but did not set the number one piston at top dead center prior to the installation of the new head gasket and rebuilt head.now the...


Yes, you could of damaged a valve by rotating then engine or the cam. Now this only applies if it's a non clearance engine.. now what you might have done is rotated the cam out of timing while doing whatever it is you were trying to do. SO you might have to dis-assemble the timing chain/gears to try and reset everything

Nov 02, 2014 | Cars & Trucks

2 Answers

My suv just died while driving no noise did not overheat would not turn over changed the alternator the stater battery was good tried to manually turn it over would not move oil was full water was ful


drain the oil pan and look for piece of metal. could be head gasket or engine block defect or blown engine.
make a few check remove belt and try to turn crankshaft with Tools if not remove engine oil pan you will see the damage

hope it helps

Oct 16, 2014 | 2001 GMC Jimmy

1 Answer

While driving my 2001 Grand Am 2.2 Echo engine the timing chain broke. Does this mean my valves are bent?


The only way to tell is to pull it apart and inspect the head and valves to see what damage was done, sometimes no damage,sometimes major damage.

Jun 06, 2012 | 2001 Pontiac Grand Am SE

1 Answer

I have been advsed that I have a broken timing belt or "jumped timing chain.Besides the belt/chain, what other components do you recommend replacing(Gasket/seal,cam and crank pulleys,tensioners)?


I am assuming you have the 2.2L 4 cylinder engine. The timing chain tensioner on these engines is nororious for failure resulting in jumped timing. Be advised that depending upon the situation, you may have sustained major engine damage. If the timing simply jumped when turning the engine off, you may be safe, but if it occurred at highway speed, there is a high probability that there is valve damage in the engine that will need repair before you can move on to the timing chain and tensioner. As far as "other components", if your know that the head is ok, then you should replace the timing gears, chain, and tensioner. Also purchase a "timing gasket set" which will give you the gaskets ans seals you need to do the job.

Jun 24, 2011 | 1997 Chevrolet Cavalier

1 Answer

Timing chain broke on my 96 cavalier 2.2 ohv. Replaced the chain and tensioner but now the car runs rough necause of a miss n the car. The motor had to be hoisted up in order to change the timing chain im...


If the chain broke while the engine was running, and I presume it did, it is possible that you may have damaged the valves. When the chain breaks the cam shaft stops moving and the valves stay in their last position. The pistons continue to move until the engine comes to a stop. An open valve can be hit by a piston, sometimes breaking the valve or just bending the shaft. Also you have to be sure the new chain has the cam shaft and crank shaft properly timed. As I understand that that engine does not have timing marks on the chain sprockets. To test for damaged valves, remove the spark plugs and test the compression in each cylinder by cranking the engine while holding the compression gage in the spark plug hole. All the cylinder should have the same pressure within about 15 psi. A cylinder with damaged valves will not have any compression pressure. If you are unsure about the valve timing check into how that engine is timed. I don't have that information but if is out of time it has a very major effect on the engine performance and idle. I hope this gives you a place to start looking for the cause of the mis. Good luck.

Thanks for using FixYa.

Gaker

Jun 22, 2011 | 1996 Chevrolet Cavalier

3 Answers

CAR STALLED. DISCOVERED TIMING BELT HAD BROKEN. REPLACED BELT. STILL WILL NOT START BUT WILL TURN OVER


It sounds like the timing is still off, which will not allow it to start, or you have a faulty cam, or crank sensor.

Apr 14, 2011 | 1993 Volvo 850

3 Answers

84 s15 2.8l misfire, popping carb, and gas and coolant in oil


Wow, sounds like head gasket &/or timing problem. First thing you need to do is a pressure test on cooling system to see if head gasket gone, then I'd do a compression test as well. Have you pulled any spark plugs to see what they look like?

Aug 03, 2009 | 1985 Chevrolet S-10

1 Answer

1999 olds alero timing belt


2.4L engine dont have timing belt.it has a timing chain.fixing timing chain dont cost much.but the damage that occur when it broke.you probably got bent valves.damage piston heads.you can buy car if they dont charge arm and leg.you can repair timing chain your self for at least .$300.00.you have to buy timing chain.it come in a set.you get timing gears and tensioners.about.$190.00 and .$40.00 for timing cover gasket and seal.dealership going to charge you at least.$600.00 including labor.

Jun 25, 2009 | 1999 Oldsmobile Alero

Not finding what you are looking for?
1992 Nissan Stanza Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

66433 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...