- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1983 Chevrolet S10 Pickup Truck Car Radio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Orange Car Radio Accessory Switched 12v+ Wire: Yellow Car Radio Ground Wire: Black Car Radio Illumination Wire: Gray Car Stereo Dimmer Wire: Brown Car Stereo Antenna Trigger Wire: N/A Car Stereo Amp Trigger Wire: N/A Car Stereo Amplifier Location: N/A Car Audio Front Speakers Size: 4? x 6? Car Audio Front Speakers Location: Dash Left Front Speaker Positive Wire (+): Tan Left Front Speaker Negative Wire (-): Gray Right Front Speaker Positive Wire (+): Light Green Right Front Speaker Negative Wire (-): Dark Green Car Audio Rear Speakers Size: 4? x 10? Car Audio Rear Speakers Location: Rear Corners Left Rear Speaker Positive Wire (+): Brown Left Rear Speaker Negative Wire (-): Yellow Right Rear Speaker Positive Wire (+): Dark Blue Right Rear Speaker Negative Wire (-): Light Blue
Yes,an ohmeter across the two power leads(pimary) should yeild a fairly low resistance I'm not sure on the specs but it is just a winding so maybe 10 ohms,then test the secodary winding with one lead to either power lead and one lead to the high voltage post(the coil wire connection),should read about 10k ohms,you can go to autozone.com and register and they have a repair guide that should have the test specs.
mine is a 1990, beleive it or not, it hooks to the negative side of your coil under the hood facing the front of your truck it will be on the right hand side, (black is ground and red is hot for the light)
First disconnect the positive battery cable. You already have the bolts out. pull the starter back and down and it will drop out. do not let it hand from the wires. Disconnect the wires to the starter. Pay attention as to which wire comes off what terminal. They must be attached correctly or your starter will not crank after installation. Then the last thing you do will be to hook the battery up again.
As a RULE I NEVER replace Electronic parts with used parts, you dont know what you have in a used Spedo head. Possible that Magnetic pickup at transmission is good. A Problem like this on MY Personal Vehicle I would go with ALL New parts Including Wires.