Question about 2005 Honda Accord

2 Answers

Keyless remote my keyless remote control isnt working can you tell me what should i do

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Honda Master
  • 2,039 Answers

You tried a new battery or maybe its need to be reprogram call the dealer service deparment do that cheers pierre

Posted on Jun 26, 2008

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 4 Answers

You can try they have program instructions. If that doesnt work just buy a new remote, they are cheap if you buy them online. Cheers!

Posted on Dec 28, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the fuse for the keyless enerty pad

Keyless entry pad has not fuse ! Get's power from Body control module !

Aug 21, 2016 | Cars & Trucks

1 Answer

Keyless remote camry

Toyota is having problems.. Nothing surprises me

May 10, 2014 | 2013 Toyota Camry

1 Answer

2008 HHR Remote Starter not working

Is this an issue with all 2008 HHR remotes??? Highly doubtful , probably the vehicles keyless entry system . Taking the vehicle to a qualified repair shop an having the keyless entry system checked for DTC'S - diagnostic trouble code's . Do you know what a DTC is ?
The keyless entry system is a vehicle entry device. The keyless entry system is used in conjunction with the body control module (BCM) to remotely activate certain vehicle features. Keyless entry will lock/unlock the doors, or release the rear compartment lid when a corresponding button on the keyless entry transmitter is pressed. This is accomplished by the transmitter sending a radio frequency to the remote control door lock receiver (RCDLR). The RCDLR interprets the signal and activates the requested function via a serial data message to the BCM. A low transmitter or vehicle battery or radio frequency (RF) interference from aftermarket devices, such as 2-way radios, power inverters, computers, etc., may cause a system malfunction. High RF traffic areas may also cause interference that could lead to a malfunction. Keyless entry allows you to operate the following components:
• Door locks
• Liftgate lock
• Remote rear doors (Panel only)
• Vehicle locator/panic alarm
• Illuminated entry lamps
• Remote vehicle start
The keyless entry system has the following components:
• Keyless entry transmitters
• Keyless entry antenna
• 2 Way Advanced Remote Start RCDLR

Guessing will not fix this .

Jan 12, 2018 | 2006 Chevrolet HHR

1 Answer

The keyless remotes are not working at all and I have tried new batteries and they still are not working.

There is a web site for free that will tell you how to program you remotes.look up remote keyless entry replacement's

Aug 05, 2011 | 2006 Chevrolet Impala

1 Answer

How do i reprogram electronic door locks

Programming Electronic Door Lock Control System NOTE: The electronic door lock control processor (14B001) erases all previous keyless entry remote transmitter (15K601) from memory when the keyless entry remote transmitters are programmed or reprogrammed. The electronic door lock control processor can store up to four keyless entry remote transmitters in memory.

  • To program (or reprogram) keyless entry remote transmitter into the electronic door lock control processor, perform the following steps:
  1. Turn ignition switch to the RUN position and momentarily short the two terminals of the program connector taped to the wire assembly and located behind the glove compartment. All doors should lock and then unlock. Remove shorting pin.
  1. Press any button on keyless entry remote transmitter. All doors should lock and then unlock to verify the keyless entry remote transmitter has been programmed. If door locks do not respond, press button again (up to three times maximum with the same keyless entry remote transmitter).
  1. Repeat the above step to program additional keyless entry remote transmitters into the electronic door lock control processor (up to four keyless entry remote transmitters maximum).
  1. Turn ignition switch OFF. All doors should lock and then unlock.
  1. Check operation.

Jun 05, 2010 | 1997 Ford Windstar

1 Answer

Remote key fob does not unlock or lock car

It may just be a battery problem. Replace the battery of your remote fob. If it will not work, try to reposition the controller beneath the dashboard.

May 27, 2009 | 2005 Suzuki Swift

2 Answers

Program factory remote keyless entry: 2003 Hyundai XG350

The procedures you list require the Hyundai Keyless Remote programming module, which you don't have. This module is proprietary - only Hyundai Dealerships have it. There is a 10 pin connector under the dash (next to the DLC - Data Link Connector) which is used to connect the Keyless Remote Programming Module. This module has two switch positions "Ready" and "SAVE". When the switch is place in the 'SAVE" position, that's when the keyless remotes are activated to send their 'codes' to the Electronic Time and Control System (ETACS). The module's switch is then set to "Ready" and the remote is tested to see if it works properly.

May 22, 2009 | Hyundai Motor 2003 XG350

1 Answer

How do I tell if my used car had a keyless remote

it would be quit a job to set your car up with a keyless remote.unless you found some one very very very good whit wire.but to tell you the truth i do not thik it hwate of time . it would cst a hole lot of money .hope i help you

Apr 09, 2009 | 1999 Honda Civic

1 Answer

Alarm goes off when key open the door

Dealer is correct that you have too replace the bcm, so i would tell you to call junk yard and get one. Cheap $ 50.00 put it in by yourself. Right hand side of the glove compartment. behind the fuse box with couple connectors on it, or have some person with knowledge to do it.

Apr 02, 2009 | 2003 Chevrolet Venture Passanger

1 Answer

03 Honda Civic LX keyless remotes . . .


Jun 27, 2008 | 2003 Honda Civic

Not finding what you are looking for?
2005 Honda Accord Logo

266 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides