I have had my 250 superduty for two years now, and have had to spray wd-40 into the latch hole evey oil change or so to keep the "door ajar" light out, or have the same problem as you. A little squirt around the latch mechanism and contacts and the light goes out.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
as for your door locks, your key fob may have been misprogrammed when you removed the battery. refer to owners manual to reset your locking options on your key fobs. as fot the door open light, try spraying a silicone based product into the inside door lock mechanisms. silicone spray is much better than wd 40.
You are going to need to check the power lock control moduel on the inside of the door panel. If the FOB appears to be working but the doors are not unlocking, you need to check this. I would also replace all fuses that control the locks. If both of these devices check out ok, you may need to replace your FOB. To check your power lock control moduel, manually lock and unlock your doors by pressing the lock button on the inside of the door. If it does not work, it is either the fuses or the power lock control moduel. If it works, your FOB has gone bad. Hope this helps! Please rate 4 thumbs up!
Right , here's your problem ,,, the door swiches are incorperated into the door locks and thats why your interior light does not come on, therefore the vehicle thinks the doors haven't opened, This will cause the alarm to recycle the door locking signal .
hello on the door locks not working could be a couple problems open the driver side door and were the door hinges are there is a small tube with wires in there that runs from the door into the side of the kick panel inside of the car these wires are your windowns locks and more now were the door open you will have to cut tube with a razr knife so you can see if any of the wires are broken now if there is no wires broken now the power door lock actuators inside the front right-and left door could be bad or the door look swiches this is not unlikey you can check this by removing the door panel you will see a rod or cable going from the door lock down the bottom of the door
now on the key not working that sounds like the door lock rods there that hooks to the lock on the inside of the door is off or one of the plastic clips that hold the rods has broken if it is not locking or unlocking your doors it is not unlikey for both sides to be broken you will have to remove the door panels to check
i would think the door is not recognised as being opened.if the interior or door light does not work when the door is opened its probally due to a faulty microswitch in the door lock mechanism,the whole lock mechanism will need to be replaced.