Question about 2004 Chevrolet Colorado

1 Answer

Colorado Drivers Side Door Window

My side glass won't go all the way up and as it goes up it goes at an angle.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,039 Answers

The window regulator broken you have to remove the inner door panel and change the regulator good luck pierre

Posted on Jun 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front left window not working


If the window still goes up and down via the passenger switch then the switch on the drivers door has gone bad and will need to be replaced. I don't believe that you can only replace the one switch so you are ultimately going to replace all four on the driver side door.

Mar 14, 2013 | 2004 Chevrolet Colorado

1 Answer

Window switch for drivers side window/ window won't move all the rest work window stuck about 3 inches open


The driver side window switch panel and the circuit needs a check including the fact that there is POWER to the panel - if in case the power cable harness has opened in the door hinges.
Now the rest of the windows seems to cut off as there is friction when the glass goes up which can be a glas channel friction or if the motor drive is fault and so cuts off on load. You need to remove and check for free movement of the window glass and also check for the load bearing on the winder to confirm. Check for +12 voltage without loss to all the windows for the drive.

Oct 11, 2011 | 2005 Kia Amanti

1 Answer

I need to attach the glass to the window track on the drivers side door?


there is a little plastic clip that goes in the hole on the door handle side of the glass on the top corner, put that clip in and push glass back into place

May 05, 2011 | 1997 Chevrolet Blazer

1 Answer

I have a 2003 volkswagen jetta. i need to remove the glass on the front drivers side and front passenger side doors and replace it with new glass.after i remove the door panel how do i do this?


The panels have 3 t20 torx screws on the bottom and one philips head near the mirror. Under pull handles there are 3 philips on the drivers and 2 philips on the passengers sides. Pull the panels from the bottom and lift the panels up. There are 2 black rubber plugs in each door, pop each plug out and the glass is held in place to the clips on each side with either a 10 mm bolt or t30 torx bolt. Move the glass to the point where you can see the bolts, loosen, but don't remove the bolts. Once loose, you can pull the glass loose. Once loose, lower the window a bit, angle the rear of the glass up and pull it out. The glass may be epoxied in place, as VW had a problem with windows coming loose. If so, try to pop the rubber in the clamp loose (above the bolts you see through the holes) and reinstall it with the window removed.

Dec 22, 2010 | 2003 Volkswagen Jetta TDI

1 Answer

2006 colorado drivers side will will not go up


i think ur haveing a problem with the drivers side window not going up i asume u have checked fuses so here is a trick that works some times.slam the door while pushing the button but to fix permanently it will probaly need the window motor replaced.hope this helps

Nov 13, 2010 | 2006 Chevrolet Colorado

1 Answer

How do you install the drivers side window in a 1994 Jeep Cherokee Sport? Already removed interior door panel, bottom window molding, and screw & washer from regulator, Can't understand how to get...


Most door glass slides in from the top **** in the door. Sometimes the window seal around the window frame may have to come out and can be re-installed after you secure the glass to the track. You may have to insert the glass at an odd angle to fit it thru. Be sure to have the door panel off so you can access the track screws(bolts) and make sure you do or don't have to bond it with adhisive. A great bonding agent for this is gorilla glue, tested and still working on my friends 93grand cherokee. Good luck.

Aug 31, 2010 | 1994 Jeep Cherokee

1 Answer

2005 Chevy Colorado drivers side window, and power locks


Check for door ajar switches not making contact.

Mar 08, 2010 | 2006 Chevrolet Colorado

Not finding what you are looking for?
2004 Chevrolet Colorado Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...