Question about 1994 Isuzu Pickup

1 Answer

Oil leaking oil is leaking out a tube that goes between eng. and motor mount below carburetor what is causing this ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,010 Answers

Most likely the valve cover gasket is leaking. this is best case scenario. a fairly easy and inexpensive fix.

most other oil leaks are difficult to fix and very expensive.

-------------

edit.
you can get the gasket at a renault dealership. an auto parts store might have one, or can order you one. in the USA, there are very few renaults, so, most auto parts places would not stock parts for them. there is no demand.

Posted on Jun 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The engine is going through a quart of oil in a week?


i would think if the motor is too hot it would cause leakage

Mar 02, 2014 | Cars & Trucks

1 Answer

I have a 1994 S-10 pickup, V-6, auto-trans, 2WD. Have worn out 2 sets of oem motor mounts. Is there a better motor mount to use?


I'd try using an aftermarket urethane mount (check Summit Racing).... Urethane mounts will put up with much more of a beating than do stock mounts. I'd also take a look at the trans mount. If the trans mount is bad, it will cause excessive movement that will kill the engine mounts rather quickly.
If using stock mounts, make sure there isn't any oil leaking on them. Oil will soften the rubber and cause it to fail as well.

Feb 20, 2011 | 1998 Chevrolet S-10 Pickup

2 Answers

351 runs rough in drive - acts like a vacuum leak but cant find it. I put new plugs , wires , dist. cap and rotor , fuel filter. How can I fix this? I've had it to 3 mechanics and they give up but they're...


spray carb and choke cleaner around intake gasket area motor rpms will raise if leak is present, will also react on vacuum lines in the same way.

Jan 30, 2011 | 2004 Ford F150

2 Answers

2006 Toyota Corolla, every morning there is squeaky sound when I start the car. Later, it goes away. It is for the past six months. Is it serpentine belt causing this sound, if so how I can loose...


The problem is the rear motor mount is filled with hydraulic fluid that leaks onto the accessory drive belt. The motor mounts fail prematurely and the fluid makes the belt squeak. Toyota dealership I took my 2006 Corolla to replaced the motor mount and belt free of charge.

Nov 24, 2010 | 2006 Toyota Corolla

1 Answer

98 breeze Just bought it and on the way home it started staling out there was a clicking noise and the rpm gauge jumped around all the way into the red line without the engine reving at all then it...


no think about this for a min. noise coming from eng. large oil leak, eng. dies. do yourself a favor Breeze it back to the dealer. you might have blown you motor

Sep 12, 2010 | 1998 Plymouth Breeze

2 Answers

Oil pressure warning light comes on when slowing to a stop. Goes off when you accelerate.


either your eng. oil pump is failing or just so low on oil that the pick up tube cant pick any oil up, check eng oil level first, if level is ok....then your oil pump is definitely failing

Apr 06, 2010 | 2008 Chrysler Town & Country

2 Answers

How do you remove starter?


disconnect neg batt cable. as required remove nuts from a/c compressor and eng brace, adjacent to starter, if neessary. remove nut from eng cross brace. using a pry bar between upper eng mount and eng pry rerward and support eng.if nessary remove oil filter, air induction tube and cooling fan. Disconnect wiring at starter, and (note!!!!)position. good luck

Jun 25, 2009 | 1993 Chevrolet Lumina APV

1 Answer

Oil leaking from left side of 6 cylinder 250 chevy c10


Make sure your valve cover is tight. They are known to come loose. Ckeck oil filter tightness and be sure when you change oil the old gasket of filter does not stick to bkock.This will cause an improper seal.

Apr 09, 2009 | 1983 Chevrolet Blazer

3 Answers

GM truck vortec Eng oil pressure low with high engine noise


CHECK THE OIL PUMP SUMP TUBE O-RING. THEY COLLAPSE CAUSING THE OIL PUMP TO PULL AIR INSTEAD OF OIL. TO VERIFY OVER FILL ENGINE OIL AND CHECK ENGINE OIL PRESSURE. THIS IS A COMMON PROBLEM ON ALL NEWER GM V-8 ENGINES : 4.8 5.3 5.7 6.0

Feb 21, 2009 | 1998 GMC Sierra

2 Answers

Eng oil leak/3.8 Ltr. eng.


ok who ever installed the oil filter didnt put oil on the seal and tighted oil filter down properly this lead to seal on oil filter burning up and cracking replace oil filter and put oil on the seal all the way around

May 17, 2008 | 1996 Ford Windstar

Not finding what you are looking for?
1994 Isuzu Pickup Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...