KEY WON'T TURN IN IGNITION TRIED EVERYTHING, WHAT ELSE CAN I DO

SOURCE: Ignition key won`t turn on my chrysler cirrus

tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

SOURCE: ignition key won t turn. steering wheel locked

the key may be worn badly or the ignition needs to be replaced.

SOURCE: I tried to start my 2002 chrysler sebring but the

move your steering left and to right as u trying to turn the ignition
also try the shifter too,

G gl

SOURCE: 1997 pontiac grand prix key won t turn ignition

well does the key go in does it turn to the start pos? if the dash dost power up its because the switch is bad if it will power up but not start it can be becuse of the resitor chip depends on what is going on if you cant get power its becuse of the switch

SOURCE: the key is in the

Your steering locks could be in a bind. Is your steering wheel turned to the side? Try moving the steering wheel while trying to turn the key. If this is not the case, then you most likely have either a worn-out key or a worn-out ignition lock cylinder assembly.
I would first try a different key if you have one. If there is not another key, I would take the Vehicle Identification Number (VIN) to the dealer along with proof of registration and picture ID, and have them cut a NEW key using the key codes for your vehicle. If this does not work, then you will probably have to replace the ignition lock cylinder assembly.