Question about 1997 Infiniti.5 Q45

1 Answer

1992 infiniti q45

I'm trying to add freon to my 1992 infiniti q45 and can't find the low port connector. I've done this for other vehicles but can't seem to find it on this particular car.

Posted by on

  • Anonymous Mar 16, 2014

    infiniti q45 memory switch

  • Anonymous Mar 26, 2014

    radio

×

1 Answer

Motor run ruff and will not ideal

Posted on Aug 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do a add Freon into a 745Li BMW?


buy can with hose adapter and hook it up according to instructions to the low side port the following link shows how to add freon to different vehicles your vehicle is not their but the explanation and how to are the same for adding freon
How To Add Freon To Auto Yahoo Video Search Results

Aug 17, 2016 | Cars & Trucks

1 Answer

Does a starter come out the top of a 2000 infinity q45??? or the bottom????


bottom, but the manual mentions a couple different procedures. See below.

4.1L Engine
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:

    Negative battery cable Steering gear and linkage assembly Harness connector Starter retainers Starter

To install:
Install or connect the following:

Starter Starter retainers. Tighten the starter retainers to 30-37 ft. lbs. (40-50 Nm). Harness connector Steering gear and linkage assembly Negative battery cable
Alternate procedure:

  1. Remove or disconnect the following:

    Negative battery cable Engine undercover Harness connectors Starter motor mounting bolt and nut
  2. Remove engine mounting insulator bottom nuts, and lift engine approximately 2 inches with a transmission jack
  3. Remove starter motor

To install:
  1. Installation is in reverse order of removal; observe torque values shown in diagram


jturcotte_2457.gif

Fig. Starter motor mounting and torque specifications-Q45 & 2004 M45

Oct 31, 2011 | 1997 Infiniti.5 Q45

1 Answer

I have a 2005 buick rainier i need to know where is the low pressure port where i can add freon at


Add freon on the low side port:

The low side port is located on the thicker piping vs. the thinner piping.
It may have a black or blue cap.
The hose, don't worry' won't fit anything but this quick connector,

Jun 23, 2010 | Cars & Trucks

1 Answer

LOOKING FOR WIRING DIAGRAM FOR 1992 INFINITI Q45 FUEL PUMP NOT GETTING POWER OR RELAY OR SOMTHING NEED WIRING DIAG.


CHECK FUEL PUMP FUSE.AND SCAN CAR FOR PCM FAULT CODES.PCM CONTROLS THE FUEL PUMP.A HAYNES REPAIR MANUAL HAS FUEL PUMP DIAGRAM.

May 06, 2010 | 1997 Infiniti.5 Q45

1 Answer

I have an Infinity q45 1999. The


take it to a local mechanic ,he should be able to put the light out for you and advise what the other lights are for

Mar 17, 2010 | 1997 Infiniti.5 Q45

1 Answer

My 96 infinity Q45 is very slow starting...it acts as if the battery is low ... but it does crank


Maybe the battery going out, alternator not charging correctly. Its hard to tell on less someone is there to actually look and listen to the engine. Take the vehicle to a local autozone, have them test the battery and alternator for any probblems.

Feb 08, 2010 | 1997 Infiniti.5 Q45

1 Answer

1994 Q45 WILL NOT COME OUT OF GEAR AND WILL NOT START


Possibly brake light switch or neutral safety switch, but not positive on an Infiniti.

Oct 25, 2009 | Infiniti Q45 Cars & Trucks

2 Answers

I'm trying to add freon to 1992 Lexus LS 400 where is it located


the compressor has two hses coming out of it and one of the hoses/lines will go towads the radiator to the condeser the other will go towards the firewall,,under windshield ,this is the one with the low side service port it will be the small port on the larger line/hose the other one is a large port on a small liquid line/hose,,,,the small port is the one u will need to hiook up to ,on the large line/hose

Jun 28, 2009 | 1992 Lexus Ls 400

1 Answer

Overheating


Hi

Are you loosing coolant ?

You need to pressure test the cooling system first, with a cooling system pump, (available at any good Car Spares Shop) to test for and eliminate any leaks, and go from there !

Also have the head gasket tested, with a Carbon Monoxide gas test, on the cooling system.


Good luck !

John

A FixYa rating would be appreciated thanks !

Feb 12, 2009 | 1997 Infiniti.5 Q45

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

367 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13152 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...