Question about 1995 Chevrolet Camaro

3 Answers

1995 3.4 V6 camaro won't start

So i was driving and suddenly a beeping started exactly like the warning beeps of the headlights being on without the car being started. The car's power steering and brakes gradually shut off. once the car was off the road the key would not budge to turn. when i finally did get the key turned the car turns over and fires but as soon as the key is released, it stalls. I know there is gas in the car. Any ideas? personally i am beginning to suspect something is not sending fuel to the engine- fuel pump, possibly?

Posted by on

  • Anonymous Mar 13, 2009

    my car will not crank at all. my key has a little click sound when i turn it. its just that one spot. could it be my ignition switch?



3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If your Ignition switch is hard to turn ...... Believe it or not, check the transmission assembly for debris... I had a small piece of wire caught up and when I threw the shifter to 'PARK' it wasn't going far enough to release the ignition key!

Posted on Mar 09, 2010

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 46 Answers

Fuel pump relay

Posted on Jul 14, 2008


Could be a Bad ignition switch...if its hard to turn, you should not have to force it...something may have broken inside the switch, causing the warning sound you heard,and vehicle to stall as if turned off, a heavy key ring will often cause failure of the ignition switch...if this is not the case, turn on key without starting engine, and listen very closely for a low pitch humming sound, if you hear a humming for a second or two, your fuel pump is running..and would look at possible other failure.

Posted on Jul 18, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2005 jeep wrangler when i turn lights on beeping starts

did you RTM read the operators guide yet,
it tells you why all beeps beep and what lamps flash, (warning) and why. did you?
you turn on, the head lights, (what about 1st click , parking lights"?)
and does the dash cluster, show warnings of any kind?

if a door is ajar the system will think, you are exiting veh. with lights on and tell you, buy beeping ,etc.
but on my jeep it says on the dash DOOR, or on EVICs, (not yours)
the newer car even tells what door IS AJAR.
mine on shows , "DOOR"
the operator guide will say, check all doors for ajar, and get warning clear before driving....etc.

if you lost the guide here it is for free

click the 05 link
ignore beeps, there are just too many .. i look at the cluster and learn to read it..
my newer jeep 08 can produce 1000s of errors,,,,, possible.
in fact the intent it to beep to tell the driver to look at the cluster
for in depth, causes.
see chapter starting on page 136'

once sound it makes is Check gauges chime. so check them.
and headlamps left on
and door ajar.

page 63
NOTE: If the driver's door is left open, and the headlights
or parking lights are left on, the "High Beam
Indicator Light" will flash and a chime will sound.
Lights-On Reminder
If the headlights or parking lights are on after the ignition
is turned off, a chime will sound when the driver's door

its a crude system, and evolved to complex in 2007.
"DOOR" or RF-door , on mine.

NOTE: A tone will chime if the turn signals are left on
for more than 1 mile (2 km).

search manual for
"chime will sound"

Mar 21, 2014 | 2005 Jeep Wrangler

1 Answer

Seat Belt Indicator flashes and beeps randomly

If I remember correctly there is a sensor in the seatbelt buckle. It might have worked its' way loose and your leg motions might be moving it enough to open or ground the circuit. Might be a good idea to check and see if something fell into the latch area, too.

Feb 20, 2014 | 2006 Subaru Forester

2 Answers

When headlights turned on the dashboard lights dim and after 5 minutes a warning sound comes on.

Sounds like your charging system needs some attention.
1st check battery for voltage should be 12.50 or better with car off
2nd, start car check battery for voltage again should be 14.0 to 14.75 volts.
3 with running turn on headlamps and check charging voltage again if your voltage dropped to battery voltage your charging system is not working.

Oct 30, 2017 | 2006 Jeep Wrangler

1 Answer

Hello there, Well I have a 95 mustang srs V6 the problem i have with it is that whenever I turn on my lights (headlights) a beeping sound goes off as if the doors were open. Again this only happens when...

Thanks for choosing FixYa and welcome. I would say this is your reminder switch that is beeping. When the car is off, it will beep to let you know to turn off the lights. It probably isn't recognizing the car is on, only the lights being on. It could also be a sign of a headlight out possibly. I would say your headlight warning switch may be bad. Either that or the light. It is only supposed to go off when the car is dead and the lights are on. As far as the location of the part, I really don't know. This is just a possibility.

May 09, 2011 | 1995 Ford Mustang

1 Answer

Constant beep even while driving and when i turn it off it still beeps unless i disconect the interior lighting fuse and plug it back in fuse # 8 i believe. if i leave the fuse out it makes a wierd sound...

1995 GrCher Orvis - I have now just started with the same problem. An incessent loud high pitched alarm sound. Identical fuse, ignition on/off, and ticking issues. Can start jeep, warning sounds as normal followed by incessent tone, I can remove fuse to get quiet, but then when I close the door I get the identical alarm sound, but with a slight pause. Tone. Tone, Tone, etc. I can't figure. Tore through all components of dash: to learn that the alarm seems to emminate from the transmission floor area, and is not in the instrument panel (f up #1) nor is it behind the dashboard (f up #2). I'm stuck now... Anybody got something for me? Is it a transmission warning?

May 28, 2010 | 1995 Jeep Grand Cherokee

2 Answers

We get 3 sets of 5 beeps

check for codes i think that your connector under driver seat is loose or corroded wires clean it and put it back again

Nov 19, 2017 | 1994 Ford Mustang

1 Answer

A beep just recently started up. It comes and

hi from uk the beep may well be that your rearfogs are still switched on and is normally a beep warning the switch may be in on positio but the fogs will not come on untill you have head lights on dipped mode this is how they should work

Feb 14, 2010 | 2006 Ford Mustang

2 Answers

After driving several miles my 2004 pacifica starts to beep - 3 beeps every 30 seconds and doesn't stop. No lights are on - engine or otherwise. Once I've stopped and the engine has been turned off for...

if you drive slowly does it not start? ensure you do not having anything resting on your passenger seat. if there is a weight sensor in the seat for the seatbelt warning the car assumes sombody is in the passenger seat. or the sensor is defective to isolate this plug the passenger seatbelt into its lock and see if the problem goes away. (when driving slowly this may not start. the alarm may be set to go of after a certain speed)

note: keep all clutter away from the driver position after cornering or breaking, debris may fall into the foot well and interfere with the pedal movement. or fall onto the driver.

Nov 13, 2009 | 2004 Chrysler Pacifica

1 Answer

Warning beeping

Sounds like a security system warning, must use scanner to accesss system. Hope this helps.

Jan 23, 2009 | 2000 Chevrolet Malibu

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

1,099 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides