Question about Mitsubishi Outlander

1 Answer

2008 Mitsubishi Outlander 2.4L CVT Transmission

I am having a hesitation problem when starting from a stopped position and I can hear what sounds like a spark pop noise dealer said no problem found but I have 2 other mitsis with same engine this one in particular has only 2700 miles on it any feedback?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 375 Answers

It cold be both the fuel pump or crankshaft sensor will cause this problem. A shop should be able to use a scope and check the square wave pattern on the sensor to determine if it is good or not.

Posted on Jun 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My neutral light is flashing on my 2007 Mitsubishi endeavor, it will go in reverse but won't go in drive. What can be the problem?


Stuck Transmission Lock - Mitsubishi-Forums.com

www.mitsubishi-forums.com > ... > 2G (2007+) Outlander

Feb 22, 2008 - 5 posts - ‎4 authors
Drives: 1997 Outlander LS, 2007 Series 3 380 SX ... Hopefully the heads up will help one/some of you out if you ... This morning I jumped into my 2007 Outlander (Aussie Spec with the CVT) and I couldn't move the gear ... I couldn't find anything in the manual about it, but a Google search brought me here.

Getting Into Reverse Gear - Mitsubishi-Forums.com

www.mitsubishi-forums.com > ... > Colt & Mirage Forum > 2003+ Colt

Mar 17, 2007 - 15 posts - ‎10 authors
go to another car dealer with the same model and a manual ask for a test ...QUOTE(stevansam @ Mar 19 2007, 07:34 AM) ... the dealer won't take the car back because it's not a fault of the car but a ... I also have a Renault megane and at workdrive a Ford pick-up, which both have syncho in reverse, I can't ...

Adjust Digital Transmission Range Sensor - YouTube

? 0:42
https://www.youtube.com/watch?v=FyiGxhkV-VM
Mar 27, 2010 - Uploaded by Alexander Cameron
If the DTR is not adjusted properly, you will get a no-start situation. ... when I am in drive and shift to reverse my backup lights dont work but if I put into park and not even all the way into park and go reverse they work. ... Hi I changed the solenoid

Jan 10, 2016 | Mitsubishi Cars & Trucks

1 Answer

2008 Mitsubishi lancer radio from loud squealing noise


What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html
NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

Dec 03, 2015 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Outlander cvt transmission does not change over to 2nd 3rd or 4th 2006 model


could possibly be what they call limp home mode which is commonly caused by a dirty earth connection from body to engine

Mar 08, 2015 | 2006 Mitsubishi Outlander 2.4i

2 Answers

I have a 2008 Mitsubishi Outlander 2.4 CVT that is vibrating (intermittantly) when accelerating. The vibration feels like it is from underneath and through accelerator. It is more prone to happen if going...


Sounds like a driveline/driveshaft issue. Either loose bolts or a bent shaft. Nut & bolt the shaft. If it continues after that, you may have a bent shaft.

Feb 10, 2014 | Mitsubishi Cars & Trucks

1 Answer

07 mitsubishi outlander wont start.


Hi michael, a couple of things, 1st if you have a key with a chip in it (as a theft deterent) it couldvre malfunctioned, if you have a reg. key id start with the main fuse for the computer regulator and work my way to the starter relay, efi relay, neutral safety switch, and so on, hope this helps!!

Jun 10, 2012 | 2007 Mitsubishi Outlander LS

1 Answer

Can i use toyota ws autotransmission fluid in mitsubishi lancer cvt autotransmission?


NO. you must use appropriate CVT fluid, anything else will damage transmission.

Feb 27, 2011 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

What trasmition oil do this car use


Your transmission requires a special fluid. DIA QUEEN CVTF-J1
You can save yourself some time and go directly to the Mitsubishi dealer. You may hear alot of "recommended" replacements for the OEM fluid. With that CVT transmission, I recommend that you stay with OEM fluid.

Good Luck

Dec 31, 2010 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Transmission problem stuck in sport shift mode


I also have a 2009 Outlander Sportronic transmission with a V6 engine.
Bought it this summer ... transmission appeared fine but seemed to automatically slow down the vehicle using the engines compression whenever I let go of the gas pedal.
Now that the cold weather is upon us here in Canada, whenever I accelarate normally (not like a teenager) the transmission takes quite a bit of time to shift into second... If I rev up the engine (quick take off) it seems to help but the shifting of gears is not as smooth as I would expect it (mildly slips and kicks into second)...

The worst is when come to a complete stop ... then the transmission kicks coming down from the higher gears???

I read somewhere that this is because this transmission is a CVT type and is learning my driving habits in order to adjust itself so the vehicle becomes more fuel efficient... Not sure but if the trany is computer controlled then it must be poorly writen program...
I'm taking the car in to the dealer and will write back on the diagnostic they give me ...

May 15, 2009 | 2006 Mitsubishi Outlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

761 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...