Question about 2005 Chevrolet Tahoe

1 Answer

2005 tahoe door

Back door and window on 2005 tahoe will not open seams like the lock is jambed you can hear it operate but not as loud as it us to be

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,039 Answers

The locking mecanizine is jam lub the latch its not easy to do you might have to remove the inner panel of the door .put some lub and try to move the lock unlock button many time for the lub to go in wd-40 or something better thank you
pierre

Posted on Jun 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix it the problem with the sensor on back passenger door it shows up on dash board as door is open


Many door open sensors self-adjust the first time the door is closed. If something gets between the door jamb and the button switch, the switch can get pushed in too far to actually make the connection when the door is closed.
You may be able to pull the switch back into normal position, or at least replace the switch.

May 15, 2015 | 2005 Renault Megane Scenic

2 Answers

'05 Mercury Montery PSD's stuck shut


Ford power sliding doors suffer from amnesia. That is, they forget how they are supposed to operate. This can occur if the battery is disconnected or if the doors are not operated frequently. I have found it necessary to open the door manually, check the spring-loaded contacts on the edge which connect power to the latch mechanism for proper operation, then close it using the button on the jamb. after that, I use the fob button frequently to open the door and the jamb button to close it. Idleness causes memory loss. The overhead button has never cured the problem - I would just leave it alone. Lastly, you may find the door problem goes away after repeated therapy. Also check to determine whether the door(s) had the child locks enabled inadvertently.

Nov 28, 2013 | Mercury Monterey Cars & Trucks

1 Answer

2005 F-150 no power to windows


Lots of times the wiring breaks in the door jamb where the door opens and closes. Check fuses first and any power at the master switch, if not have to trace wiring.

Nov 10, 2013 | 2005 Ford F-150 SuperCab

1 Answer

Locked keys in my car 1997 buick lesabre


use a coat hanger and a large screw driver to to open the door. here is how; Use the screw driver to open the upper portion of the door jamb. (NOT THE WINDOW THE JAMB) next use the coat hanger to press the unlock button and the door is opened...

Apr 18, 2011 | Buick LeSabre Cars & Trucks

1 Answer

I have a 2005 tahoe and the back door will not open.When I click the remote to unlock, it clicks but does not open. How do I get it open?


try opening it manually from the inside. it seems your lock switch is bad. even though you can hear it, it may not have enough power to open the lock. does it have a key lock on the outside?

Feb 18, 2010 | 2005 Chevrolet Tahoe

2 Answers

No power of windows or locks from 2005 F150 driver side control


are the lock motors bad?the rubber around them dry up and allow water in them.

Oct 13, 2009 | 2005 Ford F-150

1 Answer

Back boor wont open


I opened the back pannal and un-bolted the lock base from the body den took lock apart and made a new 1 useing parts i had from my old suit case yes i said suit case i used the locking pin from that 2 replace the broken 1 on the door

Sep 30, 2009 | 2005 Renault 18I

1 Answer

My back door won't open on my 2000 tahoe


you latch mechanism could be broken or came apart, common to any vehicle.. open the cover to the back and you will see the locking mechanism, once the rear cover open you can find the latch and open it form the inside. once you get the door open you can play with the door handle by pulling on it like you opening the door and you can observed what actually connect to what to operate the latch. if small rod attached from the door handle to the lock could pop off or broken. may have to replace the handle, depend if its broken or came apart. should be 30 buck for the new handle if needed..hope that help some..good luck

May 30, 2009 | 2000 Chevrolet Tahoe

1 Answer

Hatch-back door will not open


I can say I have had the same problem, only the back doors and the rear hatch/glass won't open using keyless remote from them freezing this Winter.  The front two driver/passenger doors will unlock with keyless remote but none of the rear doors, hatch or glass.  Since I had to replace the stoplight bulbs in the rear with one not working and I don't need a ticket on Memorial Day weekend (need to replace 2 at the same time is wise according to any good mechanic), I had to get the rear hatch open to get to the lamp assembly and replace the bulbs.  My thinking was that since my two front locks were opening but no others and my keyless remotes are working, it has to be a fuse or relay that is not working!  So, I talked with a NAPA rep and he said the "Day running lights" relay can be a temporary fix to get the rear locks open to replace the bulbs.  I looked up in the owners manual where both relay's are located and removed the "Locked" relay and "Day running lights" relay and put the "Day running lights" into the same slot where the "Locked" relay was not operating and it worked!  I got the doors unlocked and replaced my stoplight bubs replaced.  Now, I have a new problem, my Tahoe won't start!!  I'm assuming the relay wasn't supposed to stay in the wrong slot when operating the vehicle because I started the truck, and it started and died-started and died-same and again.  I think the wrong fuse can be used to fix another problem like a fuse.  But, a fuse you can leave in and deal with one operation in the vehicle not working until you can replace the fuse later when you purchase it.  But, not a relay!  Now, I think the confused electronics cause another component (possibly the fuel pump relay) to burn out with the wrong relay in place of another when the vehicle operates.  I should have known but I was so glad to get the doors open after two months and it being Memorial Day weekend.  Now I have to find out what else is wrong so don't make that mistake to avoid the same predicament.  Better to get the relay ordered and replaced than to have this happen to you. 

Apr 09, 2009 | 2005 Chevrolet Tahoe

Not finding what you are looking for?
2005 Chevrolet Tahoe Logo

375 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...