Question about 2000 Audi A4

1 Answer

A/c problem dear sirs im facing a problem with the use of a/c . i noticed that after a few hours of a/c work, something like a visible film appears on the windows (inside the cars) and make them blurring. This film get away only when rub it lightly with a water cloth or paper Is something wrong with a/c compessor? does anything toxic or harmfull air gets into the cabin? thanks babis karathanasis a4, 1.6 2000 model

Posted by on

  • bogs-bab Jul 07, 2008

    what y mean is that i ll have leaking problems inside the car? or just no good air-con working?

    and sorry if i look silly but how do i chek the collan level or the leak place?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 373 Answers

Hi. I hope this work for you.
Check the coolant level. of the radiator or reservoir.
If you note the coolant is loosing. The heater core is leaking.
THis is the common problem of film. that can't go it self.
Unless you wipe with cloth o someting.

And is bad for your health.

Posted on Jul 04, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

While im driving i noticed the amp meter was going down to the left(discharge). I would turn off all electrical acc and then after 10-15 secs. it would jump back to a normal position on the guage. I...

I suggest that you check your charging system. With the ignition off, measure the battery voltage, then measure it again with the engine running. The voltage should be higher with the engine running, by 1 - 2 volts. This is a just a quick check, but if the charging system isn't working at all, the voltage will not increase when the engine is running.

Aug 12, 2010 | 2004 Ford Mustang

1 Answer

Bad CV Joint?

Did you notice any leaks from the power steering? If you did not notice any leaks, the only place for the fluid to go is in the bellow boots(the accordion boots on the rack and pinion system). Go underneath and if no leaks are obvious, take a small screwdriver and poke a small hole in one of the boots. If fluid comes out, you're looking at replacing the rack and pinion. This would also explain the excessive play you're feeling in the steering.

Feb 25, 2010 | 1992 Oldsmobile Cutlass Supreme

1 Answer

2006 ford mustang wont start after driving the car for a few hours cut car off and parked for about a hour or so when returned to get back in car to leave the car would not start the lights inside the car...

Sounds like an electrical mess up. Im not too familiar with ford and newer vehicles. It could be the starter getting jambed. The make a grinding/clicking noise..Something like a selenoid? Just ideas..

Oct 05, 2009 | 2006 Ford Mustang

1 Answer

BMW wont start - Exhaust emission values light

it simply sounds like your oxy sensor(s) are bad, maybe egr system, and or clogged catalytic converter. Yes it will be a little pricey. Sorry.

Sep 05, 2009 | 2001 BMW 330

1 Answer

Mercedes E300 turbodiesel, 1999, is poor to start when cold, almost/is impossible to start when hot. no air visible in fuel lines, all seals etc replaced, new fuel tank strainer, fuel pre filter and fuel...

Yes sir , you have a failing valve, soon it will snap in two....please have your head checked. You can do this yourself by placing a long-handed screwdriver , business end down to each cylinder while pressing your ear to the handle(while engine is running) will notice a definite difference when you hit which cylinder has the bad valve. Also makes sure the egr valve is clean and your exhaust recycle valve is not stuck.( located in the crossover pipe)

Aug 29, 2009 | 1999 Mercedes-Benz E-Class

Not finding what you are looking for?
2000 Audi A4 Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

80608 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14417 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides