Question about 1993 Buick Skylark

2 Answers

Car starts but stalls when put in gear

Car starts and runs until put in gear

Posted by on

2 Answers

Actually the torque converter was locked up-disconnected it-car is good for now

Posted on Jun 25, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

Its not idleing right take it to get repaired

Posted on Jun 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Excurtion will start normal, but stall when putting in gear (reverse) or braking. When re-starting it runns ok until next braking.


Have the catalytic converter checked at your local muffler shop...clogged...worn out...Hope this helps.

Mar 12, 2014 | 2005 Ford Excursion

1 Answer

1991 F350 w/460 cu starts but runs rough until warm.


sounds like auto matic choke problem try a manual choke

Jan 02, 2014 | Cars & Trucks

1 Answer

2008 Sprinter stalls at idle when in gear


2506 PCM/ECM Power input signal range/performance
110 IAT Intake Air Temp sensor 1 circuit
104 MAP/ Baro sensor low input
You probably did do some damage by not isolating the engine and controls out before the repairs/mods were started.

Jun 11, 2013 | 2006 Dodge Sprinter

2 Answers

Car will start but when put in gear it dies/stalls


my ford winstar vav stalls when you put it in drive will idol all day just find

Apr 08, 2013 | 1993 Buick Century

1 Answer

I have a 88 grand am Se 2.0 OHC turbo, automatic the turbo does not work. my problem is that it runs great for about 1/2 hour driving until it gets warmed up. I come to a light it starts to surge and...


The TCC solenoid in the transmission needs to be replaced. It is under the side cover. It controls the converter to lock up for better fuel mileage. If you want to drive car until you get it fixed you can un-plug the connector going to the transmission on the front of transmission. This will keep it from going to lock up mode and keep it from stalling until you can fix it. Common problem.

Apr 02, 2011 | 1988 Pontiac Grand Am

2 Answers

As you've probably heard before my 91 cav starts fine gets warm stalls at lights starts right back up but cuts off when i put it in gear


pull off the transmission transition switch wire pluged on to tranny
start car drive should be fine never hook op again 0 money
or pay 700 dollars to install a new one
or buy switch pull tranny and install your self

Jul 14, 2010 | 1991 Chevrolet Cavalier

1 Answer

1990 Pontiac 6000 2.5 after driving, car stalls when put in gear.


You need to replace the TCC solenoid under the side cover pan of the transmission. You can also unplug the wires that go to the transmission in the front. After that it will not go into overdrive but it will stay running at stop lights untill you have it repaired.

Sep 28, 2009 | 1990 Pontiac 6000

1 Answer

1989 4 Cyl will run until hot, then stalls


could possibly be camshaft position sensor or crank shaft sensor have you had a diagnostic scan

Aug 20, 2009 | 1993 Ford Probe

1 Answer

When I put car in gear it sputters and stalls.


read the codes with volvo or if you would like me to guess replace the air mass meter/ck all vac hoses

Jun 07, 2008 | 1999 Volvo V70

Not finding what you are looking for?
1993 Buick Skylark Logo

Related Topics:

275 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...