Question about 2005 Ford F-150

1 Answer

Possible "stealth" lock down of truck

Turned key, lights blinking, horn blowing, will not start. Supposedly the "key" part of the stealth was dismantled when I bought the truck. Short of going to the dealer, can this be fixed? Also, I think the battery may be ready to be replaced.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 594 Answers

The truck will not start because the alarm is engaged. that is a saftey masure for new cars and trucks so that way someone who is stealing it can not get far. if part of the alarm was dismantled (disconnected) than it will not allow you to start the truck you will either have to completly disconnect the entire alarm system or take it in and have it hooked back up and reset so the truck will start

Posted on Aug 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Keyless remote is broke cannot disable anti fheft system, engine won't start


lock all doors from button on side of door...goto passenger side door and use your key to open it and it should take care of the problem

Oct 02, 2014 | 2000 Jeep Grand Cherokee

1 Answer

Changed rack and pinion. when turning wheel to right horns started blowing. unplugged airbags and horn stopped. drove truck for 1 day now wont start and dome light is blinking and warning lights on dash...


It sounds like you disturbed the wiring or the connector inside the lower portion (inside the cabin, under the dashboard) of the steering column. You may have also pinched wiring higher inside the steering column, up near the horn button. You'll need to track it all down & correct the wiring problems in (and around) the steering column.

Aug 04, 2014 | 2004 Dodge Ram 1500

1 Answer

Horn blows randomly


change horn relay

Jan 25, 2014 | 2008 Dodge Avenger

1 Answer

My car battery got dead so I bought new battery and tried to replace the old one. As soon as I reconnected the terminals of the new battery the car started making panic horn noise. Its horn alarm goes on...


On some models you can disable the alarm after you connect the battery by locking and unlocking the driver door with the key.
I would disconnect the horn or pull the relay until you can get the alarm turned off.

Sep 25, 2013 | 1999 Toyota Corolla

1 Answer

Alarm set


this is a factory alarm, the problem is the alarm is active, you will need to use the door locks to turn alarm off, insert key in driversdoor and lock and then unlock door this will turn alarm off, if that doesnt work then use pass/side door, the lock has a built in switch that knows when the door is locked or opened, the driversdoor may have a bad switch so inturn the computer thinks the door was forced opened without key and it is turning alarm on, so again use the key to unlock door try the pass/side if driversdoor doesnt work. good day

Nov 24, 2011 | 1998 Plymouth Voyager

1 Answer

Turning off Alarm


close the doors while on the outside... lock and unlock the drivers door with the key. then open the door and you should be able to start the vehicle

Mar 31, 2010 | 1998 Jeep Grand Cherokee

1 Answer

Horn do not blow when i lock my 2007 nissan truck with remote


Murano, maybe others.

This is adjustable through the center console, Key turned to the on position but not running, press settings, then you will see your selections, use the center knob to move up / down and enter to select. I believe it's the center choice & once you push the enter button, the display will show several options concerning locking the doors, lights, horn options for the remote. If that setting is correct and the horn isn't working, check your fuse/horn.

good luck

Mar 09, 2010 | 2005 Nissan Murano

1 Answer

When the door opens the alarm goes off the horn blows and the lights blink and the can be started


i had the same problem. the issue is with the passenger door. lock and unlock with the key. it worked for me.

Oct 04, 2009 | 1992 Buick Park Avenue

1 Answer

2006 Criuser won't start and intrusion alarm can't be stopped


YOUR WIRELESS CONTROL MODULE(SENTRY KEY MODULE)MAY BE ELECTRICALLY LOCKED UP..THERE IS A SERVICE BULLETIN FROM CHRYSLER..YOU CAN REMOVE IOD FUSE IN FUSEBLOCK(UNDERHOOD BEHIND AIR CLEANER..IGNITION OFF DRAW(IOD)THIS WILL RESET WIRELESS CONTROL MODULE AND VEHICLE SHOULD START AND LOCKS RESPOND AGAIN..IF IT DOES,THE WCM WILL HAVE TO BE REPLACED AND THIS NEEDS TO BE DONE BY DEALER

May 30, 2009 | 2006 Chrysler PT Cruiser

1 Answer

The power door locks quit working. When pressing the key fob to unlock the door the lights blink and horn blows


Just had the same problem fixed at dealership. Locks had to be reprogrammed? Cost me $90, but they work now

Jul 25, 2008 | 2008 Dodge Grand Caravan

Not finding what you are looking for?
2005 Ford F-150 Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...