Question about 2001 Cadillac DeVille

2 Answers

Air Conditioning My 2001 deVille air conditioning runs cold on the passenger side and rear seat systems, but is warm most of the time on the drivers side. When it is very hot outside the whole system will occasionally go warm, but cycles back cold without much change in driving conditions. I have checked the cooling system fluid levels and topped it off with DexCool. That didn't seem to change anything. I didn't think it would because the engine temp was pretty steady before. I don't think its a refrigerant level problem because it really does blow cold at times. I also don't think the compressor is cycling off and on because it goes for long periods when it is cold on the passenger side and warm on the drivers. I have changed ever system setting, including air recirculating and nothing seems to improve the situation. Got any ideas?

Posted by on

  • rllec Jul 11, 2008

    Same problem on mine I removed all servos and manualy shifted all door flaps still no change. the evaporator was changed for leak and doors seal's checked.



    But there is still a 10 degrees difference in passenger & driver air vent

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Try changing the lower temp sensor in the air duct on the drivers side. I bought one and never replaced it. before the part arrived I took the lower sensor out and taped it up and put it back under the dash... not in the air duct housing were it belongs. believe it or not it works so well I did not even see a need to change the thing.

Posted on Jan 08, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 43 Answers

It sounds to me that one of the cables or servos is loose or faulty causing one or more of the direction flaps to be left open or closed ,whatever the case may be ..hope this helps

Posted on Jun 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air conditioning system, when you turn on the air conditioner the drivers side blows cold air and the passengers side blows hot air? What causes this problem?


The most common cause of this is that you have a stuck air temperature control blend door, this can be a motor actuator issue or a jammed door or both (common). To replace both parts you will need to completely remove the dash from the car to access the blend door.

Jul 02, 2016 | 2010 Ford Flex Limited

1 Answer

Passenger side blows cold air--what part could it be


2001 Chevy Tahoe Heat Problem - Tahoe Forum

www.tahoeforum.com > ... > Technical Discussions
Dec 5, 2008 - 10 posts - ‎7 authors 2001 Tahoe, the front heater blows a little hot air when the car warms up and then blows cold air. The rear heat seems to work fine. I changed ...

Rear AC blows hot air - Tahoe Forum - Chevy Tahoe Forum

www.tahoeforum.com > ... > Technical Discussions

Jul 14, 2008 - 10 posts - ‎5 authors
On my wifes 03' Yukon the rear air conditioning blows hot air no .... Pull the panel off and look at the hot/cold actuator shown in the picture.

Oct 30, 2015 | 2001 Chevrolet Tahoe

1 Answer

Odyssey air conditioning


HVAC Vent Doors under the dash- need to be diagnosed
One is not operating- to switch the air flow
HVAC Vent Door Motor or Vacuum Motor
which ever type you have

Jul 18, 2013 | 2005 Honda Odyssey

1 Answer

Air conditioning blows cold on drivers side but warm air on passengers side.


dodge has dual blend door actuators on the air box. you have to pull the dash board assembly out to access the passenger side door actuator. it calls for 5.8 hours to do this job. you also have to evacuate and recharge the ac system.

Jul 19, 2010 | 2004 Dodge Ram 2500

3 Answers

Looking to replace heater core


Cherokee, Grand Cherokee, 1999-2005

Removal & Installation
  1. Disconnect and remove the negative battery.
    CAUTION After disconnecting the negative battery cable, wait 2 minutes for the driver-s/passenger-s air bag system capacitor to discharge before attempting to do any work around the steering column or instrument.
  2. Drain the cooling system into a clean container for reuse.
  3. Remove the instrument panel by performing the following procedure:
    1. Turn the steering wheel in the straight-ahead position.
    2. Remove the knee blocker from the instrument panel.
    3. Remove the steering column; do not remove the air bag module, the steering wheel or switches from the steering column.
    4. From under the driver-s side of the instrument panel, disconnect the following items:

      Instrument panel wiring harness connector from the 100-way wiring harness connector at the left side of the inner panel. Side window demister hose at the heater/air conditioning housing demister/defroster duct on the driver-s side.
    5. Remove the glove box.
    6. Reaching through the glove box opening, disconnect the following items:

      Two halves of the heater/air conditioning system vacuum harness connector. Instrument panel wiring harness connector from the heater/air conditioning system wiring harness connector. Instrument panel wiring harness connector from the passenger-s side air bag module wiring harness connector. Side window demister hose at the heater/air conditioning housing demister/defroster duct (passenger-s side). Two halves of the radio antenna coaxial cable connector. Two instrument panel wiring harness connectors from the passenger air bag ON/OFF switch wiring harness connector. Passenger-s side air bag ON/OFF switch wiring harness from the retainer clip on the plenum bracket that supports the heater/air conditioning housing just inboard of the fuse block module. Two lower passenger-s side air bag module bracket-to-dash panel nuts.
    7. Remove the upper cover from the instrument panel.
    8. Remove the 3 instrument panel-to-door hinge pillar screws.
    9. Remove the 4 upper instrument panel-to-dash nuts.
    10. Using an assistant, remove the instrument panel from the vehicle.
  4. If equipped with air conditioning, discharge and recover the air conditioning system refrigerant.
  5. Disconnect the refrigerant lines from the evaporator. Plug the refrigerant openings to prevent evaporation.
  6. Disconnect the heater hoses from the heater core tubes.
  7. Disconnect the heater/air conditioning system vacuum supply line connector from the T-fitting near the heater core tubes.
  8. In the engine compartment, remove the 5 heater/air conditioning housing-to-chassis nuts. If necessary, loosen the battery hold-downs and reposition the battery for access.
  9. Remove the cowl plenum drain tube from the heater/air conditioning housing stud; it-s located behind the cylinder head on the cowl.
  10. From the bottom of the heater/air conditioning housing, remove the floor duct.
  11. On the passenger side, remove the heater/air conditioning housing-to-plenum bracket screw.
  12. Pull the heater/air conditioning housing down far enough to clear the defrost/demist and fresh air ducts, then, rearward far enough to clear the mounting studs and the evaporator drain tube to clear the dash panel holes.
  13. Remove the heater/air conditioning housing assembly from the vehicle.
  14. Remove the heater/air conditioning housing upper case.
  15. Lift the heater core from the lower half of the heater/air conditioning housing.
To install:
  1. Assemble the heater core into the lower half of the heater/air conditioning housing.
  2. Install the heater/air conditioning housing upper case.
  3. Install the heater/air conditioning housing assembly to the vehicle.
  4. On the passenger-s side, install the heater/air conditioning housing-to-plenum bracket screw.
  5. At the bottom of the heater/air conditioning housing, install the floor duct.
  6. Install the cowl plenum drain tube to the heater/air conditioning housing stud; it-s located behind the cylinder head on the cowl.
  7. In the engine compartment, install the 5 heater/air conditioning housing-to-chassis nuts.
  8. Connect the heater/air conditioning system vacuum supply line connector to the T-fitting near the heater core tubes.
  9. Connect the heater hoses to the heater core tubes.
  10. Connect the refrigerant lines to the evaporator.
  11. If equipped with air conditioning, evacuate and charge the air conditioning system refrigerant.
  12. Install the instrument panel by performing the following procedure:
    1. Using an assistant, install the instrument panel to the vehicle.
    2. Install the 4 upper instrument panel-to-dash nuts.
    3. Install the 3 instrument panel-to-door hinge pillar screws.
    4. Install the upper cover to the instrument panel.
    5. Reaching through the glove box opening, connect the following items.

      Two lower passenger-s side air bag module bracket-to-dash panel nuts. Passenger-s side air bag ON/OFF switch wiring harness to the retainer clip on the plenum bracket that supports the heater/air conditioning housing just inboard of the fuse block module. Two instrument panel wiring harness connectors to the passenger air bag ON/OFF switch wiring harness connector. Two halves of the radio antenna coaxial cable connector. Side window demister hose at the heater/air conditioning housing demister/defroster duct (passenger-s side). Instrument panel wiring harness connector to the passenger-s side air bag module wiring harness connector. Instrument panel wiring harness connector to the heater/air conditioning system wiring harness connector. Two halves of the heater/air conditioning system vacuum harness connector.
    6. Install the glove box.
    7. Under the driver-s side of the instrument panel, connect the following items:

      Side window demister hose at the heater/air conditioning housing demister/defroster duct on the driver-s side. Instrument panel wiring harness connector to the 100-way wiring harness connector at the left side of the inner panel.
    8. Install the steering column.
    9. Install the knee blocker to the instrument panel.

  13. Connect and remove the negative battery.
  14. Refill the cooling system.
  15. Run the engine to normal operating temperatures; then, check the climate control operation and check for leaks.

Hope helps (remember rated this).

Jun 25, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Air cond warm coming out of driver side dash,warm passenger side


you want me to post a free solution yet want to charge for info I requested for free?

Jun 18, 2009 | 2002 Cadillac Deville

1 Answer

Air Conditioning


I'm going to assume the fan louvers (that direct air from wind shield head to feet ect) are electronically controlled. If that is the case, then a motor may have died. You only have one AC system for the vehicle, so if its cold on one side, then the fault lies within the air ducting system. Maybe a mouse built a nest in there and is blocking air flow?

Jun 18, 2009 | 2001 Pontiac Grand Prix

Not finding what you are looking for?
2001 Cadillac DeVille Logo

534 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...