Question about 1999 Dodge Durango

1 Answer

1999 dodge durango

My durango will not start on the first couple of tries and it makes a clicking sound before it starts.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 979 Answers

If it only makes the clicking sound during these unsuccesful start attempts, I would look at the battery, terminals on the top of it, the cables, then, barring problems there, replace the starter...accordianman

Posted on Jul 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Will a bad pick up coil stop a 1999 dodge Durango from cranking


It wouldn't stop the engine from turning over while trying to start. But it can make engine not start or run poorly

Sep 12, 2015 | Dodge Cars & Trucks

Tip

Dodge Durango Won't Start, Turns over, NO BUS on instrument cluster


1998 - 1999 Dodge Durango 3.9L
2000 - 2001 Dodge Durango 4.7L
1998 - 2000 Dodge Durango 5.2L
1998 - 2001 Dodge Durango 5.9L

The PCM has 3 connectors plugged into it. Try wiggling each connector and listen for a clicking sound, starting with the connector furthest from the front of the Durango, and the middle connector with a white top.

If this doesn't help, replace your PCM. The PCM (power control module) can get hot, causing a short or broken circuit inside the module. Replacing the module will fix the problem. If your truck dies randomly when it's hot outside, but will start back up after it cools down, this is probably the problem.

on Jun 18, 2010 | Dodge Durango Cars & Trucks

1 Answer

I have a 1999 dodge durango will not start just clicks . The lights come on and the battery is full charged but will not kick over please help me


Sounds like you have a bad starter solenoid. You are probably going to need a new starter. You could get under the vehicle to make sure you have 12 volts to the starter to verify. Also make sure battery connections and ground wire is good

Oct 04, 2012 | 1999 Dodge Durango

1 Answer

Dodge durango stalls after starting


There may be a fault code or codes stored, though. Have an engine scan done for trouble codes as a first step in diagnosis. If no codes are present, I would start by investigating the idle circuit-clean the throttle body and have the IAC (idle air control) tested for proper operation. Good luck.

Jul 12, 2012 | 1999 Dodge Durango

2 Answers

Hi i have a 1999 dodge durango and it makes a wierd sound at back of motor by trans sounds like something rattling just started couple weeks ago funny thing is it only does it while in park once you put it...


i would check to see if there is a heat shield, or protective shield in the area that you described, that might be loose or need tightening up, this could be the vibrating or rattling , when the engine is in park, due to the higher rpm's, also check to see if transmission mounts are tight.

Feb 14, 2011 | 1999 Dodge Durango

1 Answer

Dodge durango 1999 sound front end


The tranny-to-engine bolts being loose can certainly cause this symptom...accordianman

Jun 22, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

428 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...