Question about 2002 Jeep Liberty

1 Answer

How can i remove the evaporator from a 2002 jeep liberty

I must remove and replace the evaporator on a 2002 jeep libert.
How do i get the old one out

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers

Quite the project. go to autozone, online. go to repair guide section, and lookup heater core replacement, same area as evap and easier for you to follow, than my directions. good luck glenn

Posted on Feb 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Jeep Liberty 3.7L Engine Swap to newer 2005 engine


every year the motor had different parts and timing was moved. try and take parts off the old motor. like the fuel rail and the sensors

Jan 07, 2013 | 2002 Jeep Liberty

1 Answer

How much do you think a repair for the evap on a 2002 jeep liberty sport . Cause engine light keeps coming on


There are allot of reasons that cause an fuel evaporative emissions control system code to be set, it is very time consuming to track them down, so the cost is almost all labor, and that on average is about $200.00 + what ever part is needed.

Mar 07, 2012 | 2002 Jeep Liberty

1 Answer

How to remove dash on 2002 Jeep Liberty


Is to long to explain, then I suggtes check the Jeep KJ 2002 - Liberty Service Manual PDF Secc 23 - Body

I hope this helps (remember to rate this answer) and keep us updated.

Nov 26, 2010 | 2002 Jeep Liberty

1 Answer

Crank but wont start 2002 jeep libert


Did you have a (Service Engine Soon ) light come on when it was running? It could be a dead fuel pump, bad coil or ECM, I need more details please?

May 25, 2010 | 2002 Jeep Liberty

1 Answer

My driver side heated mirror on my 2002 jeep liberty limited was sideswiped. How do I go about replacing it with a new one? I am hoping to find step-by-step instructions.


1.call the chrysler dealership for a new replacement or call around to autowreckers for one. 2.open the door. 3.pry off plastic from door to mirror spindle. 4.check wiring coloring. 5. pull off plastic under steering wheel may be held on by 2 or 3 screws. 6.locate wiring from mirror under dash. 7.unplug wiring harness for mirror. 8.pull out old wiring. 9.remove old mirror with old wiring harness. 10. replace with new mirror and wiring harness and then repeat.

Jan 05, 2010 | 2002 Jeep Liberty

1 Answer

BRINGING UP CODES


replace the evaporative emissions leak detection pump, this is a known fault with this system and model.

Oct 07, 2009 | 2002 Jeep Liberty

1 Answer

AIR CONDITIONER ON 2002 JEEP LIBERTY IS LEAKING FREEON SOMEWHERE IT WILL COOL FOR FOUR DAYS AFTER CHARGING WITH FREEON AND THEN IT BLOWS HOT AIR. NO LEAK VISABLE WHEN I ADDED FREEON DYE. WHERE COULD THE...


its probley leaking in the evaporator you cannot see it without removing the dash see if anyone that you know has a freon sniffer then lacated the drain tube for the evaporator case most of the time its located on the fire wall on the right lower area with a full charge use the sniffer and see if indicates a leak

Jul 09, 2009 | 2002 Jeep Liberty

1 Answer

Replacing front rotors on a 2002 jeep liberty...removing the piece that prevents the rotor from being removed


lift and suport frame of vehicle, place safety stands under frame to prevent vehicle from falling, take tire off, remove fastners holding caliper to steering knuckle, remove caliper mount by removing fasteners at steering knuckle, slide rotor off.

Jul 06, 2009 | 2002 Jeep Liberty

1 Answer

Is wiring harness already there for power seats in my jeep libert


no, you will have to buy harness' and you probably have to buy different BCM for a liberty that had power seats!!! (BCM=Body Control Module)

Jun 19, 2009 | 2002 Jeep Liberty

1 Answer

The rear window on my 2002 jeep libert keeps poping open, when I pit it in drive.


lubricate the lock mechanism on the inside of the jeep and the lock key hole and with PB blaster --wait 15 minutes --try it then ?

No ---Replace the lock --$10.00 junk yard or up to 30 parts store or more for dealer unless under warranty --co pay = usual 50 if you had enough coverage --call the dealer in advance if you go that route --if you must ---It's a GM get used to it

Apr 05, 2009 | 2002 Jeep Liberty

Not finding what you are looking for?
2002 Jeep Liberty Logo

600 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...