Question about 1996 Land Rover Discovery

2 Answers

When engine gets real warm it will cut off

This has happened twice, the first time i was just driving around town and the engine was pretty warm, i stopped at a stop light then the engine just cut off, however it cranked right back up. today my wife and i drove to Virginis and back which was about 110 miles. so the engine got pretty warm but as soon as we got close to the house the engine shut down but it cranked right back up again. please help

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 42 Answers

Need more detailed info. I had to replace the IAC valve and TPS valve on mine to get it to crank and idle and stay running after stopping at a light. Could be other things like fuel pump or fuel pressure regulator etc.

Posted on Aug 12, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 375 Answers

Any warning light?don't irritate your engine u may lose him.check the 'water level on your tank oil also.check for any leaking.there have to be something

Posted on Jun 22, 2008

4 Suggested Answers

  • 315 Answers

SOURCE: Engine malfunction light came on

As with any check engine light, the only way to find out what the issue is is to have the code read. The dealership can pull the code and let you know what the issue is.
Before considering driving the vehicle to the dealer though, check the obvious: oil level, coolant level, transmission oil level.
If your uneasy, have it towed.

Posted on Mar 03, 2009

  • 4 Answers

SOURCE: Car Runs and Loses Power and Quits Running

Try cleaning the fuel pump filter. Under the seat behind the driver lift the carpet and you will find a round cover with six screws remove the cover. The fuel pump is directly below unscrew the retaining round plate and remove the pump. At the base of the pump is a small filter if it is covered in black muck that's your problem. clean and replace. job takes about 10 mins good luck. please let me know how you got on!

shauunswbc@aol.com

Posted on May 08, 2009

  • 1 Answer

SOURCE: My windscreen wipers stopped working

I have a Range Rover 2006 and suddenly under heavy rain the wipers atrat going very fast and quit working, I change the speed and work again but after a minute the wipers quit. And I can not find the problem . Somebody can help me?

Posted on Apr 13, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Long time before heater blows warm air


That seems pretty normal, the heater works by blowing excess heat from the engine coolant. So the coolant has to be warmed completely for the heat to work, you can get a heater that plugs into your cigarette lighter that will heat the vehicle instantly.

Nov 12, 2013 | 2004 Chrysler Town & Country

1 Answer

2002 Beetle Engine cuts out after it warms up for a few hours.


Hello,
my advise to you is that:
Your VW problem is the throttle body, (good news) it doesn't need replacement, it only needs to be cleaned out, and even better if a good technician (know what he is doing) can run an adaptation procedure.
this will restore the ZERO position for the TPS and relearn the target engine idle speed.
Good luck.
Note: you are in my prayer.

Mar 04, 2017 | 2002 Volkswagen Beetle Turbo S

1 Answer

1997 dodge caravan stalls after driving changed egr valve an still same problemhad autozone check for codes but none came up.runs ok but after temperature warms up starts running rough an dies.after it...


My van cuts off after driving on a long stretch of highway. Around town it does pretty good. It starts back up after ten or fifteen mins. I changed the oil, oil filter, coil pack new spark plugs, and fuel fliter. It still does it. Does any one know what this could be???? O its a 2001 dodge caravan

Oct 30, 2011 | 1997 Dodge Caravan

2 Answers

1997 town and country cut out while driving.Will not crank.There is no check engine light on.


check for a blown fuse under the hood, for the engine computer. also check other electrical components, like head lamps, radio.

Dec 31, 2009 | 1997 Chrysler Town & Country

2 Answers

Coolant leaking from engine bottom driver side. 2001 subaru forester


A lot of suburus have a horizontal engine configuration. This leak could be from a number of places. I would dry all the coolant off that you can see, then let it sit for a while and try to trace it back to it's origin. Driving it will blow the coolant all over, so ideally letting it run for a while in the driveway, or garage after cleaning it will be better than driving it around town. Once you have an origin, such as a hose, a frost plug, from between the head and the block, etc. Then we can help you get if narrowed down further.

Nov 10, 2009 | 2001 Subaru Forester

1 Answer

1997 Mk 3 Golf GTI. Engine cuts whilst driving. Electrical?


try removing battery and cleaning all the ground under the battery tray and check main ground wire from battery to engine

Aug 20, 2009 | Volkswagen Golf Cars & Trucks

1 Answer

Engine light codes p0352, p0300, and p1391


po352 is ignition coil B primary/secondary circuit malfunction---ignition coil #2----p0300 is random /multible cylinder missfire, muti cylinder missfire detected!!

May 17, 2009 | 1996 Plymouth Voyager

1 Answer

Vehicle cuts out and even backfires (blacksmoke) when driving down road does not die just does not run smooth. Changed oil twice oil is black, fluids to help clean, pluggs are good, wires are good when it...


If it seems to run better when it's first started (cold) and gets worse as it warms up. You can try disconnecting the coolant temp sensor and jumper the terminals in the connector (wire side) with a paper clip. The coolant temp sensor is either in the intake manifold or the thermostat housing and has a 2 wire connector. Jumping the connector will make the computer think that the engine is hot (warmed up) and will not richen the system. If doing this helps then replace the coolant temp sensor. Hope this is helpful.

Apr 28, 2009 | 1987 Ford Ranger

1 Answer

Trouble with my rpms


Here are some of the causes of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Apr 13, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

5.9 DIESEL ENGINE CUTS OFF WHEN DRIVING


Hi

From what I can gather, the engine cuts out and then the check engine light comes on, not the other way around, check engine light and then cut out?

If you switch on the ignition but do not start the engine, you will see that the check engine light is on. It won't go out until you start the engine.

When the engine cuts out, it is just as though you have switched on the ignition without starting the engine, the key is in the exact same position, and therefor the check engine light comes on purely and simply because the engine isn't running, not because it has sensed a problem, hence you have no fault codes, its perfectly normal.

If, however, the light comes on then the engine cuts out, then the reason for the lack of codes could be a short term electrical failure. If the power to the ECM were briefly cut then the codes would be erased immediately, but this would have to be a complete failure because there is a KAM (Keep Alive Memory) wire, which supplies permanent power to the ECM if I'm not mistaken. A good candidate for a complete failure is a bad main ground cable (loose or broken).

Wiring problems a just the worst ever to trace.

Just a thought to hopefully point you in the right direction.

Very best regards

Geordie

Jun 10, 2008 | 2007 Dodge Ram 2500 Mega Cab Laramie

Not finding what you are looking for?
1996 Land Rover Discovery Logo

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70347 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...