Question about 1992 Nissan Stanza

1 Answer

R33 GTST Skyline

I have just replaced the water pump on my car.
Once we had finished an put the front end back together we tryed to start the car but it seems that the immobiliser would not disengage.

Dont know where to look to disconnect the immobiliser.

Thanks amer702

Posted by on

  • amer702 Jun 22, 2008

    R33 GTST Skyline

    I have just replaced the water pump on my car.

    Once we had finished an put the front end back together we tryed to start the car but it seems that the immobiliser would not disengage.



    Dont know where to look to disconnect the immobiliser.



    Thanks amer702

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 117 Answers

Unlock either driver door or boot with the key this will dissengage the immobilizer

Posted on Jun 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

R33 nissan skyline turbo over heated.the radiator exploded due to bottom radiator hose clamped shut causing no water flow i started it a couple of times after that.but now it wont start it almost does...


Hi this is really bad, first thing the overheating may have warped the head on the motor so i would get that checked by a pro before you do anything including starting it as it will do even more damage, second the water leaking near water pump will be from the gasket which would have blown out/split from the pressure which also maybe why water has ended up in your airbox, third the oil on the road can really only leak from the engine so the block maybe cracked too.
The best solution would be take to a pro and get an assessment but i wouldnt be suprised if the motor needs a lot of repair work im sorry to say hope this helps

Apr 09, 2011 | Nissan GT-R Cars & Trucks

4 Answers

How to replace water pump on a 1985 90 hp mariner outboard motor


mcdevito75 Here, If I;m not mistaken the water pump is in the lower houseing, a big job, let the marina take care of it as the water pump should be Changed only if it doesn"t pump at all.

Jun 16, 2010 | 2004 Mercury Mariner

1 Answer

I have a r32 nissan skyline gtst and oil is seaping through intercooler pipes


Hi
sounds like the turbo is pulling oil through, have you noticed any difference in power or smoke from the exhaust? if so then the oil seals are shot in the turbo.

Regards

Dan

Feb 01, 2010 | Nissan GT-R Cars & Trucks

1 Answer

I want to replace my cambelt on my nissan skyline 1994 2.5 GTS R33 and need some advice to doing it


Timing belt replacement.

RECOMENDATION:

Start with the tech manual.
Use a factory original belt.
Have impact and tools ready for removal of pulleys and balancer.

If you have never done this job find a friend that has. mistakes will lead to a call for a tow truck.

Hope this Tip Helps.

R/
David

Jan 30, 2010 | 2009 Nissan GT-R

1 Answer

Noisey gearbox bearing in r33 skyline how hard to fix


U will need to replace all the gearbox bearing's, not just one, there is a bearing kit(s) u can buy for most manual transmissions, but u will need a factory service manual to have any real hope of setting this trans up right when u put it back together. On a scale of 1-10 10 being the hardest this is a 9 for an untrained technician.

Apr 02, 2009 | Nissan GT-R Cars & Trucks

1 Answer

How to get my bak seat out


the bottoms you pull out first/ Pull the back forward then pull out front to back then you will see bolts holding that down take out the bolts torx bits 32-34 thanks for using fix ya Please rate my response thank you very much

Jan 31, 2009 | Nissan GT-R Cars & Trucks

2 Answers

Nissan R34 CRASH BAR


when saying crash bar do you mean roll bar? or the front bumper support?

if roll bar, i believe it will fit with minor adjustments on the floorboard.

if the bumper support. i dont think so. the r34 has a slightly more square design on the front end and would not make for a good switch.

in theory if you can weld you can get anything to fit. good luck hope they put a skyline section up for ya...ya lucky bastard. youve got my dream car. have a nice day

Oct 18, 2008 | 1996 Nissan 300ZX

1 Answer

Nissan r33 skyline coupe


i found out by going down to repco and buying an alsortment of bulbs then found out which was right when un did the front kit light

Jun 14, 2008 | 1996 Nissan 200SX

Not finding what you are looking for?
1992 Nissan Stanza Logo

Related Topics:

331 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...