- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It's actually pretty easy.
Here you go:
remove fan shroud
open petcock and drain fluid (bottom corner of tank on engine side)
remove upper and lower hoses
remove tranny coolant lines
unbolt radiator and lift out. Reverse these steps to install the new one. Hope this helps.
make sure engine is cool then drain coolant by opening the drain plug at bottom of radiator. remove cap from radiator so coolant will continue to drain and when coolant is down enough to pull off upper radiator hose at intake then close drain, then remove two bolts at coolant housing and remove thermostate. clean gasket material from intake and housing and replace with new gasket and thermostate tighten bolts install hose fill rad with coolant water mix 50/50 and run engine with heat on floor until gets hot and you see coolant flowing in rad, install cap