Question about 1999 Oldsmobile Alero

4 Answers

1999 OLDS ALERO FLASHER

TURN SIGNALS AND FLASHERS DONT WORK. ALL THE FUSES ARE GOOD. I CAN NOT FIND THE FLASHER. HAVE LOOKED IN BOTH FUSE LOCATIONS INSIDE AND ALSO UNDER THE HOOD. SEARCHED UNDER THE DASH NOT THERE EITHER. DOES ANYONE KNOW WHERE THE FLASHER IS SO I CAN REPLACE THIS $9.00 ITEM? AUTO ZONE HAS THE FLASHER BUT THEY COULD NOT TELL ME WHERE IT IS. (NOR OREILLY, GOOD YEAR , FIRESTONE. I WAS ON TERMINAL HOLD AT GMC AND OLDS DEALERS HERE....I AM STUCK IN DES MOINES AND CAN NOT FIND ANYONE WITH ANSWER

Posted by on

  • Anonymous Mar 30, 2014

    I cannot find the flasher relay to replace it

×

4 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

This was a recall. Check with your dealer.

Posted on Mar 25, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

In Olds Alero the flasher is intergrated into the hazard light button. It is all one assembly in the dash. It is in the $40 dollar range, but that is the only way to fix the flashers is to replace assembly. You must remove the plastic housing from around the dash cluster to reach. It is located to the right of the dash cluster. If you are good with your hands you will be able to get it out without taking out the cluster. Be careful, it is held in place with plastic snaps. Part number is on the assembly and it is GM exclusive.

Posted on Jun 27, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The flasher is located right behind the four way flash buttin. it's a little green cube in my car. (( alero 3.4 )) you can unscrew the guage cluster it's just a few simple screws be carefull taking out the cluster, you might have to turn it forwards abit to unhook the plug to it. (( located over to the left side of the top of the cluster )) then you can see the little flasher box. it might be handy to remove the air vent just on top of it if you have big hands so you can get in there easier. hopw this helps. (also the was a recall on these flashers from alero's 2000 and up maybe you could get it replaced for free.)

Posted on May 26, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 14,036 Answers

Usually problem with multifunction switch causes problems with hazard switch.

Posted on Mar 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My saturn signal light work sometime than go off if it the flasher please tell me there it is in my car


IF TURN SIGNAL LIGHT DONT WORK SOME TIMES.CHECK FOR BLOWED OR LOOSE FUSE.CHECK TURN SIGNAL BULBS AND CHECK BULB SOCKETS FOR CORROSION.CHECK TURN SIGNAL FOR BAD GROUND.USE JUMPER WIRE BETWEEN GROUND SIDE OF THE TURN SIGNAL BULBS AND A GOOD CHASIS GROUND.IF ALL IS GOOD TURN SIGNAL SWITCH IS BAD OR FLASHERS GOING BAD.TURN SIGNAL FLASHER LOCATED ON CENTER CONSOLE SIDE PANEL GRASP THE FLASHER UNIT AND DETACH IT FROM THE FUSE BOX.IF YOU HAVE EARLY MODEL VECHICLE FLASHER UNIT LOCATED AT THE FRONT OF THE FUSE BLOCK.

Aug 23, 2011 | Saturn LS Cars & Trucks

2 Answers

I have a Frontier XE 2001. Niether turn signal works have good bulbs and fuses are OK. Where else should I look.


did both signal lights stop working at the same time or not,it may just be the signal flasher has gone bad,it is located under the dash by the fuse panel.if the hazard flashers work then i would say the signal flasher is bad.with the hazards on you can locate it and that is what the signal flasher looks like and it is a separate flasher,

Mar 31, 2011 | 2000 Nissan Frontier

1 Answer

The turn signals do not work when you use the signal switch. However, the emergency flashers do work. The fuse was checked and is good. Everything else on the signal stem works: the cruise control,...


if the fuse is good and all the lights work(if you checked them when the hazards were working)then you need a signal flasher,the signals have a separate flasher and it looks like the hazard flasher.if you turn on the hazards and look for it under the dash then you know what the signal flasher looks like,it is located on the fuse panel of in that area.

Mar 18, 2011 | Oldsmobile Bravada Cars & Trucks

1 Answer

My blinkers dont work. fuse is good. hazards work. what might the problem be


locate the hazard flasher unit under the dash by turning on flasher and feel flasher unit clicking. the turn flasher unit looks ths same and is close to the signal flash unit and may be interchangable. switch the 2 units and see if the turn flashers work now and replace faulty flash unit

Feb 12, 2011 | 1999 GMC Suburban

1 Answer

Replaced the turn signal lever in my 1999 caravan and the left turn signal still doesnt work. The fuse for the flasher is still good and the right tun signal works any recommendations


Try the flasher module located on the junction box/fuse panel underneath the drivers side dash. It looks like a regular relay but is double the length.

Apr 16, 2010 | 1999 Dodge Caravan

3 Answers

Turn signals dont work


that could easily be just the fuse or the flasher unit. both are on the driver side under the dash

Mar 10, 2010 | 1991 Ford Tempo 4 Door

2 Answers

Where is the flasher for the turn signals in a 1999 ford explorer


The 2 fuses are no 10 (7.5amp) and no 21(15amp) in the interior fuse panel.The flasher is located on the base of steering column under dash. See this this pic find connector c214 on bottom 3rd from right.
http://i253.photobucket.com/albums/hh43/chuck943/EXN15113.gif

Mar 14, 2009 | 1999 Ford Explorer

2 Answers

Flash signal


Check Under the Hood for the Fuse Relay Box. This should have the Flash Module in it. The Diagram is inside the Cover for the Box. If not there, Look under the Dash on the Left of the Steering Column and see if there is not a Panel under there that has a Small Circle and Square at the Top of the Panel, Turn the Flashers on and you will be able to here the Correct Box Ticking in Sequence with the Blinkers. Replace this Box. Please Rate My Response! Thanks!

Feb 03, 2009 | 1999 Oldsmobile Alero

3 Answers

Flasher or turn signal switch


When you select left or right do any of the bulbs come on? If you select left check front and back left side if one of the bulbs did not come on the flasher will not work. Change the bulb that is out. Same with the right. If the fuse for the turn signal is good (check fuse or replace do not use visual, some appear to be good but are not).
The emergency flasher is different from the turn signal flasher. Look at manual for location of turn signal flasher. If you manually lift and lower turn signal control you may hear a clicking under the dash to locate the flasher.

Jan 02, 2009 | 1995 Chevrolet Caprice Classic

Not finding what you are looking for?
1999 Oldsmobile Alero Logo

1,130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

66744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...