Question about 1997 Dodge Ram 2500 Club Cab

1 Answer

BLINKERS NOT WORKING

MY DODGE IS A CUMMINS EXTRA CAB 5-SPEED. tHE EMERGENCY LIGHTS WORK, BUT THE TURNING SIGNALS DO NOT WORK. i HAVE CHECKED THE FUSE's, AND THEY ARE ALL GOOD. aNY HELP WOULD BE GREATLY APPRECIATED.

Robert

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

The could be broken relay or the wiring socket is out please check all the connection , if not then turning switch is defective............

Posted on Jun 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace turn signal blinker switch in 2005 Chevy impala


There is only one blinker '. If it works for a left turn there is something else wrong. Check the lamps and sockets. Could be a broken wire.
Turn on the emergency flashers and walk around the car to look at all of the lights that should flash.

Nov 04, 2014 | Cars & Trucks

1 Answer

Why would the flashers work on a dodge ram but not the blinkers


If the blinker light is turning on but not blinking the most likely cause would be the turn signal relay. The hazard and turn signals have a seperate relay so this may be why one is working and the other not working. I do not have a diagram but I can tell you that both of those relays are directly in the fuse panel right under the steering column. I hope I was able to help

Jan 31, 2012 | 1996 Dodge Ram 1500 Club Cab

2 Answers

Turning signals not working all the time


Sounds like the blinker relay. Is the emergency flasher switch on the dash above the radio ? If it is the blinkers relay is the same as the emergency relay. If the blinkers stop working pound on the emergency lights switch and if they start working then replace the emergency lights relay switch cause the blinkers is on the same relay as the emergency lights. My 2001 Grand Am does the same and I just hit the emergency lights switch and they start working again.

May 27, 2010 | 2001 Pontiac Sunfire

4 Answers

I have a 2006 dodge caravan and the rear turn signals will not work. fronts work fine, headlights and fog lights work fine. I checked all fuses and bulbs and none are burnt out. the turn lights on the dash...


Hello Durant.
Your rear signal lamps are turned on by the body control module (BCM).
You could have some broken wires from the BCM to the rear signals or the BCM isn't providing power to them. The BCM must be getting a signal input because the front ones are functional.
If you want to trace the wires here are the colors you are looking for.
Left rear wire is white/dark green.
Right rear wire is white/brown.
You may need to have your BCM scanned to verify.
If you would like more information to solve this yourself ask me.

Mar 27, 2010 | 2005 Dodge Caravan

1 Answer

No brake lights of blinkers 1990 dodge dynasty


While not likely, it is possible that the light bulbs in both sides are have bad filaments. Turn on ignition key (but don't start engine). Then turn on parking lamps (first detent or "click" on headlamp switch). Walk around car and look for illumination on front parking lamps and rear tail lights. Turn on the right turn signal. Are those (right hand) lamps now changing brilliance? Try the left turn signal in the same manner. Are those (left hand) front and rear lights changing briiliance? Take note of any positions that did NOT change briliance when the turn signals were activated. If NONE changed briliance, you either have a bunch of bad bulbs (unlikely) or a bad flasher (more likely) or a bad turn signal switch (most likely) or perhaps wiring problems (possible if the car has been in a collision or has been "worked on" by some "non-expert" mechanic). Check the action of the emergency flasher control switch located on the steering column (facing up). Pushing it in (down) should result in the button going to two different heights alternately (low, high, low, high). You could just have bad flashers or corroded flasher contacts! Good luck!

Nov 15, 2008 | 1993 Dodge Dynasty

1 Answer

Blinker dont work flasher and other lights work


The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.

Oct 23, 2008 | 1995 Jeep Cherokee

3 Answers

Blinkers stopped working


Your F--150 has 2 flashers, emergency and turn signal. Both are mounted on the fuse block under the dash. The turn signal flasher is mounted on the front of the fuse panel, the emergency flasher is mounted on the rear of the fuse panel. so replace the turn signal flasher should solve the problem. Let me know how it goes.

Oct 20, 2008 | 1996 Ford F150 Regular Cab

3 Answers

Blinkers not working


Did you check the bulbs? If one bulb is burned out, the blinkers won't word on that side. You could have one bulb burned out on each side. Start the car, put left signal on. Check front and back lights. Is one light on but not blinking? If that's the case, the light that's not on at all is burned out and has broken the circuit so the good light stays on and won't blink. Check the other side. You also have a 'flasher' , actually 2. One for emergency flashers, one for the turn signals. It could be that the turn signal flasher is shot. You just have to unplug it to remove. It's probably located near the fuses. good luck countrycurt0

Aug 10, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...