Question about 1997 Chevrolet Cavalier

1 Answer

I need wiring diagrams for the engine compartment. The motor was pulled and when it got put back together, I started having problems. First, the engine fan will not operate. Second, the intermittent wipers pause in the wrong position. Check engine light is on, throws an alarm for the fan. I can get the fan to kick on by jumping the ground leg of the fan relay, but it won't the car will not kick it on.

Posted by on

  • Anonymous Jun 23, 2008

    i need to wire in a tachometer for a 99 cavalier but i dont know which wire on the coil connector to tap into

  • Anonymous Oct 31, 2008

    hard to start and weak spark

×

1 Answer

Try j-body.org they may have the diagrams or you could ask in a thread

Posted on Oct 24, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a diagram on how to put wires on a distributor for a 78 monte carlo motor wit a 305


The fireing order is 1 8 4 3 6 5 7 2 . Pull #1 plug bring engine up on' top
dead center if you put a finger in the plug hole you will hear and feel the engine coming up on compression and TDC, Pull dist cap and locate # 1 terrminal the rotor will be pointing at the location .Rotation on small block chevy's is clockwise start with #1 and plug the wires in. Hope this helps
Regards

Mar 14, 2013 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

1998 isuzu trooper need wiring diagram for charging system with a3.5 li5ter motor


1998 trooper new alternator and still not charging and alternator bench tested good,
Check main 80 amp fuse in engine compartment and also check fuses in inside fuse box, there two in that one. first is engine fuse 15amp and the 10amp gauge fuse,

Here is the wiring diagram for the charging system as you asked for , also check connections, follow battery wire off the back of alternator make sure connections are good , that wire runs to engine fuse box and that is one fuse that i said to check it is 80amp, hope this is helpful good day9_30_2012_10_15_05_pm.gif

Sep 30, 2012 | Cars & Trucks

2 Answers

How to change serpentine belt


on the engine compartment area up front, in area of radiator should have a diagram explaining the procedure of replacing the serpentine belt, if not , then look for the belt tensioner, it should be on the passenger side in front of the engine, you will need a 13- 15" metric socket with a 3/8"rachet to release the tensioner , in order to get the belt off, "look at the belt , very closely before removing it, in order to make sure you get it back on right. start from the bottom, and work your way up, then , when you get to the tensioner, pull back on it and allow the belt to come in contact with the tensioner pulley, then while releasing the tensioner pulley against the belt, and then look at the whole belt to make sure it is on right , before you start the vehicle.

Jun 16, 2011 | Pontiac Sunfire Cars & Trucks

1 Answer

I am unable to find and get to the blower motor in my 1980 turbo trans am and ive already pulled out almost everything under the glove box including the glove box. im at the ventalation shaft where the...


In 1980 the blower motor is changed from the engine compartment. It is located on the passenger side of the firewall, sitting low behind the inner fender. It will have a single wire plugged in to it and is attached with 4 small bolts. Simply unplug the wire and undo the bolts, 5/16 I think, and the motor pulls out. A whole lot easier than newer cars. Hope this helps.

Apr 19, 2011 | Pontiac Firebird Cars & Trucks

2 Answers

No start I have a 1979 Dodge MobileTraveler with a 360 in


Hello
It sounds like this needs a hall affects plate in the distributer, this will need to pull the distributer remove the gear end , slide the shaft out , remove the plate ,, install the new plate put distributer back together install back into motor, set timing hot,
Thanks

Jul 12, 2010 | 1983 Dodge 600

1 Answer

Wiring Diagram for 1999 Ford Ranger 3.0


if u can gain access to the ignition switch wiring use a testlight and probe each wire while turning the ignition at start position.one of these wires shld have power during starting position and release it again to confirm.this wire goes directly to the trasmission multi lever position swicht (mlp).this MLP is mounted just outside the transmission shifting lever ganged together.Trace the corresponding return wire using the testlight. You may need someone to help you do the job.The return wire usually go to a relay on your fuse box on the engine compartment.Then from relay to the starter.

Jan 30, 2010 | 1999 Ford Ranger SuperCab

1 Answer

I need a detailed diagram of a 307 V8 motor for a 1970 chevy nova


Your best bet is to get yourself a repair manual from chiltons or strate from G.M. Most all your major auto parts stores have web sites you can go to and get the information and diagrams you need also. A repair manual is best. You also can get them thru Year One. National Parts Depot. Original Parts Groupe, Jegs, and Summit Racing. for your particular project.

Mar 29, 2009 | Chevrolet Nova Cars & Trucks

1 Answer

1988 Mustang 5.0 wiring


for the most part when you put the engine back the wires will lay back where they need to go and that will help you most plugs are not interchangeable but some sensors are if you can take a peek at one to get a idea of how to start the wires then it will be easier. As best I can remember the larger bundle runs down the passenger side of the engine intake

Dec 30, 2008 | 1988 Ford F 150

Not finding what you are looking for?
1997 Chevrolet Cavalier Logo

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...