Question about 1999 Mitsubishi Galant

1 Answer

A/c control module- blower resistat

Where is it located

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I'm having the exact same issue with my 1999 Galant, I was told it was under the dash next to the blower motor.

Posted on Jul 23, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the fuses for the blower motor on a 2005 Pontiac Bonneville


Doesn't work on any speed ? high - low . Does your's have manual or automatic climate control ?
Don't think a fuse problem , blower motor control processor more then likely .
Blower Motor Control Processor
The blower motor control processor is an interface between the HVAC control module and the blower motor. The blower motor speed control, battery positive voltage, and ground circuits enable the control processor to operate. The HVAC control module provides a pulse width modulation (PWM) signal to the control processor in order to command the blower motor speed. The processor supplies 12 volts to the blower motor through the blower motor voltage supply circuit. The control processor uses the blower motor ground as a low side control to adjust the blower motor speed.
Look here for fuse location an wiring diagram's http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model an engine size. Under system click on HVAC , subsystem HVAC controls . click the search button then click on the 5th blue link . This show's fuse location an wiring diagram for the blower electrical circuit . If you don't know where the rear fuse box is ,it's under the rear seat . It would be easier to just check under the passanger side dash at the blower motor control processor at the orange wire .
Do you know how to test electrical circuits with a voltmeter ?

GMC Yukon HVAC Blower Motor Won Turn On

Nov 26, 2017 | Pontiac Bonneville Cars & Trucks

1 Answer

Where is the location of the blower motor resistor control module for a 2000 buick lesabre. i would really appreciate your help thanks mike


Doesn't have resistor , has blower motor control module .
Blower Control Module
Under the right side of the instrument panel, right of the blower motor
Search from over 10 Million Auto Parts

Jan 17, 2017 | 2000 Buick LeSabre

1 Answer

Im trying to locate the fuse for the rear blower in my 2008 gmc arcadia, can anyone help me


RR/HVAC fuse 30amp located in the under hood fuse box. You can check it but highly doubt it's the problem . More then like it's the blower motor control module that's bad .
Circuit/System Description
The auxiliary blower motor is a variable speed fan. The HVAC control module controls the fan speed by sending a pulse width modulated signal to the auxiliary blower motor control module. The auxiliary blower motor control module varies the duty cycle across the auxiliary blower motor in relation to the pulse width modulated signal. The auxiliary blower motor speed can be adjusted from 10 percent to 90 percent duty cycle (PWM), 90 percent is high speed fan.
Watch this video for testing purpose's only , this is a front blower motor control module . Same way your back one works . GM is GM Chevy , Buick ,GMC , Cadillac .

Oct 21, 2016 | GMC Cars & Trucks

1 Answer

Need to locate the motor blower resistor for my 1999 mercury mountaineer, it has dual air, the resistor for the back is fine but the one in the front is bad and i cannot locate it. Please help.


If you have a manual system, you have a resistor. If electronic, you have a blower motor speed controller. Please rate if this helps.

here is info:

Control System Outputs-Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:
  • The assembly is located on the evaporator housing in the engine compartment.
  • Three resistance elements are mounted on the resistor board to provide four blower motor speeds.
  • Depending on the heater blower motor switch position, series resistance is added or bypassed in the blower motor circuit to decrease or increase blower motor speed.
  • An overheating protective device (thermal limiter) will open the resistor coil circuit when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
  • The thermal limiter cannot be reset and is not serviceable.
Control System Outputs-EATC
Blower Motor Speed Control
The blower speed control is located on the evaporator housing in the engine compartment.
  • The function of the blower motor speed control is to convert low power signals from the electronic automatic temperature control module to a high current, variable ground feed for the blower motor (18527).
  • The blower motor speed is infinitely variable and is controlled by the electronic automatic temperature control module software.
  • A delay function provides a gradual increase or decrease in blower motor speed under all conditions.

Jan 10, 2011 | 1999 Mercury Mountaineer

1 Answer

1992 bonneville sse w/ac replaced blower motor +


You replaced the blower control module or the blower control panel on the dash? This has automatic temp control right?

Mar 31, 2010 | 1992 Pontiac Bonneville

1 Answer

1992 Cadillac Coupe Deville blower fan runs all the time


The BLOWER MODULE is located on the A/C EVAPORATOR housing located UNDER THE HOOD passenger side firewall. Has 2 electrical connectors. Mounted with 4 screw bolts.Hope this helps

May 20, 2009 | 1988 Cadillac Sedan DeVille

1 Answer

Location of blower motor control module


Its just above the blower motor on passenger side on housing. Goes in from the top side hidden, by cover on firewall.

May 16, 2009 | 1995 Buick Park Avenue

1 Answer

Location of the blower motr control module


replace the blower motor speed control module, that is the only cause of this problem that I know of, and u are about the 20 post for this issue that I have read, it has fixed the other ones..

Feb 26, 2009 | 1999 Chrysler 300M

3 Answers

PCM module, ECM module 1996 Chevy Suburban K model


Powertrain Control Module = under right side of dash, near blower motor.
Engine Control Module = same as above
Vehicle Control Module = same as above

All Suburban vehicles are equipped with only one of these choices. Good luck.

Oct 04, 2008 | 1996 Chevrolet Suburban

Not finding what you are looking for?
1999 Mitsubishi Galant Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...