Question about 1994 Mazda 323

1 Answer

Leak Hi I hope you can help, i have a mazda 323f 1996 and i have a leak at the back of the car, it flows into the boot where the spare wheel is, also i hand to take out the back seats to dry them,

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,036 Answers

He there!

Take a close look at the tailgate hinges / seal area.

Particularly the horizontal part at the top.

It sometimes helps to pull the seal off, and use a low modulus silicone to wipe a little over the seam, then replace the seal.

Process of elimination though - it could be a window seal.

If this assists, please rare as Fixya! Thanks,

Posted on Jun 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air suspension default line


unusual for only one corner to be out, the common problems are, air leaks, between valve block and suspension unit, ride level sensors, normally the clamp on the suspension corrodes and allows the sensor to float,it sounds like a air leak on that corner to me. you can buy a leak detection spray to help find the leak. the pump is also troublesome. located front bumper liner lh, but that would affect the whole system, I would check the plastic pipe is ok from the valve block to the suspension unit first, then get the fault codes out of the air suspension module, the valve block is in the boot spare wheel well. hope this helps.

Mar 16, 2014 | 2004 Jaguar XJ

1 Answer

My mazda 323f 1.6 twincam 2002 model has an oil leak from crankshaft pulley area,to solve the fault will probably involve removal of timing belt/belts,is there any advice/diagrams for strip-down procedure...


1997 Rover; Saloon car; cc rating 1580.
Need a diagram and markings to set the crankshaft & twin overhead camshaft timing; What is the firing order before TDC

Dec 09, 2010 | Mazda 323 Cars & Trucks

1 Answer

My mazda 323f has a problem with the aircon, it works for 1/2 hour then pumps out normal temperature air. If I stop the engine for say 15 mins then restart the engine, the aircon works for a short time. I...


When you a/c works does it cut off on reaching the temp. If so decrease the rheostat and check. The compresor is developing a high back pressure and getting caught . This reduces the pressure and flow to reduce the cooling. You will need to confiirm if the compressor is having a bad valve, a filter, fault in the gas or gas pressure, block in the condenser. Try to reduce your fan speed and reduce the thermostat and check if the a/c cuts off. If the cooling gets better ,use it till your next overhaul, the check the entire a/ system for blocks in cooling pipe/condenser and refill correct gas. Hope the fan is working well when the a/c is switched on with no blocks in the condenser fins. Use a good spray to clean the fins too. Hope you try this out and hope it helps. Good day

Jul 23, 2010 | 1994 Mazda 323

2 Answers

My back tire locks up on my 4x4 pic up on my Mazda b4000 4x4 1996


U MUST REMVOVE THE WHEEL TO CHECK THE BRAKES FOR OIL CONTAMINATION FROM A POSS LEAKING AXLE SEAL.

Nov 11, 2009 | 2007 Mazda B4000

2 Answers

Mazda 323f sport 1999. How do you adjust parking brake?


Where the handbrake lever is,it will be covered by a boot of some sort.Peel this back and beside the lever will be either a rod with a nut on it,or it will have a recess for a screwdriver.with the h/brake off,do the adjustment by tightening it.When it's right, the h/brake should have to be pulled so 7 'clicks' can be heard.Hope this helps

Aug 19, 2009 | 1994 Mazda 323

1 Answer

Electric aerial mazda 323 P reg


you shuld be able to take the inner plastics out of the boot then you should be able to get to iti have a mazda 323f m rege hatchback that was what i did! hope it works!!!!!!!!

Mar 26, 2009 | 1994 Mazda 323

2 Answers

Mazda 323f: Rain water leak into cabin on drivers side, low down.


I am fixing a similar problem on my daughter's 2002 323 Hatchback (Australian BJ model, RH drive) at the moment. Rainwater comes in from above the clutch pedal.

If you look down thru the vents in front of the windshield near the wipers, you will see a spot-welded body seam running across the bottom of that recess. This is where hers is leaking. I originally sealed it with a RTV silicone sealant which fixed the problem but after approximately 6 months it has started leaking again. I am going to remove the silicone and seal over the seam with a brushable bitumen -type sealer.

Remove windscreen wipers and the vent panel for easy access to the area.

Mar 24, 2009 | 1994 Mazda 323

3 Answers

Mazda 323 1.3 1996


the lifters are naking noise because they are worn out or the engine oil is not reaching them due to the oil pump,but due to your cars year they might be just worn out there is only one way to fix a problem like this is to get then replaced there is no quick fix,and also they will just get louder and louder like tick tick tick and it will sound quicker.

Jul 07, 2008 | 1994 Mazda 323

1 Answer

MAZDA 323F 1990 MODEL


There you go, the prices, i dont know about the charges, sorry, try also go to Amazon.com
here is a link for you:
http://www.google.com/products?hl=en&q=steering+wheel+for+mazda+323f+1990&um=1&ie=UTF-8&sa=X&oi=product_result_group&resnum=1&ct=title

Jun 22, 2008 | 1990 Mazda 323

Not finding what you are looking for?
1994 Mazda 323 Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...