Question about 2000 Honda Odyssey

Open Question

How to remove headlight assembly on a 2000 honda odyssey?

I'd like to pull light assembly out to remove condensation?  thanks, dan

Posted by on

5 Suggested Answers

  • 4 Answers

SOURCE: I need to replace a

not hard at all, many people have had O2 sensor problems if they have installed an aftermarket Cat ( Not Honda ) get new bolts and you should be done in under an hour.

Posted on Jul 16, 2008

  • 1 Answer

SOURCE: headlight assembly

you will have to remove the front bumper cover to get to 2 bolts and also the grille to get another bolt off also there are are a total of 5 bolts that hold it in. be careful taking it out as you can crack the mounting brackets for the assembly just be patiece it will come out.

Posted on Dec 09, 2008

  • 496 Answers

SOURCE: removing rear light assembly on honda odyssey 2006

Yes, there is a "spear point" plastic clip that is still engaged into a socket type holder in the front outboard portion of the tail lamp assembly. Pry gently with a tape wrapped screwdriver at the front outboard corner of the assembly and the clip will release. You will then be able to see how the clip works and will be able to align and engage it first when replacing the tail lamp assembly.

-T

Posted on Jan 24, 2009

  • 1 Answer

SOURCE: 1999 Honda Civic "DRIVER" Side Headlight Bulb Replacement..

Okay, 1999 Honda Civic, Headlight (Driver Side). If you haven't fixed this or just wanna know, this is what you have to do. The power steering pump is in the way of you getting to the bulb. You will need to remove the back tube of the power steering reservoir, the one closest to the cabin of the car. Plug this tube with a rag, quickly as fluid starts flowing immediately. Pull the res up and out of the holder it sits in. Now on to the light. Grab a hold of the black plastic clip (with wires) on the sides, and pull the electronic clip out of the light. Gently pull the rubber tabs for the weather guards, and you should now see your old bulb. There is a metal clip that holds the bulb in place, gently release this metal clip, being careful to keep it in place. Makes the job easier when you put it together. Your old bulb can now be easily pulled out. I take the bulb at this point and plug it into the clip and test the lights. This assures me that the bulb is busted and a bigger job isn't ahead of me. Once confirmed, I place the new bulb in the headlight bezel, careful to not touch glass. Clip the metal hold down clip back in place. Put the Rubber grommet back in place, clip on the electrical wire clip. Test the headlight. Put power steering tubes back in place, place the res back on the holder, and done. The book and this site: http://www.andrewdothay.net/blog/2007/11/24/1998HondaCivicHeadlightReplacement.aspx helped me a lot!

Posted on Mar 21, 2010

  • 1 Answer

SOURCE: how to replace tail light bulb - 05 Honda Odyssey

Yup after removing the 2 screws, there is a round plastic tap.
you need to pop the light housing back and outward with a flat screwdriver. wrapped electrical tape on the flat end to avoid scratching the paint.

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda odyssey 2010 fender - how to remove driver side fender


Need to remove mirror this will allow you to remove the part behind mirror. You ?lso need to remove headlight assembly allowing the screws behind to be removed

Mar 22, 2016 | 2010 Honda Odyssey

2 Answers

How do i change my headlight assembly on a 2001 honda accord


HEADLIGHT REPLACEMENT

1. Remove the front bumper
2. Disconnect the connectors (A).
3. Remove the 5 mounting bolts (B), then remove the headlight assembly (C).

Fig. 21: Removing Mounting Bolts & Headlight Assembly
6_26_2012_3_27_45_pm.jpg

Jun 24, 2012 | 2001 Honda Accord

1 Answer

How do I remove a headlight bulb in a 2006 Odyssey


Look behind the headlight assembly and you should see a plastic socket that you push in and turn to release it. Do that pull out the light bulb, replace, put the socket back in the assembly and your done.

Good Luck

Dec 16, 2009 | 2006 Honda Odyssey

1 Answer

Replace fog light bulb for 2006 Honda Odyssey


Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.

Nov 22, 2009 | 2006 Honda Odyssey

1 Answer

I need to replace LR (driver side) exterior door handle assembly on my Honda Odyssey 2000. I found a source for part but need replacement instruction. Can you help? Thanks, Ed


Have to take off inner door panel and all parts then u will gain access to inside of door remove all linkages and remove bolts from door handle and install in reverse order.

Oct 20, 2009 | 2000 Honda Odyssey

1 Answer

How do I replace my front HEADLIGHT ASSEMBLY on a 2008 Honda Odyssey,


Open the bonnet temove the bulkhead cover drop the front bumper (its not that hard). Now remove the wires from the headlight (unplug them) remove the screws that hold the light in and reinstall the other light the same way. (Remember that the NTSB requires the headlights be aimed at a designated hight)

Jun 19, 2009 | 2005 Honda Odyssey

3 Answers

How to replace tail light bulb - 05 Honda Odyssey


Yup after removing the 2 screws, there is a round plastic tap.
you need to pop the light housing back and outward with a flat screwdriver. wrapped electrical tape on the flat end to avoid scratching the paint.

Jun 02, 2009 | 2005 Honda Odyssey

1 Answer

Changing brake light for 2000 Honda Odyssey


I believe that light is accessed through the inside of the trunk.Remove the carpet from the back of the light housing & you will most likely find a bunch of plastic wing nuts that hold the taillight assembly on,remove them & push the housing out carefully,then the light bulb just twists out.

Mar 28, 2009 | 2000 Honda Odyssey

1 Answer

Remove right front fender on 2005 odyssey


NO 2 BOLTS ON TOP OF FENDER UNDER HOOD 1 BOLT BEHIND PLASTIC TRIM BY MIRROR PULL THIS PIECE BACK TOWARDS MIRROR OR IT WILL BREAK TABS OFF 1 BOLT UNDER ROCKER TRIM 1 SCREW INTO ROCKER AND 1 SCREW BEHIND PLASTIC SHROUD GOING INTO BUMPER FROM UNDER NEATH PULL BUMPER BACK SLIGHTY AND YOU WILL SEE A WHITE PLASTIC CLIP PULL BACK AND BEHIND THIS IS A BOLT REMOVE HEADLIGHT CLIP FROM FENDER AND LOSEN BOLT BY HINGE NOW FENDER SHOULD COME RIGHT OFF BOOK IS 2 HOURS TAKES 1 HOUR TO REMOVE BUT GOES ON IN ABOUT 30 NINUTES

Mar 16, 2009 | 2005 Honda Odyssey

Not finding what you are looking for?
2000 Honda Odyssey Logo

Related Topics:

325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21984 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...